均匀分层介质中标准矢量波函数的构成

研究了在均匀分层介质中构成标准矢量波函数的必要条件。研究结果表明在均匀分层介质中构成标准矢量波函数一般需遵循Morse-Feshbach判据外，领示矢量只能选取与折射率变化方向一致的那根坐标轴单位矢量。但在某些特定的条件下，对领示矢量的选取条件可以放宽为只需遵循Morse-Feshbach判据即可。     

III-Nitride Quantum Devices—Microphotonics

Photonic devices based on III-nitrides offer benefits such as UV/blue emission, large band offsets of InN/GaN/AlN heterostructures allowing novel quantum well (QW) device design, and inherently high-emission efficiencies. Furthermore, due to their mechanical hardness and larger band gaps (when compared with conventional semiconductor devices), III-nitride-based devices may operate at much higher temperatures and voltages/power levels for any dimensional configuration and in harsher environments than other semiconductor devices and are expected to provide much lower temperature sensitivities. These are crucial advantages for many applications. Over the last decade, the physics of microsize photonic devices has been investigated. New physical phenomena and properties are expected to dominate as the device size scales down. The microsize light emitters offer benefits over edge emitters such as the ability to create arrays of individually controllable pixels on a single chip, enhanced quantum efficiency, and greatly reduced lasing threshold. Rapid progress in the area of III-nitride microphotonics has been made. The growth and fabrication of micron and submicron size photonic structures based on III-nitride wide bandgap semiconductors has been achieved, and the technology has made it possible to integrate arrays of optical elements to form active photonic-integrated devices. One example is an interconnected µ-LED with enhanced emission efficiency over the conventional LEDs for the same device area. Another example is a µ-LED array with independently addressed pixels or III-nitride microdisplay. III-nitride microdisplay may offer performance that is superior to microdisplays fabricated from liquid crystals and organic LEDs. The third example presented is III-nitride UV Focal Plane Arrays (UV-FPA) of detectors. So far, the operation of AlGaN UV-FPA with size up to 256×256 pixels with 30×30?μm² unit cells has been demonstrated. Together with the nature of their two-dimensional array, these active micro-photonic devices show promise in many important applications, such as optical communications, signal and image processing, optical interconnects, computing, enhanced energy conversion and storage, chemical, biohazard substances, and disease detection, missile and shellfire, atmospheric ozone-level, and flame sensing. III-nitride microlens arrays have been fabricated successfully for blue and UV wavelength applications on GaN and AlN. The successful fabrication of microlens arrays based on III-nitride materials opens the possibility for monolithically integrating nitride-based micro-size photonic devices, as well as coupling light into, out of, and between arrays of III-nitride emitters and detectors, especially for short wavelengths covering the green-blue to deep UV (200?nm) region. Nanofabrication and characterization of photonic crystals with diameter/periodicity as small as 100/180?nm on InGaN/GaN MQW has been achieved. An unprecedented maximum enhancement factor of 20 was obtained under optical pumping. Single-mode ridged optical waveguide devices using GaN/AlGaN heterostructures have been designed, fabricated, and characterized for operation in 1550?nm wavelength window. The feasibility of developing novel photonic integrated circuits based on III-nitride wide bandgap semiconductors for fiber-optical communications has been investigated.     

Influence of mass moment of inertia on the normal modes of a preloaded solar array mast

Earth-orbiting spacecraft often contain solar arrays or antennas supported by a preloaded mast. Due to weight and cost considerations, the supporting structures of the spacecraft appendages are made extremely light and flexible. Therefore, it is essential to investigate the influence of all physical and structural parameters on the dynamic behavior of the overall structure. The governing equation of motion and its general solution for the preloaded mast are developed. Furthermore, the mass moment of inertia of the mast subjected to bending vibrations is included in the governing equation of motion to investigate its influence on determining the circular frequencies. To verify the developed formulations, a finite element technique was implemented. The accuracy and limitation of the technique on calculating the circular frequencies are discussed. Although the study described in this paper primarily focuses on the mast for the space station solar arrays, the developed formulations and techniques can be applied to any large and flexible beam in zero gravity.     

Determination of low level85Kr and133Xe concentrations in the environment

This study was performed under the joint TRMC/INER program for the determination of low level⁸⁵Kr and¹³³Xe concentrations in the environmental air samples. Based on cryogenic adsorption of krypton and xenon on charcoal followed by chromatographic separation from other gases, the⁸⁵Kr and¹³³Xe recovered from 200 liters of atmospheric air can be determined by either on-line gas flow proportional counter or liquid scintillation counting. The recovery yields of krypton and xenon examined by using⁸⁵Kr and¹³³Xe tracers were nearly 100%. The minimum detectable activity of⁸⁵Kr and¹³³Xe by gas flow proportional counting is about 7.40 Bq. The method is satisfactory for environmental monitoring applications under abnormal conditions of nuclear facilities. However, for lower level environmental⁸⁵Kr and¹³³Xe measurements, the liquid scintillation counting method can be applied due to their extremely low detection limits (i.e. 0.107 Bq and 0.093 Bq for⁸⁵Kr and¹³³Xe, respectively). Using this method, the measurable limits of concentrations are 0.535 Bq/m³ and 0.466 Bq/m³ for⁸⁵Kr and¹³³Xe, respectively.     

多项选择题测验信度的一个估计方法及其应用

在多项选择题测验分数等于真实分数和猜测分数之和的假设模型下，本文得到了一个多项选择题测验信度的理论公式，并由此给出了测验信度的估计方法。最后，通过两个例子，说明了本文提出的方法在测验信度分析中的应用，并将这种方法与教育测量中常用的库德——理查逊方法（Ｋｕｄｅｒ－Ｒｉｃｈａｒｄｓｏｎ）进行了比较     

添加剂在氧化铈抛光中的作用机理的探索

本文在试验基础上,对添加剂在氧化铈抛光中作用机理—提高氧化铈抛光效率的机理和防止玻璃抛光表面腐蚀的机理作了探索,指出在一定的抛光工艺条件下,每一种添加剂对于一定品位的氧化铈和一定牌号的光学玻璃有一最佳的加入量。     

Synthesis of 5‐Radioiodoarabinosyl Uridine Analog for Probing the HSV‐1 Thymidine Kinase Gene

Tumor cells transduced with herpes simplex virus thymidine kinase gene have been intensively applied to the field of positron emission tomography via imaging of its substrate. As a pilot synthesis approach, a facile preparation of 5‐[¹²⁵I] iodoarabinosyl uridine starting from commercially available uridine is reported herein.     

Syntheses,crystal structures and blue emission of three zinc(II) coordination polymers with a 4,4′‐dicarboxybiphenyl sulfone ligand

Three novel zinc complexes [Zn(dbsf)(H₂O)₂] ( 1 ), [Zn(dbsf)(2,2′‐bpy)(H₂O)]·(i‐C₃H₇OH) ( 2 ) and [Zn(dbsf)(DMF)] ( 3 ) (H₂dbsf = 4,4′‐dicarboxybiphenyl sulfone, 2,2′‐bpy = 2,2′‐bipyridine, i‐C₃H₇OH = iso‐propanol, DMF = N,N‐dimethylformamide) were first obtained and characterized by single crystal X‐ray crystallography. Although the results show that all the complexes 1–3 have one‐dimensional chains formed via coordination bonds, unique three‐dimensional supramolecular structures are formed due to different coordination modes and configuration of the dbsf^2? ligand, hydrogen bonds and π–π interactions. Iso‐propanol molecules are in open channels of 2 while larger empty channels are formed in 3 . As compared with emission band of the free H₂dbsf ligand, emission peaks of the complexes 1–3 are red‐shifted, and they show blue emission, which originates from enlarging conjugation upon coordination. Copyright © 2006 John Wiley & Sons, Ltd.     

The role of binder mobility in spontaneous adhesive contact and implications for cell adhesion

The standard view of mechanical adhesive contact is as a competition between a reduction in free energy when surfaces with bonding potential come into contact and an increase in free energy due to elastic deformation that is required to make these surfaces conform. An equilibrium state is defined by an incremental balance between these effects, akin to the Griffith crack growth criterion. In the case of adhesion of biological cells, the molecules that tend to form surface-to-surface bonds are confined to the cell wall but they are mobile within the wall, adding a new phenomenon of direct relevance to adhesive contact. In this article, the process of adhesive contact of an initially curved elastic plate to a flat surface is studied for the case in which the binders that account for adhesion are able to migrate within the plate. This is done by including entropic free energy of the binder distribution in the total free energy of the system. By adopting a constitutive assumption that binders migrate at a speed proportional to the local gradient in chemical potential, the transient growth of an adhesion zone due to binder transport is analyzed. For the case of a plate of very large extent, the problem can be solved in closed form, whereas numerical methods are invoked for the case of a plate of limited extent. Results are presented on the rate of growth of an adhesion zone in terms of system parameters, on the evolution of the distribution of binders and, in the case of a plate of limited extent, on the long-term limiting size of the adhesion zone.     

Growth of single-crystal magnetite nanowires from Fe3O4 nanoparticles in a surfactant-free hydrothermal process

Single-crystal magnetite nanowires with average diameter of ca. 20 nm and length of up to several micrometers were prepared by a simple alkaline surfactant-free hydrothermal process. The crystallinity, purity, morphology, and structural features of the as-prepared magnetite nanowires were investigated by powder X-ray diffraction, transmission electron microscopy (TEM) and selected area electron diffraction. The composition and length of nanowires depends on the pH, with higher pH favoring longer nanowires composed entirely of Fe₃O₄. A mechanism for nanowire growth is proposed.