Thermodynamics of 1,10-phenanthrolinium ion and ferrous-1,10 phenanthroline complex in dioxane—water and ethanol—water at 25°c

Enthalpies of formation of 1,10-phenanthrolinium ion and ferrous-1,10-phenanthroline (tris) complex in dioxane—water and ethanol—water media at 25°C have been determined by calorimetry. Results are discussed in the light of ion—solvent and solvent—solvent interactions.     

Ultraviolet protection factors for clothing: an intercomparison of measurement systems

In recent years the need to standardize measurement protocols for quantifying the degree of ultraviolet radiation (UVR) protection provided by clothing has led to the introduction of a number of standards around the world. To date, these standards have specified spectral measurements of UVR transmission by clothing and fabrics. Development of a standard test method has become an important part of the testing process, and this article presents results from an intercomparison involving 10 independent testing laboratories and 11 different UVR transmission measurement instruments. In addition to comparing the measured ultraviolet protection factors (UPF), this intercomparison also incorporates detailed scan results from all 10 laboratories and highlights differences in performance of the various instruments in different wavelength regions. Careful examination of these differences can indicate where changes to the systems could be made to allow improvements both in equipment performance and in agreement of the final results. The variability in the measurements of UPF in this study suggest that the protection categories in standards may need to be broadened.     

Effect of trace amounts of water on organic solvent transport through gamma-alumina membranes with varying pore sizes

The transport behavior of toluene and n-hexane in gamma-alumina membranes with different pore diameters was studied. It was shown that the permeability of water-lean hexane and toluene is in agreement with Darcy's law down to membrane pore diameters of 3.5 nm. The presence of molar water fractions of 5-8 x 10(-4) in these solvents led to a permeability decrease of the gamma-alumina layer by a factor of 2-4 depending on pore size. In general, a lower permeability was found for hexane than for toluene. Moreover, in the presence of water a minimum applied pressure of 0.5-1.5 bar was required to induce net liquid flow through the membrane. These phenomena were interpreted in terms of capillary condensation of water in membrane pores with a size below a certain critical diameter. This is thought to lead to substantial blocking of these pores for transport, so that the effective tortuosity of the membrane for transport of hydrophobic solvents increases.     

Separation of antimony(III) with iodide and dithizone by sorption on polyurethane foam from sulphuric acid medium for its spectrophotometric determination in glasses

A method for quantitative separation of antimony(III) by sorption on polyether based polyurethane foam and its spectrophotometric determination has been described. The method involves formation of a pink-red complex of antimony(III) with iodide (0.045M) and dithizone (2.3 x 10(-5)M) in 0.25-0.75M H(2)SO(4) medium, sorption of the complex on polyurethane foam (within 45 min) at room temperature followed by its elution with acidified acetone (acetone containing 0.008% H(2)SO(4)) and spectrophotometric measurement at 507.2 nm ( = 2.56 x 10(4) l mol cm). The method obeys Beer's law from 0.1 to 6.0 mug antimony(III). Tolerance limits of other ions are Co (100 mug), Ni (100 mug), Fe (10 mug), Cu (0.5 mug), Sn (20 mug), Zn (100 mug), As (100 mug), Mn (200 mug), Pb (50 mug), Ti (100 mug), V (50 mug), etc. Interference by iron and copper have been eliminated by treating with KOH prior to the extraction of antimony. The method has been standardized with glass samples spiked with known amounts of antimony and applied to the determination of antimony in various glasses.     

Cyclopropane chemistry. Part 5 [1,2]. Hexafluorocyclopropane as a source of difluorocarbene

Thermolysis of hexafluorocyclopropane in the presence of ethylene, propene, vinyl chloride, and vinyl bromide gives good yields of the corresponding 1,1-difluorocyclopropanes, formed by addition of difluorocarbene to the olefin. The tetrafluoroethylene formed dimerises to octafluorocyclobutane, co-dimerises with the olefin, or survives, depending on the reaction conditions. With allene, hexafluorocyclopropane gives 1-(difluoromethylene)cyclopropane, 2,2,3,3-tetrafluorospiropentane, and products derived from tetrafluoroethylene and allene.     

An integrated process for purification of lysozyme, ovalbumin, and ovomucoid from hen egg white

This article describes an integrated process for simultaneous purification of lysozyme, ovalbumin, and ovomucoid from hen egg white. The crude egg white extract was passed through a cation exchanger Streamline trade mark SP and the bound lysozyme was eluted with 5% ammonium carbonate, pH 9.0, containing 1 M NaCl after elution of avidin. This partially purified lysozyme was further purified 639-fold on dye-linked cellulose beads. Ovalbumin and ovomucoid did not bind to Streamline SP. Ovalbumin could be precipitated from this unbound fraction by 5% trichloroacetic acid, and ovomucoid was removed from the supernatant by precipitation with ethanol. The yields of lysozyme, ovomucoid, and ovalbumin were 77, 94, and 98%, respectively. All the purified proteins showed single bands on sodium dodecyl sulfate polyacrylamide gel electrophoresis. All the steps are easily scalable, and the process described here can be used for large-scale simultaneous purification of these proteins in the pure form.     

Synthesis, characterisation and evaluation of polydithiocarbamate resin supported on macroreticular styrene-divinylbenzene copolymer for the removal of trace and heavy metal ions

A new chelating resin was synthesised by the modification of styrene-divinylbenzene (2%) copolymer and incorporation of dithiocarbamate groups. The polydithiocarbamate resin was characterised by elemental analysis, thermal studies and IR studies. The analytical characteristics of the sorbent were established and optimum sorption conditions for Cu, Ni, Pb, Fe, As and Mn determined. The total sorption capacity of the resin was 37 mg g⁻¹ for Ni(II), 35 mg g⁻¹ for Cu(II), 29 mg g⁻¹ for Fe(III) and 23 mg g⁻¹ for Pb(II). The optimum pH for the removal of metal ions was 3-5 for Ni(II), 5 for Cu(II), 4 for Fe(III) and 4-5 for Pb(II). High sorption capacity was observed when compared with other conventional chelating polymers. The sorption kinetics was fairly rapid, as apparent from the loading half time t_1/2 values, indicating a better accessibility of the chelating sites.     

Metal complexes of sulphur-nitrogen chelating agents. Part 14. Nickel(II), palladium(II), copper(II), cobalt(II), and cobalt(III) complexes of the tetradentate schiff bases having ONNS donor sites

Summary Complexes of nickel(II), palladium(II), copper(II), cobalt(II), and cobalt(III) with methyl-2-(-salicylaldiminoethyl)-cyclopent-1-en-dithiocarboxylate (H₂L¹) and methyl-2-(-salicylaldiminoisopropyl)cyclopent-1-en-dithiocarboxylate (H₂L²) have been prepared. They contain the donor sites ONNS. The metal(II) ions from neutral, monomeric square planar chelate complexes. The cobalt(III) complexes [CoL¹-(H₂O)₂]X (X=Cl or ClO₄) appear to betrans-diaqua-species. All compounds have been characterized by a number of physico-chemical methods.     

EFFECT OF CHLORIDE AND BENZOATE ANIONS ON THE DELAYED LIGHT EMISSION IN DCMU-TREATED SPINACH CHLOROPLASTS

Abstract —Chloride anions, when added to DCMU [3-(3,4-dichlorophenyl)-1,1-dimethylurea]-treated spinach chloroplasts, change the rate of decay of the delayed light emission in the seconds region but do not change the shape or the temperature dependence of the decay. Benzoate anions, on the other hand, change both the rate and the shape of the decay of the delayed light emission. These results are consistent with a model in which the membrane potential and the structure of the reaction center affect the decay kinetics of the delayed light emission in the seconds region.