The Rate Constant for Dissociative Electron Attachment to Ozone Revisited

The rate constant for dissociative electron attachment to ozone has been derived over the energy range from about 0 to 10 eV using recently measured and also corrected cross section data. The new rate constant data sets for two partial dissociative channels, as well as for the total dissociative electron attachment, are compared with previously reported values, and existing discrepancies are discussed.     

An anisotropic fibre-network model for mechano-sorptive creep in paper

In this paper a simplified network model for mechano-sorptive creep is presented, which is a further development of an earlier paper [Strömbro, J., Gudmundson, P., 2008. Mechano-sorptive creep under compressive loading – a micromechanical model. International Journal of Solids and Structures 45 (9), 2420–2450.]. It is assumed that the anisotropic hygroexpansion of the fibres leads to large stresses at the fibre bonds when the moisture content changes. The resulting stress state will accelerate creep if the fibre material obeys a constitutive law that is non-linear. Fibre kinks are included in order to capture experimental observations of larger mechano-sorptive effects in compression than in tension. Moisture dependent material parameters and anisotropy in the fibre distribution have been introduced. Theoretical predictions based on the model are compared to experimental results for an anisotropic paper both under tensile and compressive loading at varying moisture content and it is found that the important features in the experiments are captured by the model. Different kinds of drying conditions have also been examined.     

Quantification of Secondary Fe-Phases Formed During Sorption Experiments on Chlorites

Hyperfine Interactions - During batch sorption experiments of heavy metals on chlorite not only sorption reactions take place, but also reactions of chemical weathering leading to mineral...     

Introduction to Hardy Spaces

Basic material from the theory of Hardy spaces is presented. The principle of positive energy representations is used as motivation to introduce these spaces.     

Error Bounds and Implicit Multifunction Theorem in Smooth Banach Spaces and Applications to Optimization

In this paper we provide an error bound estimate and an implicit multifunction theorem in terms of smooth subdifferentials and abstract subdifferentials. Then, we derive a subdifferential calculus and Fritz–John type necessary optimality conditions for constrained minimization problems.     

Fluctuation measurements in a supersonic boundary layer implying in-situ calibration of the hot-wire anemometer

A calibration technique for the constant-temperature hot-wire anemometer is presented, which is based on traversing the probe through the boundary layer of a flat plate while simultaneously performing fluctuation measurements. The free stream Mach number was M = 2.54, and the Reynolds number Re_d, based on wire diameter, ranged from 9 to 23. A comparison of the sensitivity values obtained with the aid of such a calibration procedure — under the condition of neglecting low temperature loadings (t<0.6) — agrees well with sensitivities determined with free-stream data-The use of a modified transfer function for correcting the power spectra of flow perturbations revealed a conformity of wide parts of the corrected spectra with the Kolmogorov decay. The fluctuation levels of total temperature and mass flux were computed for the boundary layer of a flat plate. This work was presented at the International Conference on the Methods of Aerophysical Research ICMAR 2007, which was held in Novosibirsk on 5–10 February 2007.