Chemische Vitamin D<Subscript>3</Subscript>-Bestimmung in Lebertran

The different aspects of Vitamin D₃ determination and the data reported in the literature are discussed. The spectrophotometric determination of Vitamin D₃ in cod-liver oil is carried out after the alkaline saponification, extraction of unsaponified parts, precipitation of accompanying sterols and the column- and thin-layer chromatographic purification and separation of vitamin D₃ on 40 cm plates from other vitamins. The dyestuff α-naphtholbenzein is suited well as standard substance for the better location and identification of vitamin D₃ zone on the thin-layer plate. The results obtained from the chemical method were checked through the simultaneous biological determination.     

Characterization of oligosaccharide moieties of intact glycoproteins by microwave-assisted partial acid hydrolysis and mass spectrometry

A method, which utilizes microwave-assisted partial acid hydrolysis and matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS), to elucidate oligosaccharide composition of intact glycoproteins is presented here. Glycoproteins, such as ribonuclease B, avidin, alpha1-acid glycoprotein, and fetuin, are used as model systems to demonstrate this technique. Partial cleavage of oligosaccharides from whole intact glycoproteins with trifluoroacetic acid was observed after a short exposure to microwaves. Due to the high-resolution mass spectra obtained by MALDI-TOFMS from glycoproteins with molecular weights less than 20 kDa, the compositions of oligosaccharides are readily derived for ribonuclease B and avidin. The data agree with the proposed oligosaccharide structures of ribonuclease B (five glycoforms) and avidin (eight glycoforms). Larger glycoproteins such as alpha1-acid glycoprotein (many glycoforms) and fetuin (many glycoforms) exhibited only broad peaks with no glycoform resolution. Nevertheless, this method can be used successfully for analysis of glycoproteins with molecular weights greater than 20 kDa to determine the presence or absence of glycosylation.     

Molecule-Responsive Fluorescent Sensors of α-Helix Peptides Bearing α-Cyclodextrin, Pyrene and Nitrobenzene Units in Their Side Chains

-Helix peptides bearing one unit of -cyclodextrin (-CD), one unit of pyrene and one unit of nitrobenzene (NB) in their side chains have been designed and synthesized as novel molecule-responsive devices.In both the CD-peptides, -PR17 and -PL17, the NB unit is separated from the CD unit by two turns of the helix. Two reference peptides (PL17, and -P17,) have also been synthesized. The circular dichroism studies in the peptide absorption region (200–250 nm)of -PR17 and -PL17 suggestthat the CD-peptides form stable-helixstructures (83–77%), which was destabilized by accommodating guest molecules (e.g., n-pentanol) into the CD cavity. It suggests that formation of intramolecular host–guest(CD–NB) complex stabilized thehelical structure and exogenous guest molecule excluded the appending NB moiety from inside to outside of the CD cavity, thereby causing destabilization of the helical structure and increasing the random coil content. The ICD spectra of the peptides in the pyrene and nitrobenzene absorption region (250–40 nm) suggest that NB forms inclusion complex with CD. The fluorescence studies revealed that the fluorescence of the pyrene unit is quenched by the NB unit in -PR17 and -PL17. The fluorescence intensity increases with increasing guest concentration for the CD-peptides.This guest-responsiveenhancement in the fluorescence intensity can be explained in terms of increased distance between the pyrene and NB moieties, which is caused by exclusion of the NB moiety from the CD cavity by guest accommodation. Using the guest-responsive fluorescence quenching properties of the CD-peptides, we have obtained binding constants for various short chain alkanols. -PL17 has higher binding affinity to the guest molecules than its isomer, -PR17, indicating that the location of functional groups on the peptide scaffold is important in molecule detection.     

Studies of tetracene- and pentacene-based organic thin-film transistors fabricated by the neutral cluster beam deposition method

The neutral cluster beam deposition (NCBD) method has been applied to produce and characterize organic thin-film transistors (OTFTs) based upon tetracene and pentacene molecules as active layers. Organic thin films were prepared by the NCBD method on hexamethyldisilazane (HMDS)-untreated and -pretreated silicon dioxide (SiO2) substrates at room temperature. The surface morphology and structures for the tetracene and pentacene thin films were examined by atomic force microscopy (AFM) and X-ray diffraction (XRD). The measurements demonstrate that the weakly bound and highly directional neutral cluster beams are efficient in producing high-quality single-crystalline thin films with uniform, smooth surfaces and that SiO2 surface treatment with HMDS enhances the crystallinity of the pentacene thin-film phase. Tetracene- and pentacene-based OTFTs with the top-contact structure showed typical source-drain current modulation behavior with different gate voltages. Device parameters such as hole carrier mobility, current on/off ratio, threshold voltage, and subthreshold slope have been derived from the current-voltage characteristics together with the effects of surface treatment with HMDS. In particular, the high field-effect room-temperature mobilities for the HMDS-untreated OTFTs are found to be comparable to the most widely reported values for the respective untreated tetracene and pentacene thin-film transistors. The device performance strongly correlates with the surface morphology, and the structural properties of the organic thin films are discussed.     

Composition-controlled synthesis of bimetallic gold-silver nanoparticles

This paper reports findings of an investigation of the synthesis of monolayer-capped binary gold-silver (AuAg) bimetallic nanoparticles that is aimed at understanding the control factors governing the formation of the bimetallic compositions. The synthesis of alkanethiolate-capped AuAg nanoparticles was carried out using two related synthetic protocols using aqueous sodium borohydride as a reducing agent. One involves a two-phase reduction of AuCl(4)(-), which is dissolved in organic solution, and Ag(+), which is dissolved in aqueous solution. The other protocol involves a two-phase reduction of AuCl(4)(-) and AgBr(2)(-), both of which are dissolved in the same organic solution. AuAg nanoparticles of 2-3 nm core sizes with different compositions in the range of 0-100% Au have been synthesized. The two synthetic routes were compared in terms of bimetallic composition and size properties. Our new findings have allowed us to establish the correlation between synthetic feeding of metals and metal compositions in the bimetallic nanoparticles, which have important implications to the exploration of gold-based bimetallic nanoparticles for constructing sensing and catalytic nanomaterials.     

Evaluation of the quality of colour changes of complexometric indicators in the titration of copper (II) with EDTA by tristimulus colorimetry

The quality of colour changes of the indicators hematoxylin, 4(2-pyridylazo)resorcinol (PAR), xylenol orange, pyrocatechol violet, chromazurolS and eriochrome cyanineR in the complexometric titration of copper(II) with ethylenediaminetetraacetic acid (EDTA) were studied with the help of tristimulus colorimetry, utilising a comparative study of the parameters SCD (specific colour discrimination), CIE La^*b^* 1976 and LABHNU 1977. Hematoxylin was found to be the best indicator among those studied. A screened indicator, viz. PAR + malachite green (52), was developed to enhance the quality of colour transition at the end-point and the accuracy of the titrimetric determination.     

Complexation of Fluvastatin Sodium with β-Cyclodextrin: NMR Spectroscopic Study in Solution

¹H NMR spectroscopic study of fluvastatin sodium (FLU), β-Cyclodextrin (β-CD) and their mixtures confirmed the formation of FLU/β-CD inclusion complex in solution. The stoichiometry of the complex was determined to be 1:1 and the overall binding constant (K _s) was calculated to be 340 M⁻¹. Two dimensional COSY, ROESY and DEPTO experiments were performed for the unambiguous assignment of aromatic proton resonances and it was found that two isomeric forms of FLU are present in solution. It was confirmed with the help of ROESY spectral data that only F-substituted aromatic ring penetrates the β-CD cavity and there is chiral differentiation by the β-CD as one of the isomer binds more strongly, which is indicated by the intensity of correlation peaks. The mode of penetration of the guest into the β-CD cavity was also established and structure of the complex has been proposed.     

Spectroscopic Study on Interaction of β-Cyclodextrin with Triprolidine Hydrochloride

The complexation of triprolidine hydrochloride （TRP） and β-cyclodextrin （β-CD） in deuterium oxide was investigated by 400 MHz 1^H NMR spectroscopy. The 800 MHz 2D ROESY data revealed that two 1 ：1 and one 2 ： 1 β-CD-TRP inclusion complexes were formed. Both aromatic moieties （p-tolyl and pyridyl ring） has entered into the β-CD cavity, confirming the existence of two different equilibria for 1 ： 1 inclusion complexes in which p-tolyl ring of the guest is more tightly held by the host cavity. The ROE intermolecular interactions provided the plausible structures of these 1 ： 1 and 2 ： 1 stoichiometric inclusion complexes of β-CD-triprolidine hydrochloride in solu- tion.