Extremal Convex Planar Sets

Each convex planar set K has a perimeter C, a minimum width E, an area A, and a diameter D. The set of points (E,C, A^1/2, D) corresponding to all such sets is shown to occupy a cone in the non-negative orthant of R⁴with its vertex at the origin. Its three-dimensional cross section S in the plane D = 1 is investigated. S lies in a rectangular parallelepiped in R³. Results of Lebesgue, Kubota, Fukasawa, Sholander, and Hemmi are used to determine some of the boundary surfaces of S, and new results are given for the other boundary surfaces. From knowledge of S, all inequalities among E, C ,A, and D can be found.     

稀土配合物Eu(asprin)_3phen发光特性的研究

将稀土配合物Eu(asprin)_3phen掺杂到导电聚合物PVK中,制成结构分别为ITO/PVK:RE配合物/LiF/AI(1),ITO/PVK:RE配合物/PBD/LiF/AI(2)的电致发光(EL)器件。发现二者的电致发光谱存在着较大的差别:在器件(1)中,来自Eu~(3 )的位于594nm(~5D_0→~7F_1)和614nm(~5D_0→~7F_2)处的发光强度大致相当,而在器件(2)中,EL主要来自Eu~(3 )位于614nm的发光,594nm处的发光很弱,与薄膜状态下的光致发光谱(PL)一致。并针对此现象进行了初步讨论。     

IMPULSIVE CONTROL OF A FISHERY SYSTEM

This paper uses the method of linear approximation for impulsive systems and gets a theorem which guarantees a fishery modei to be asymptotically stable at its equilibrium point and gives the ecological explanation.     

双驱动x射线激光等离子体能谱特性研究

用时间积分空间分辨的平晶千电子伏谱仪测量了钽激光等离子体发射波长范围为045— 075nm的软x射线能谱，精确测量和准确辨认出类镍、类钴和类铁离子的共振线及类镍离子 的内壳层跃迁线-对实验结果处理，获得了辐射线谱的强度-通过谱线比率的诊断推断脉冲激 光时差对等离子体状态的影响，至少也可部分解释激光上能级的粒子数及等离子体的 电离程度- 关键词： 离子谱特性 软x线能谱强度 谱线辨认     

Ab-initio molecular dynamics simulation on nano-system under external pressure

A new constant-pressure molecular dynamics (MD) method is developed to simulate the dynamic behavior and structure transition of finite system under external pressure. In this method, no artificial parameter is introduced and the computation overheads are very small. As an application, a hard-soft transition of single wall carbon nanotube (SWCNT) under external pressure is found, which is in agreement with the experiments.

     

神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

Hydrogen indium vacancy complex VInH4 in n-type InP studied by positron-lifetime

Positron-lifetime experiments have been carried out on two undoped n-type liquid encapsulated Czochralski (LEC)-grown InP samples with different stoichiometric compositions in the temperature range 10-300 K. For temperatures below 120 K for P-rich InP and 100 K for In-rich InP, the positron average lifetime began to increase rapidly and then leveled off, which was associated with the charge state change of hydrogen indium vacancy complexes from (V_InH₄)⁺ to (V_InH₄)⁰. This phenomenon was more obvious in P-rich samples that have a higher concentration of V_InH₄. The transformation temperature of approximately 120 K suggests that the complex V_InH₄ is a donor defect and that the ionization energy is about 0.01 eV. The ionization of neutral V_InH₄ accounted for the decrease of the positron average lifetime when the sample was illuminated with a photon energy of 1.32 eV at 70 K. These results provide evidence for hydrogen complex defects in undoped LEC InP.     

Evaluation of closed-vessel microwave digestion method for the determination of trace impurities in polymer-based photoresist by inductively coupled plasma mass spectrometry

A closed microwave digestion method followed by inductively coupled plasma spectrometric (ICP-MS) analysis was evaluated for the determination of trace impurities in photoresist. To optimize the digestion procedure, several digestion parameters such as acid, heating temperature and heating time were evaluated. Besides, the digestion efficiency of used photoresist material and the recovery of analyte elements obtained by the use of gravimetric method and ICP-MS measurement, individually, were also compared to clarify the completeness of digestion. According to our experiments, the gravimetric method was found to be not so relevant to the completeness of digestion, because the remaining sample matrix could cause suppression effect in the subsequent ICP-MS measurement. In view of minimizing blank value and working time, a simple single-step heating program was proposed to mineralize 0.25 ml of photoresist material with 5 ml of nitric acid at 180 °C for 10 min. Based on the comparative study of the analytical results obtained by instrumental neutron activation analysis (INAA) and proposed method, the reliability of proposed method for the determination of trace metallic impurities in photoresist material has been confirmed.     

High-Speed Optical Local Access Network System Using Bi-Directional Polarization Multiplexing

A high-speed and economical optical local access network system is proposed where bi-directional polarization multiplexing is applied to a bi-directional transmission. Experimental results using a prototype system confirmlow optical loss and environmental stabilities.     

Comparative investigation of up-conversion luminescence in Tm/Yb-codoped germanate-niobic and germanium-bismuth glasses: effect of phonon density on up-conversion emission

Tm³⁺/Yb³⁺-codoped germanate-niobic (GN) and germanium-bismuth (GB) glasses have been synthesized by conventional melting and quenching method. Intense blue and weak red emissions centered at 477 and 650 nm, corresponding to the transitions ¹G₄→³H₆ and ¹G₄→³H₄, respectively, were observed at room temperature. The possible up-conversion mechanisms are discussed and estimated. GN glass showed a weaker up-conversion emission than GB glass, which is inconsistent with the prediction from the difference of maximum phonon energy between GN and GB glasses. In this paper, Raman spectroscopy was employed to investigate the origin of the difference in up-conversion luminescence in the two glasses. Compared with phonon side-band spectroscopy, Raman spectroscopy extracts more information including both phonon energy and phonon density. For the first time, our results reveal that, besides the maximum phonon energy, the phonon density of host glasses is also an important factor in determining the up-conversion efficiency.