Determination of trace levels of diosmin in a pharmaceutical preparation by adsorptive stripping voltammetry at a glassy carbon electrode.

A systematic study on the electrochemical behavior of diosmin in Britton-Robinson buffer (pH 2.0-10.0) at a glassy carbon electrode (GCE) was made. The oxidation process of the drug was found to be quasi-reversible with an adsorption-controlled step. The adsorption stripping response was evaluated with respect to various experimental conditions, such as the pH of the supporting electrolyte, the accumulation potential and the accumulation time. The observed anodic peak current at +0.73 V vs. Ag/AgCl reference electrode increased linearly over two orders of magnitude from 5.0x10(-8) M to 9.0x10(-6) M. A limit of detection down to 3.5x10(-8) M of diosmin at the GCE was achieved with a mean recovery of 97+/-2.1%. Based on the electrochemical data, an open-circuit accumulation step in a stirred sample solution of BR at pH 3.0 was developed. The proposed method was successfully applied to the determination of the drug in pharmaceutical formulations. The results compared favorably with the data obtained via spectrophotometric and HPLC methods.     

Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

A MODEL OF TROPICAL MARINE RESERVE‐FISHERY LINKAGES

ABSTRACT. The excessive and unsustainable exploitation of our marine resources has led to the promotion of marine reserves as a fisheries management tool. Marine reserves, areas in which fishing is restricted or prohibited, can offer opportunities for the recovery of exploited stock and fishery enhancement. In this paper we examine the contribution of fully protected tropical marine reserves to fishery enhancement by modeling marine reserve‐fishery linkages. The consequences of reserve establishment on the long‐run equilibrium fish biomass and fishery catch levels are evaluated. In contrast to earlier models this study highlights the roles of both adult (and juvenile) fish migration and larval dispersal between the reserve and fishing grounds by employing a spawner‐recruit model. Uniform larval dispersal, uniform larval retention and complete larval retention combined with zero, moderate and high fish migration scenarios are analyzed in turn. The numerical simulations are based on Mombasa Marine National Park, Kenya, a fully protected coral reef marine reserve comprising approximately 30% of former fishing grounds. Simulation results suggest that the establishment of a fully protected marine reserve will always lead to an increase in total fish biomass. If the fishery is moderately to heavily exploited, total fishery catch will be greater with the reserve in all scenarios of fish and larval movement. If the fishery faces low levels of exploitation, catches can be optimized without a reserve but with controlled fishing effort. With high fish migration from the reserve, catches are optimized with the reserve. The optimal area of the marine reserve depends on the exploitation rate in the neighboring fishing grounds. For example, if exploitation is maintained at 40%, the ‘optimal’ reserve size would be 10%. If the rate increases to 50%, then the reserve needs to be 30% of the management area in order to maximize catches. However, even in lower exploitation fisheries (below 40%), a small reserve (up to 20%) provides significantly higher gains in fish biomass than losses in catch. Marine reserves are a valuable fisheries management tool. To achieve maximum fishery benefits they should be complemented by fishing effort controls.     

Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Nonlinear Theory of Spectra of Thermally Stimulated Currents in Complex Crystals with Hydrogen Bonds

The nonlinear theory of thermally stimulated depolarization currents is developed. The theory explains the processes of hetero- and homocharge relaxation in complex crystals with hydrogen bonds and allows the relaxation oscillator parameters to be calculated using the quadratic approximation for the external electric field.     

Nonequilibrium Ionization by Vibrationally Excited Molecules in Supersonic Flows

The results of experimental investigations on thermal nonequilibrium ionization in CO₂: N₂: He mixtures are presented. Measurements of electron density, n_e, in vibrationally excited nitrogen were made in a supersonic flow with different CO₂ contents as well as in a CO₂: N₂: He = 1 : 5 : 4 mixture laser gas. The mixtures were heated in a shock tube and expanded through a supersonic nozzle. Furthermore, supersonic mixing of N₂ and CO₂ + He was used in some experiments. The measured values of n_e in the plenum chamber and in the supersonic nozzle are reported, and the processes responsible for nonequilibrium ionization in a laser-active medium are discussed.     

Localization and the integer-quantized Hall effect: Diffusion constant for high Landau levels and white noise potential

The diffusion constant and the diagonal conductivity for non-interacting electrons in a two-dimensional, disordered system are studied. A homogeneous magnetic field perpendicular to the electron system is assumed. For weak short-range random potentials and high fields the Landau quantum numbern can be used as expansion parameter. In the limit of high Landau levels the system shows metallic behaviour. Corrections for finiten decrease the conductivity and indicate localized states in the whole energy band. A breakdown of the expansion and stronger localization are observed only for the lowest Landau levels if the typical experimental length scale of the quantized Hall effect is used.     

Vascular morphology by three-dimensional magnetic resonance imaging

A three-dimensional examination of blood vessels is provided using MR data from seven cases. The vascular surfaces are constructed with an algorithm that automatically follows the selected artery or vein and generates a projected three-dimensional gradient shaded image. Fast 3DFT pulse sequences were optimized to enhance the time-of-flight contrast of the intravascular region. By increasing the surface threshold value in a three-dimensional head study, the flesh of a patient's face was peeled away to demonstrate the superfacial temporal artery. Gated cardiac images show the great vessels and cardiac chambers. A three-dimensional view of the aorta shows an irregular surface in the vicinity of an adrenal tumor. 3D MR exams provide a non-invasive technique for assessing vascular morphology in a clinical setting.