Influence of wall heat loss on the emission characteristics of premixed ammonia-air swirling flames interacting with the combustor wall

The influence of wall heat loss on the emission characteristics of ammonia-air swirling flames has been investigated employing Planar Laser-Induced Fluorescence imaging of OH radicals and Fourier Transform Infrared spectrometry of the exhaust gases in combustors with insulated and uninsulated walls over a range of equivalence ratios, ?, and pressures up to 0.5 MPa. Strong influence of wall heat loss on the flames led to quenching of the flame front near the combustor wall at 0.1 MPa, resulting in large unburned NH₃ emissions, and inhibited the stabilization of flames in the outer recirculating zone (ORZ). A decrease in heat loss effects with an increase in pressure promoted extension of the fuel-rich stabilization limit owing to increased recirculation of H₂ from NH₃ decomposition in the ORZ. The influence of wall heat loss resulted in emission trends that contradict already reported trends in literature. NO emissions were found to be substantially low while unburned NH₃ and N₂O emissions were high at fuel-lean conditions during single-stage combustion, with values such as 55 ppmv of NO, 580 ppmv of N₂O and 4457 ppmv of NH₃ at ? = 0.8. In addition, the response of the flame to wall heat loss as pressure increased was more important than the effects of pressure on fuel-NO emission, thereby leading to an increase in NO emission with pressure. It was found that a reduction in wall heat loss or a sufficiently long fluid residence time in the primary combustion zone is necessary for efficient control of NH₃ and N₂O emissions in two-stage rich-lean ammonia combustors, the latter being more effective for N₂O in addition to NO control. This study demonstrates that the influence of wall heat loss should not be ignored in emissions measurements in NH₃-air combustion, and also advances the understanding of previous studies on ammonia micro gas turbines.     

Studies on the effects of imidazole on the peroxyoxalate chemiluminescence detection system for high performance liquid chromatography

The catalytic effect of bases (imidazole, pyridine, Tris and triethylamine) on the peroxyoxalate chemiluminescence (PO-CL) reaction for high performance liquid chromatography (HPLC) was investigated. Imidazole increased PO-CL intensity extraordinarily, whereas the other bases (pyridine, Tris and triethylamine) did not. The peak heights of dipyridamole (coronary vasodilator) obtained using the eluents containing buffers were largest at pH 7.0, a few times less at pH 6.0 and pH 5.0, 100 times less at pH 4.0 and a few hundred times less at pH 3.0. The eluents containing buffers at pH 3, 4, 5, 6 or 7 each with imidazole increased the peak heights by a few to ten times as compared with those without imidazole, and those peak heights were within one order of magnitude. On the other hand, the eluent containing buffer at pH 2 did not affect the peak heights with or without imidazole. Bis(4-nitro-2-(3,6,9-trioxadecyloxycarbonyl)phenyl) oxalate (TDPO) alone and bis(2,4-dinitrophenyl)oxalate (DNPO) plus TDPO were recommended to be used against eluents containing buffers of pH 5-7 and pH 3-4, respectively. Dipyridamole and benzydamine hydrochloride (anti-inflammatory drug) were separated on the ODS column and detected by the present system. The detection limits of dipyridamole and benzydamine hydrochloride were 40 amol and 270 fmol, respectively.     

Sensitive detection of oxo-steroids and oxo-bile acids by liquid chromatography with peroxyoxalate chemiluminescence detection

Oxo-steroids and oxo-bile acid ethyl esters were derivatized with 5-N,N-dimethylamino-naphthalene-1-sulphonohydrazide (DNS-hydrazine) to DNS-hydrazone in the presence of hydrochloric acid in ethanol or trifluoroacetic acid in benzene, purified by high-performance gel-permeation chromatography, separated on an ODS column with an eluent containing tetrahydrofuran and detected via a peroxyoxalate chemiluminescence reaction using bis[4-nitro-2-(3,6,9-trioxadecyloxycarbonyl)phenyl] oxalate (TDPO). Sensitive detection (femtomole level) of each oxo-steroid which appeared as a single peak was achieved. The procedure for the isolation of oxo-bile acids developed for GC-MS allowed the detection by this system of an unusual oxo-bile acid, 7α-hydroxy-3-oxo-5β-cholanic acid, at the nanomole l^?1 level in urine from a patient with cholestatic liver disease.     

Hartree–Fock and density functional theory calculations for the reaction mechanism of nitric oxide reductase cytochrome P450nor from Fusarium oxysporum

A reaction mechanism of a nitric oxide reductase, cytochrome P450nor (P450nor) from Fusarium oxysporum, was clarified by using Density functional theory and Hartree–Fock calculations. In this reaction mechanism, molecular orbital (MO) analysis revealed that the NO ligand dissociates from the heme iron immediately after one-electron reduction by NADH, and MO energy analysis revealed that NADH acts as a one-electron reducer, not as a two-electron reducer, and that NADH has a pivotal role different from other one-electron reducers. The role of NADH is to act as a double one-electron donor (i.e. one-electron transfer occurring twice) and to combine with the NO⁻ molecule by charge recombination reaction. Our quantum chemical calculations indicated that all reactions occurring in the heme pocket are too fast to become rate-limiting. Therefore, the rate-limiting steps in the proposed reaction mechanism are the process of capturing NO and NADH into the heme pocket and the process of expelling a product generated in the heme pocket. Kinetics of these processes was discussed based on large-amplitude vibration, which helps capturing and expelling processes in a widely opened heme pocket of P450nor. The reaction mechanism proposed here well explains published experimental data.     

Selective photocatalytic oxidation of alcohols to aldehydes in water by TiO2 partially coated with WO3

Semiconductor TiO₂ particles loaded with WO₃ (WO₃/TiO₂), synthesized by impregnation of tungstic acid followed by calcination, were used for photocatalytic oxidation of alcohols in water with molecular oxygen under irradiation at λ>350 nm. The WO₃/TiO₂ catalysts promote selective oxidation of alcohols to aldehydes and show higher catalytic activity than pure TiO₂. In particular, a catalyst loading 7.6 wt % WO₃ led to higher aldehyde selectivity than previously reported photocatalytic systems. The high aldehyde selectivity arises because subsequent photocatalytic decomposition of the formed aldehyde is suppressed on the catalyst. The TiO₂ surface of the catalyst, which is active for oxidation, is partially coated by the WO₃ layer, which leads to a decrease in the amount of formed aldehyde adsorbed on the TiO₂ surface. This suppresses subsequent decomposition of the aldehyde on the TiO₂ surface and results in high aldehyde selectivity. The WO₃/TiO₂ catalyst can selectively oxidize various aromatic alcohols and is reusable without loss of catalytic activity or selectivity.     

Transpeptidase-mediated incorporation of D-amino acids into bacterial peptidoglycan

The β-lactams are the most important class of antibiotics in clinical use. Their lethal targets are the transpeptidase domains of penicillin binding proteins (PBPs), which catalyze the cross-linking of bacterial peptidoglycan (PG) during cell wall synthesis. The transpeptidation reaction occurs in two steps, the first being formation of a covalent enzyme intermediate and the second involving attack of an amine on this intermediate. Here we use defined PG substrates to dissect the individual steps catalyzed by a purified E. coli transpeptidase. We demonstrate that this transpeptidase accepts a set of structurally diverse D-amino acid substrates and incorporates them into PG fragments. These results provide new information on donor and acceptor requirements as well as a mechanistic basis for previous observations that noncanonical D-amino acids can be introduced into the bacterial cell wall.     

Synthesis and pharmacological evaluation of 1-isopropyl-1,2,3,4-tetrahydroisoquinoline derivatives as novel antihypertensive agents

A series of 1-isopropyl-1,2,3,4-tetrahydroisoquinoline derivatives were synthesized and their bradycardic activities were evaluated in isolated guinea pig right atria. Structure-activity relationship studies revealed that the introduction of an appropriate substituent and its position on the 1,2,3,4-tetrahydroisoquinoline ring are essential for potent in vitro activity. Furthermore, the tether between the piperidyl moiety and the terminal aromatic ring is important for potent antihypertensive activity. Oral administration of 6-fluoro-1-isopropyl-2-{[1-(2-phenylethyl)piperidin-4-yl]carbonyl}-1,2,3,4-tetrahydroisoquinoline (3b) to spontaneously hypertensive rats (SHR) elicited antihypertensive effects without inducing reflex tachycardia, which is often caused by traditional L-type Ca2? channel blockers.     

Synthesis and pharmacological evaluation of 1-alkyl-N-[(1R)-1-(4-fluorophenyl)-2-methylpropyl]piperidine-4-carboxamide derivatives as novel antihypertensive agents

We synthesized and evaluated inhibitory activity against T-type Ca(2+) channels for a series of 1-alkyl-N-[(1R)-1-(4-fluorophenyl)-2-methylpropyl]piperidine-4-carboxamide derivatives. Structure-activity relationship studies have revealed that the isopropyl substituent at the benzylic position plays an important role in exerting potent inhibitory activity, and the absolute configuration of the benzylic position was found to be opposite that of mibefradil, which was first launched as a new class of T-type Ca(2+) channel blocker. Oral administration of N-[(1R)-1-(4-fluorophenyl)-2-methylpropyl]-1-[2-(3-methoxyphenyl)ethyl]piperidine-4-carboxamide (17f) lowered blood pressure in spontaneously hypertensive rats without inducing reflex tachycardia, an adverse effect often caused by traditional L-type Ca(2+) channel blockers.     

A risk assessment of human ether-a-go-go-related gene potassium channel inhibition by using lipophilicity and basicity for drug discovery

The blockade of human ether-a-go-go-related gene (hERG) potassium channels is widely regarded as the predominant cause of drug-induced QT prolongation. The correlation analysis between the inhibition of the hERG channel (hERG inhibition) and physicochemical properties was investigated by use of in-house quinolone antibiotics as model compounds. In order to establish a simple prediction model of hERG inhibition, we focused on the comprehensible physicochemical parameters such as lipophilicity (log P) and basicity (pK(a)). At first, the risk associated with increasing log P and pK(a) was examined by statistical analysis. It was demonstrated that the risk associated with increasing log P and pK(a) by one unit, respectively, almost identically increased. Consequently, equal attention should be paid to both parameters on hERG inhibition. Next, a prediction model of hERG inhibition which was represented by log P and pK(a) was investigated. As a result, we built the stepwise discriminant prediction model which took advantage of the risk judgment by zone classification. In conclusion, the impact of log P and pK(a) on hERG inhibition was clarified relatively and quantitatively. The quantitative risk assessment established based on both parameters, was considered to be a practical and useful tool in avoiding hERG inhibition and in the rational drug design for drug discovery, especially in lead optimization. Moreover, we also carried out a trend analysis using a different derivative and demonstrated that both parameters were equally significant for hERG inhibition.