三甲基硅烷基丙炔与五甲基二硅烷基丙炔共聚物膜及其气体透过性

研究了三甲基硅烷基丙块与五甲基二硅烷基丙块共聚物〔poly(TMSP-co-PMDSP)〕的成膜特点。poly(TMSP-co-PMDSP)膜的气体透过系数分别为:P_(O2):4×10~3～12×10~3,P_(N2):3×10~3～8×10~3和P_(CO2):2×10~4～4×10~4barrer,气体透过稳定性低,透过行为偏离第二Fick定律,过系数下降,其中溶解系数降低的比例远大于扩散系数的增加比例,在含有凝聚性气体的环境里,膜的气体透过出现表面吸附控制的特征。     

Two-dimensional hydrophilic interaction chromatography coupling anion-exchange and hydrophilic interaction columns for separation of 2-pyridylamino derivatives of neutral and sialylated N-glycans

A novel chromatographic approach coupling anion-exchange (diethylaminoethylene) and hydrophilic-interaction (amide or zwitterionic type) columns was developed for the separating of 2-pyridylamino derivatives of N-glycans (PA-N-glycans). This is a kind of on-line, two-dimensional (2D) separation approach in hydrophilic-interaction chromatography (called the 2D-HILIC method), analogous to that of coupling cation- (or anion-, or mixed ion-) exchange and reversed-phase columns in hydrophobic interaction (reversed-phase) chromatography. The efficiency of the 2D-HILIC method was tested with biantennary neutral and sialylated PA-N-glycan standards by properly combining linear gradient elutions of water-acetonitrile and spiked-salt (ammonium acetate) elutions. The retention time RSDs of all the peaks in three sequential runs of a 100 min cycle are less than 0.52%, which indicates a reasonably good repeatability of the 2D-HILIC method. Then, the method was applied to a complex mixture of PA-N-glycans from human serum proteins. It was demonstrated that the neutral PA-N-glycans and mono-, di-, tri-, and tetrasialylated PA-N-glycans are able to be eluted in turn according to the number of sialic acids in an automated (programmed) single run.     

Fe K‐Edge X‐ray Absorption Fine Structure Determination of γ‐Al2O3‐Supported Iron‐Oxide Species

The structure of FeO_x species supported on γ‐Al₂O₃ was investigated by using Fe K‐edge X‐ray absorption fine structure (XAFS) and X‐ray diffraction (XRD) measurements. The samples were prepared through the impregnation of iron nitrate on Al₂O₃ and co‐gelation of aluminum and iron sulfates. The dependence of the XRD patterns on Fe loading revealed the formation of α‐Fe₂O₃ particles at an Fe loading of above 10 wt %, whereas the formation of iron‐oxide crystals was not observed at Fe loadings of less than 9.0 wt %. The Fe K‐edge XAFS was characterized by a clear pre‐edge peak, which indicated that the Fe?O coordination structure deviates from central symmetry and that the degree of Fe?O?Fe bond formation is significantly lower than that in bulk samples at low Fe loading (<9.0 wt %). Fe K‐edge extended XAFS oscillations of the samples with low Fe loadings were explained by assuming an isolated iron‐oxide monomer on the γ‐Al₂O₃ surface.     

Synthesis and light‐emitting properties of carbazole‐based copolymers bearing cyano‐substituted arylenevinylene chromophore

Two arylenevinylene compounds bearing the cyano group at α‐position ( 6 ) and β‐position ( 9 ) from the dialkoxylphenylene unit were synthesized, in which the molecular termini were functionalized with 3‐bromocarbazole. The Suzuki coupling copolymerization of these compounds with 1,4‐bis[(3′‐bromocarbazole‐9′‐yl)methylene]‐2,5‐didecyloxybenzene and 9,9‐dihexylfluorene‐2,7‐bis(boronic acid) was carried out to obtain copolymers ( cp67 and cp97 ) containing the cyano‐substituted arylenevinylene fluorophore of 7 mol %. Model compounds ( 6 ′ and 9 ′) corresponding to the arylenevinylene fluorophore were also prepared. The UV spectra of copolymers resembled that of homopolymer hp with no arylenevinylene segment in both CHCl₃ solution and thin film. The emission maxima of copolymers in CHCl₃ (394 nm) agreed with that of homopolymer indicating that the emission bands originated from the carbazole‐fluorene‐carbazole segment. The emission maximum wavelength of copolymer cp67 in thin film (477 nm) indicated fluorescence from the cyano‐substituted arylenevinylene fluorophore because of the occurrence of fluorescence resonance electron transfer. In contrast, copolymer cp97 showed fluorescence at 528 nm to suggest the formation of a new emissive species such as a charge‐transfer complex (exciplex). © 2009 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 48: 91–98, 2010     

Quantitative visualization of temperature field in non-luminous flame by flame reaction technique

Abstract  

An experimental technique for measuring a temperature field in an axisymmetric non-luminous flame is developed using the flame reaction technique combined with the inverse Abel transformation. Flame visualization is carried out using alkali metal solution of Potassium (K), which is supplied to a premixed methane/air flame in a form of spray mist. The basic principle of this technique is based on the measurement of local emission intensity distribution visualized by the flame reaction, which is a function of temperature according to the Maxwell–Boltzmann statistics of thermodynamics. The relationship between the local intensity and the temperature is obtained from the calibration study, in which the local intensity is evaluated from the line of sight intensity by the inverse Abel transformation, and the temperature is measured by thermocouple. This technique is successfully applied to the measurement of local temperature distribution in steady and flickering premixed methane/air flame. The temperature field in the flickering flame indicates that the local temperature oscillates periodically with the flickering frequency, and the highest temperature is found along the flame front and in the merging region.     

Numerical analysis of dipole sound source around high speed trains

As the maximum speed of high speed trains increases, the effect of aeroacoustic noise on the sound level on the ground becomes increasingly important. In this paper, the distribution of dipole sound sources at the bogie section of high speed trains is predicted numerically. The three-dimensional unsteady flow around a train is solved by the large eddy simulation technique. The time history of vortices shows that unstable shear layer separation at the leading edge of the bogie section sheds vortices periodically. These vortices travel downstream while growing to finally impinge upon the trailing edge of the section. The wavelength of sound produced by these vortices is large compared to the representative length of the bogie section, so that the source region can be regarded as acoustically compact. Thus a compact Green's function adapted to the shape can be used to determine the sound. By coupling the instantaneous flow properties with the compact Green's function, the distribution of dipole sources is obtained. The results reveal a strong dipole source at the trailing edge of the bogie section where the shape changes greatly and the variation of flow with time is also great. On the other hand, the bottom of the bogie section where the shape does not change, or the leading edge and boundary layer where the variation of flow with time is small, cannot generate a strong dipole source.     

New microporous coordination polymer affording guest-coordination sites at channel walls

Utilization of a metalloligand, ([Cu(2,4-pydca)2(H2O)].2Et3NH) (1) (2,4-pydca = pyridine-2,4-dicarboxylate), as a building unit provides a novel porous coordination polymer, ([ZnCu(2,4-pydca)2(H2O)3(DMF)].DMF)n (2), in which the Zn(II) ion at the node of the network acts as a linker and the Cu(II) ion in the channel wall is available for guest-coordination.     

Synthesis and molecular geometry of an achiral 30-crown-12 polyacetal from alpha-cyclodextrin

Periodate oxidation of alpha-cyclodextrin followed by borohydride reduction readily provided an octadeca-hydroxymethyl-substituted 30-crown-12 polyacetal 1, its 30-membered macrocycle being composed of six meso-butanetetrol/glycolaldehyde acetal units, which is, consequently, optically inactive. Its solid-state molecular geometry emerged from the X-ray structural analysis of the well-crystallizing octadeca-acetate 2, which revealed the undulated macrocycle to be molded into three loops with a unique order of succession of the -CHR-CHR-O-CHR-O- units: alternating gauche- and anti-conformations of the meso-butanetetrol portions and consecutive disposition of the glycolaldehyde-acetoxymethyl groups above and below the mean-plane of the macrocycle. In solution, however, as evidenced by 1H- and 13C-NMR spectra, the macrocycle is highly flexible at ambient and higher temperatures, its mobility becoming distinctly restricted only below -20 degrees C.