Chemical analysis and distribution investigation of trace elements in indium matrix by spark source mass spectrometry

Summary High-purity indium was analysed by spark source mass spectrometry, using electrical and photoplate detection. For the calibration of the differences in elemental sensitivity, a standard sample was prepared in which 10 impurities were determined by graphite furnace atomic absorption spectrometry. In this way accuracies of less than 40% were obtained for relatively homogeneous elements at ppm and sub-ppm level. About 40 elements could be determined with detection limits of 10 to 30 ppb. Two pattern recognition methods, principal component analysis and clustering analysis, were applied to obtain information on trace element distribution, which indicated that a number of elements were strongly spatially correlated in the analysed sample.

---

Chemische Analyse und Verteilungsbestimmung von Spurenelementen in Indium-Matrix durch Funkenquellen-Massenspektrometrie

---

On leave from: Department of Chemistry, Nanjing Normal University, Nanjing, People's Republic of China     

Viscoelastic properties of nanostructured natural rubber/polystyrene interpenetrating polymer networks

The effects of the blend ratio and initiating system on the viscoelastic properties of nanostructured natural rubber/polystyrene‐based interpenetrating polymer networks (IPNs) were investigated in the temperature range of ?80 to 150 °C. The studies were carried out at different frequencies (100, 50, 10, 1, and 0.1 Hz), and their effects on the damping and storage and loss moduli were analyzed. In all cases, tan δ and the storage and loss moduli showed two distinct transitions corresponding to natural rubber and polystyrene phases, which indicated that the system was not miscible on the molecular level. However, a slight inward shift was observed in the IPNs, with respect to the glass‐transition temperatures (T_g's) of the virgin polymers, showing a certain degree of miscibility or intermixing between the two phases. When the frequency increased from 0.1 to 100 Hz, the T_g values showed a positive shift in all cases. In a comparison of the three initiating systems (dicumyl peroxide, benzoyl peroxide, and azobisisobutyronitrile), the dicumyl peroxide system showed the highest modulus. The morphology of the IPNs was analyzed with transmission electron microscopy. The micrographs indicated that the system was nanostructured. An attempt was made to relate the viscoelastic behavior to the morphology of the IPNs. Various models, such as the series, parallel, Halpin–Tsai, Kerner, Coran, Takayanagi, and Davies models, were used to model the viscoelastic data. The area under the linear loss modulus curve was larger than that obtained by group contribution analysis; this showed that the damping was influenced by the phase morphology, dual‐phase continuity, and crosslinking of the phases. Finally, the homogeneity of the system was further evaluated with Cole–Cole analysis. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1680–1696, 2003     

Generation of slanted gas-filled icicles

A procedure for the generation of slanted gas-filled icicles by freezing, using a domestic refrigerator, is described. The freezing vessel was a plastic ice-cube tray, which was filled both with tap and deionized water and was frozen successively from the outer to the inner compartments of the tray. Icicles having slanted elevations grew out of the surface of the deionized water of the innermost compartments. The erection angle of the icicles to the horizontal lay between 30° and 60°, for the three longest and thinnest specimens it was almost exactly 30°. All icicles have gas inclusions. Their shape varies between an irregular distribution of circular bubbles and a nearly uninterrupted axial gas channel together with dendrite-like, radially distorted bubbles. If a cold (-18°C) specimen comes into contact with warm and humid room-air, then hoarfrost is observed at the bottom and the top of the icicle, while the area in between remains transparent.     

Relevance of Reflection in Static and Dynamic Light Scattering Experiments

Using a monodisperse PMMA dispersion, it was shown that light reflection at the sample cuvette walls may greatly influence the results of both static (SLS) and dynamic (DLS) light scattering experiments. Considering SLS, this reflection phenomenon mostly causes an overestimation of the scattered intensity at high scattering angles, which may give rise to the emergence of an additional, artificial peak in the lower region of the particle size distribution. On the other hand, the influcence of reflection on DLS measurements was shown to be particularly important in the upper region of the particle size distribution. The experimentally observed phenomena were explained from the basic principles of both particle sizing methods. Finally, it was shown that the disturbing effect of reflection could be avoided by modifying either the hardware or the software of the static and dynamic light scattering technique.     

Combined-modality treatment of adductor spasmodic dysphonia with botulinum toxin and voice therapy

A combined-modality treatment program consisting of botulinum toxin injection (Botox) and voice therapy was used to treat 17 subjects diagnosed with adductor spasmodic dysphonia (ADD SD). Ten subjects with ADD SD served as the control and were given Botox only. Voice therapy after Botox injection was directed toward reducing the hyperfunctional vocal behaviors, primarily glottal overpressure at voice onset and anterior-posterior squeezing. The results indicated that subjects who underwent combined-modality treatment maintained significantly higher mean airflow rates for significantly longer periods. Moreover, there was a carryover effect in these patients when they received Botox only. Adductor spasmodic dysphonia is treated most effectively when intrinsic laryngeal muscle spasms are reduced or eliminated by Botox injection and extrinsic hyperfunctional vocal behaviors are treated with voice therapy     

New Combinatorial Descriptions of the Triangulations of Cyclic Polytopes and the Second Higher Stasheff–Tamari Posets

This paper is concerned with the d-dimensional cyclic polytope with n vertices, C(n,d), and the set of its triangulations, S(n,d). We show that there is a bijection between S(n,d) and certain partitions of the set of increasing d-tuples on the integers 1 to n–1. We give a combinatorial characterization of the second higher Stasheff–Tamari poset, which is a partial ordering of S(n,d), and we determine its 2-dimension. There is a well-known representation of triangulations of an n-gon by right bracket vectors. We generalize this to cyclic polytopes of higher dimensions.     

On disjoint configurations in infinite graphs

For a graph A and a positive integer n, let nA denote the union of n disjoint copies of A; similarly, the union of ?₀ disjoint copies of A is referred to as ?₀A. It is shown that there exist (connected) graphs A and G such that nA is a minor of G for all n??, but ?₀A is not a minor of G. This supplements previous examples showing that analogous statements are true if, instead of minors, isomorphic embeddings or topological minors are considered. The construction of A and G is based on the fact that there exist (infinite) graphs G₁, G₂,… such that G_i is not a minor of G_j for all i ≠ j. In contrast to previous examples concerning isomorphic embeddings and topological minors, the graphs A and G presented here are not locally finite. The following conjecture is suggested: for each locally finite connected graph A and each graph G, if nA is a minor of G for all n ? ?, then ?₀A is a minor of G, too. If true, this would be a far‐reaching generalization of a classical result of R. Halin on families of disjoint one‐way infinite paths in graphs. © 2002 Wiley Periodicals, Inc. J Graph Theory 39: 222–229, 2002; DOI 10.1002/jgt.10016     

Influence of trans-cis photoisomerizations of solubilized compounds on transition temperatures in the system cetyltrimethylammonium bromide-water: Light-induced phase transitions

Transition temperatures (TN1) from the nematic lyotropic liquid-crystalline phase to the isotropic phase were measured for the system cetyltrimethylammonium bromide (CTAB) water in the presence of small amounts of 3-stilbene carboxylic acid (3SC), 4-stilbene carboxylic acid (4SC) and Δ2/2'-bi-(2H-l,4-benzothiazine) (BT). TNI, increases as a function of trans-3SC or trans-4SC concentration, ranging from 01 to 08 wt %, by up to 12°C. A further increase in TNI between 2 and 5°C can be achieved by photochemically converting the solubilized trans stilbene derivatives to the cis isomers. Irradiation of a trans-3SC containing sample at a temperature just above TNl leads to a light-induced phase transition to the lyotropic liquid-crystalline phase. Solubilization of trans-BT causes a slight decrease of TNI while photoisomerization to cis-BT increases T_NI by 1°C.