Rheological behavior and prediction for blending conditions of a thermotropic liquid crystalline polyester with nylon

The dynamic rheological behavior of a liquid crystalline polymer (LCP), Vectra™ A, and nylons was investigated. The viscosities of nylon 66 and nylon 6 decrease slowly with an increase in temperature, while the viscosity of Vectra A drops dramatically at 280 °C, but remains slightly changed above 300 °C. At constant frequency and above 300 °C, the mean value of the activation energy of Vectra A is about 87.0 kJ/mole, but jumps to a much higher value of about 407.0 kJ/mole if the melt temperature is below 300 °C. The activation energy of Vectra A above 300 °C is lower than nylon 66, which shows that the viscosity of nylon 66 has a greater temperature dependence than Vectra A. The viscosity ratio of Vectra A to Nylon 66 is less than 1 at temperatures higher than 290 °C, which indicates that Vectra A can form the fibrils in the nylon 66 matrix and reinforce nylon 66 when blending them above this temperature. Experimental data confirm our prediction. Copyright © 2000 John Wiley & Sons, Ltd.     

0.2wt% Bi2O3、CuO、B2O3对5Ca0.6La0.267TiO3-5Ca(Mg1/3Nb2/3)O3微波介质陶瓷的性能影响

采用传统的固相反应法,研究了三种烧结助剂Bi2O3、CuO、B2O3对5Ca0.6La0.267TiO3-5Ca(Mg1/3Nb2/3)O3微波介质陶瓷的烧结性能和介电性能的影响。实验结果表明,掺入0.2wt%的Bi2O3、CuO、B2O3产生了液相,有效地降低了体系的烧结温度。Bi2O3和CuO的加入没有改变烧结体的微观形貌,它们介电常数和品质因数随烧结温度的变化趋势和体积密度趋于一致,均在体积密度最大时最高。当温度大于1300℃时,加入0.2wt%B2O3试样有柱状晶体生成,并随着烧结温度的升高而增多,柱状晶体的存在可能促使Q×f值较大的提高,当烧结温度过高时(1350℃),由于柱状晶体过多使得烧结体不均匀导致Q×f值下降。Bi2O3、CuO、B2O3的加入没有改变烧结体的晶相组成,因此所有烧结体均有近零的温度系数。结果表明,加入0.2wt%B2O3的5Ca0.6La0.267TiO3-5Ca(Mg1/3Nb2/3)O3在1325℃烧结温度具有最佳的介电性能:εr=54.87,Q×f=55 726 GHz,τf=-0.6 ppm/℃。     

亚相金属离子与两亲配体LB膜相互作用的研究

The complex formation of 2-hexadecylcarbamoyl-8-hydroxyquinoline(HHQ) monolayers at the air/water interface by reaction with metal ions from the subphase was investigated using X-ray photoelectron spectroscopy. The formation of HHQ-metal complexes leads to the appearance of new peaks assigned to the metal ions. The information on stoichimoetry provided by XPS indicated that a metal ion is coordinated by two HHQ molecules for La3+ and Cd2+ ions, but by one HHQ molecule for Mn2+ and Ni2+ ions.     

前胡内酯肟酯衍生物的合成及其抑制乙酰胆碱酯酶活性评价

本文以香豆素类化合物前胡内酯为先导化合物,设计合成了12个前胡内酯肟酯衍生物,所有目标化合物经熔点、~1H NMR和MS进行结构确证。体外抑制乙酰胆碱酯酶(AChE)活性评价结果表明,在1μmol/mL浓度下,目标化合物4a和4k对AChE具有较强的抑制活性,其抑制率分别达到58.05%和66.27%。初步构效关系研究表明,引入吲哚环能提高前胡内酯对AChE的抑制活性。通过分子对接方法考察了化合物4k与AChE结合的模式,发现目标化合物可以和AChE的催化活性中心部位结合。     

脉冲形状和静电场对电离率和高次谐波的影响

采用数值方法研究静电场和不同的激光脉冲对氢原子的电离率和高次谐波的影响.结果表明脉冲形状和电离率之间有着确定的关系,电离率反过来又影响了谐波谱的性质;另外,随着所加的静电场强度的增大,电离率呈上升的趋势,而谐波谱出现一个双平台的结构.     

Continuum shock profiles for discrete conservation laws I: Construction

We construct continuum shock profiles for finite difference schemes for hyperbolic conservation laws. Our analysis is based on the time‐asymptotic estimates for solutions of the difference schemes. Our result applies to dissipative schemes with the nonresonance property, such as the Lax‐Friedrichs and Godunov schemes. Discrete profiles have been constructed for shocks with rational speed using a fixed‐point and central‐manifold approach. For such an approach the strength of the shock is required to be small as compared to the denominator of its rational speed. Thus it does not apply to shocks with irrational speed. Our new approach yields continuum profiles for shocks with speed satisfying the Diophantine property. © 1999 John Wiley & Sons, Inc.     

One‐Pot Cascade Transformation of Glucal into Structurally Diverse Drug‐Like Scaffolds

A diversity‐oriented synthesis strategy to produce three types of structurally drug‐like N‐heterocyclic‐fused rings has been developed from abundant biomass‐derived d ‐glucal, aniline and water in a stereoselective manner. The overall transformation which entails a cascade of Ferrier reaction and 4π conrotatory imino‐Nazarov cyclization was performed in one‐pot allowing convenient preparation of scaffolds of high molecular complexity from relatively simple starting materials. While indoline‐fused products were readily accessible using ortho‐unsubstituted secondary anilines as substrates, reactions with ortho‐hydroxyl‐anilines furnished fused 1,4‐benzoxazines instead. In both cases, InBr₃ acted as the Lewis acid catalyst. By altering InBr₃ to Ln(OTf)₃, the indoline‐fused products could be further converted into tetrahydroquinoline‐fused cyclopentenones via ensuing retro‐ene rearrangement.     

Multipeak fitting analysis of Raman spectra on DLCH film

The hydrogenated diamond‐like carbon (DLCH) film with 1‐µm thickness is deposited by direct hydrocarbon gas ion beam method on silicon wafer and annealed at 400 °C. Detailed Raman spectra feature are fitted from nine sets of different peak fitting functions, including Gaussian, Lorentzian and Breit‐Wigner‐Fano (BWF) functions. These fitting results obtained from a two‐peak combination show some specific variances on the G peak position, FWHM_G and I_D/I_G ratio for as‐deposited and as‐annealed DLCH films. The most popular two‐peak fitting method with full Gaussian function tends to exhibit a higher ratio of the G peak position shift and higher I_D/I_G ratio than others fitting methods, the drastic difference among the most popular G (G) & G (D) and B (G) & L (D) schemes also have brought out in I_D/I_G ratio. However, for a more complex four‐peak Gaussian function fitting Raman spectra, the I_D/I_G ratio is close to that of a two‐peak fitting function with a mixture functions of BWF (G) and L (D). Furthermore, a series of systematic peak fitting procedures and comparisons of Raman spectra have been discussed in this study. Copyright © 2009 John Wiley & Sons, Ltd.     

单色仪转角重复精度的相位板衍射准直方法测量

为准确测量上海光源软X射线谱学显微光束线采用的变包含角平面光栅单色仪的转角重复精度,提出了一种新的基于相位板衍射准直技术的测量方法.该方法将半导体激光单模光纤和相位板衍射准直技术结合起来,利用面阵CCD采集图像,通过测量光斑的位移变化确定平面镜和光栅的角度变化.实验表明.该方法可以测量掠入射情况下单色仪联动时的转角重复精度,测量精度可达士0.1",此测量精度优于同等实验条件下的商用ELCOMAT 3000自准直仪的测量精度.     

Polyamide-imide/polyetherimide dual-layer hollow fiber membranes for pervaporation dehydration of C1–C4 alcohols

To circumvent the common swelling and deteriorated performance of integral asymmetric hollow fiber membranes for pervaporation dehydration, we have developed novel polyamide-imide (PAI)/polyetherimide (PEI) hollow fiber membranes with synergized performance with the aid of dual-layer spinning technology. Dehydration of C1–C4 alcohols has been conducted and the orders of their fluxes and permeances have been analyzed. The hollow fibers spun at 2 cm air gap and annealed at 75 °C exhibit the highest pervaporation performance: separation factors for t-butanol/water and iso-butanol/water binary systems are greater than 50,000 with flux more than 700 g/m² h. A comparison with literature data shows that the newly developed membranes outperform most other polymeric membranes for the dehydration of IPA and butanols. The dual-layer hollow fiber membranes also exhibit good long-term stability up to 200 h. The superior performance can be attributed to (1) the balanced properties of PAI as the selective layer for dehydration pervaporation; (2) the low water uptake and less swelling characteristic of the PEI supporting layer; and (3) the desirable membrane morphology consisting of a fully porous inner layer, a porous interface, and an ultrathin dense-selective outer skin.