The authors describe a microreactor for performing a multiplexed polymerase chain reaction (PCR) which is operated with minimal accessories such as a single heater for gene amplification and a hand-held syringe for sample actuation. It was fabricated by wrapping a polytetrafluoroethylene (PTFE) tube around a rectangular poly(dimethylsiloxane) (PDMS) block having a predetermined thickness. The resulting portable microreactor was applied to PCR using a single heater because the rectangular PDMS block spatially segregated the upper and lower arrays of the PTFE tube. This warrants the adjustment of distinct temperatures inside the upper and lower tubes. A hand-held plastic syringe was connected to the inlet of the PTFE tube and used as a portable pump to achieve a homogeneous transport of a sample liquid inside the microreactor. The use of gas-impermeable PTFE prevents the formation of bubbles during thermal cycling. The microreactor was successfully applied to the amplification of typical DNA fragments of three foodborne pathogens in less than 30 min. In our perception, this method paves the way to the construction of a truly portable PCR chip that is applicable to rapid clinical diagnosis and the detection of foodborne pathogens.
This work presents the experimental study of the isomeric ratio of 137mCe–137gCe produced in 138Ce(γ, n) 137m,gCe photonuclear reaction, in neutron capture reaction 136Ce(n, γ) 137m,gCe and in the two simultaneous reactions 138Ce(γ, n) 137m,gCe and 136Ce(n, γ) 137m,gCe in the mixed photon—neutron field by the activation method. The investigated samples were irradiated at the bremsstrahlung photon flux, in the epithermal and thermal-epithermal neutron beam and in the mixed photon-neutron field constructed at the electron accelerator Microtron MT-25 of the Flerov Laboratory of Nuclear Reaction, Joint Institute for Nuclear Research, Dubna, Russia. The results were analyzed, discussed and compared with those of other authors to examine the role of the channel effect in nuclear reaction and provide the nuclear data for theoretical model interpretation of nuclear reactions.
<正>Two new eudesmane derivatives were isolated from the leaves and flowers of Verbesina virginica,along with the known 6-O-β-E -p-coumaroyl-4α-hydroxyeudesmane(1).Their structures were determined as 6-O-β-Z-p-coumaroyl-4α-hydroxyeudesmane(2) and 6-O-α-E-p-coumaroyl-1β-4α-dihydroxyeudesmane(3) by spectroscopic methods. 相似文献
由于锂铅合金因具有高增殖比、低活泼性和可能作为冷却剂的特点,被认为是最有潜力的能源堆包层氚增殖材料。在理论模型描述熔融锂铅合金氚释放行为的基础上,开展了中子辐照后Li17Pb83合金的离线氚释放实验。结果表明: 释放氚的化学形式99％以上为难溶于水的成分（HT或T2）; 氚滞留时间随载气中氢分压的增加而减小,氢分压达到1000 Pa后变为常数,且与实体积无关;氚释放速率对温度的依赖性符合Arrhenius定律。以此为基础得到的氚在熔融锂铅中的动力学参数结果,虽与文献值有差异,但同样证明了在633—973 K的范围内, 氚从液态锂铅到气相的整个释放过程中起决定作用的是氚在合金内的扩散和气\|液界面的多相反应重组。Lithium\|lead alloy is considered to be one of the most prominent tritium breeding materials for the fusion reactor blanket because of its high breeding ratio, and low reactivity and possible use as coolant. An out\|of\|pile experiment of tritium release from Li17Pb83 alloy was performed after neutron irradiation on the base of mathematical model to describe tritium release behavior from an eutectic lithium\|lead alloy. The results suggest that the dominant chemical form of the released tritium (>99%) was the water\| insoluble component (HT or T2). Tritium residence time decreased with increasing H2pressure in carrier gas up to 1000 Pa, and above this concentration limit it became constant and not influenced by the plenum volume. The temperature dependence of the tritium release rate can be described by an Arrhenius law. Consequently, the present results on the kinetic parameters of tritium in molten Li17Pb83alloy are considered to be different from the values in literature, but it is the same that the overall release process is governed by the diffusion of tritium atoms in the Li17Pb83and by the heterogeneous reaction at the gas\|eutectic interface of the tritium atom recombination at temperatures from 633 to 973 K. 相似文献
