The preparation and properties of bulk-heterojunction organic solar cells with indole-containing fulleropyrrolidine derivatives as acceptors

Two indole-containing fullerene derivatives, N-hydrogen-2-[3-(N-2-ethylhexylindolyl)][60]fulleropyrrolidine (EHIHC60P), and N-(2-ethylhexylindolyl))-2-[3-(N-2-ethylhexylindolyl)][60]fulleropyrrolidine (DEHIC60P) were synthesized by the typical Prato reaction. The absorption spectra, electrochemical properties of the two compounds were measured. Inverted solar cells were fabricated with the structure of ITO/ZnO/poly(3-hexylthiophene) (P3HT):fullerene derivatives/MoO₃/Ag. The highest power conversion efficiencies (PCEs) of 3.32% and 3.23% were obtained for P3HT/EHIHC60P and P3HT/DEHIC60P based solar cells at the composite ratio of 1:1 after the active layers were annealed at 150 °C under inert atmosphere, with a open-circuit voltage (V_oc) of 0.66 V and 0.74 V, respectively. For comparison, the device based on P3HT/PCBM at the same conditions showed the PCE of 3.28%, with a V_oc of 0.61 V. The influence on the photovoltaic property of the fullerene derivatives, which was induced by some subtle changes in the chemical structure was compared and discussed.     

The molecular diversity of three-component reactions of 4-dimethylamino- or 4-methoxypyridine with acetylenedicarboxylates and arylidene cyanoacetates

The three-component reactions of 4-dimethylamino- or 4-methoxypyridine with acetylenedicarboxylates and arylidene cyanoacetates showed very interesting molecular diversity. The polysubstituted 1,8,9,9a-tetrahydro-4H-1,4-ethanoquinolizines, 2H-pyran-2,3-dicarboxylates, and buta-1,3-diene-1,2,4-tricarboxylates derivatives can be formed in high yields and with good diastereoselectivity depending on the substrates and reaction conditions.     

Effect of TaNx on electrical and optical properties of annealed TaNx/Ag/TaNx films

As‐deposited Ag(10 nm)/glass films exhibited agglomerated nanocrystals with seemingly thick boundaries. Introduction of a TaN_x layer below the Ag films resulted in dense and smooth structures, with a resistance at least three times lower than that of Ag/glass. For TaN_x(10 nm)/Ag(10 nm)/TaN_x(10 nm)/glass multilayer films, Auger electron spectroscopy results indicate that TaN_x acts as an effective barrier restraining the diffusion of Ag. After annealing (up to 573 K), no outward diffusion of Ag through either TaN_x layer was seen. However, partial oxidation of the outermost TaN_x layer to form Ta₂O₅ was observed. The films showed promising optical properties with 73% transmittance in the visible region and ~15% average transmittance in the near‐infrared region. The optical data obtained here was in good agreement with simulated predictions. Copyright © 2013 John Wiley & Sons, Ltd.     

A fast parallel clustering algorithm for molecular simulation trajectories

We implemented a GPU‐powered parallel k‐centers algorithm to perform clustering on the conformations of molecular dynamics (MD) simulations. The algorithm is up to two orders of magnitude faster than the CPU implementation. We tested our algorithm on four protein MD simulation datasets ranging from the small Alanine Dipeptide to a 370‐residue Maltose Binding Protein (MBP). It is capable of grouping 250,000 conformations of the MBP into 4000 clusters within 40 seconds. To achieve this, we effectively parallelized the code on the GPU and utilize the triangle inequality of metric spaces. Furthermore, the algorithm's running time is linear with respect to the number of cluster centers. In addition, we found the triangle inequality to be less effective in higher dimensions and provide a mathematical rationale. Finally, using Alanine Dipeptide as an example, we show a strong correlation between cluster populations resulting from the k‐centers algorithm and the underlying density. © 2012 Wiley Periodicals, Inc.     

Accurate double many‐body expansion potential energy surface by extrapolation to the complete basis set limit and dynamics calculations for ground state of NH2

An accurate single‐sheeted double many‐body expansion potential energy surface is reported for the title system. A switching function formalism has been used to warrant the correct behavior at the and dissociation channels involving nitrogen in the ground and first excited states. The topographical features of the novel global potential energy surface are examined in detail, and found to be in good agreement with those calculated directly from the raw ab initio energies, as well as previous calculations available in the literature. The novel surface can be using to treat well the Renner–Teller degeneracy of the and states of . Such a work can both be recommended for dynamics studies of the reaction and as building blocks for constructing the double many‐body expansion potential energy surface of larger nitrogen/hydrogen‐containing systems. In turn, a test theoretical study of the reaction has been carried out with the method of quantum wave packet on the new potential energy surface. Reaction probabilities, integral cross sections, and differential cross sections have been calculated. Threshold exists because of the energy barrier (68.5 meV) along the minimum energy path. On the curve of reaction probability for total angular momentum J = 0, there are two sharp peaks just above threshold. The value of integral cross section increases quickly from zero to maximum with the increase of collision energy, and then stays stable with small oscillations. The differential cross section result shows that the reaction is a typical forward and backward scatter in agreement with experimental measurement result. © 2013 Wiley Periodicals, Inc.     

Experimental Validation of the Temperature-Resistant and Salt-Tolerant Xanthan Enhanced Foam for Enhancing Oil Recovery

Xanthan enhanced foam (XGF) is a newly developed chemical agent for enhanced oil recovery in high-temperature and high-salinity reservoirs. In this paper, laboratory experiments were performed to characterize the morphology and foam properties of XGF, to study its performance under different temperature and different salinity conditions, respectively. Based on simulate reservoir formation conditions of Xidaliya field, a series of research on XGF were conducted. The experimental results showed that the scanning electron microscopy of XGF reflected a more viscoelastic and stable nature of the foam system. High temperature had a great adverse impact upon the stability of XGF, and the increase of salinity in the solution helped to improve the stability of foam. The foam stability increased remarkably when XG4 is added, and an increase in ambient pressure made enhancement of foam stability became more noticeable. In the presence of crude oil, Xanthan could enhance the stability of emulsions and was more favorable to stabilize foam. XG4 enhanced foam had dramatic properties for mobility controlling and oil displacement in the porous media.     

The Influences of Polymers and Temperature on the Foam Properties of 3‐Dodecylalkoxyl‐2‐hydroxylpropyl Trimethylammonium Chloride

The foam performances of 3‐dodecoxy‐2‐hydroxypropyl trimethylammonium chloride (C₁₂TAC) have been determined in the existence of different relative amount of polymer. The experimental results show that the foaming ability of the mixture systems of the C₁₂TAC/PEG and C₁₂TAC/PVP is stronger than that of the surfactant solutions in the absence of polymer, and with the increase of relative amount of polymer both foaming efficiency and foam stability of the surfactant solutions are evidently enhanced. For the aqueous solution of the surfactant, effect of temperature on foaming properties has also been examined. The results show that both the foaming ability and stability of the foams of the surfactant solutions are highest (or strongest) at 30°C.     

Synthesis and characterization of biodegradable polyesteramides constructed mainly by alternating diesterdiamide units from N,N′-bis(2-hydroxyethyl)-adipamide and diacids

Two kinds of aliphatic alternating polyesteramide prepolymers were prepared through melt polycondensation from N,N’-bis(2-hydroxyethyl)-adipamide and adipic acid or sebacic acid. Chain extension of them was conducted with 2,2′-(1,4-phenylene)-bis(2-oxazoline) and adipoyl biscaprolactamate as combined chain extenders. The chain extended polyesteramides (ExtPEAs) were characterized by IR, 1 H-NMR, differential scanning calorimetry, thermogravimetric analysis, wide angle X-ray scattering, tensile test and enzymatic degradation. The results showed that the ExtPEA(4,m)s were mainly constituted with the diester adipamide alternating units. ExtPEA(4,4) and ExtPEA(4,8) had Tm of 83.8℃ and 85.8℃ and initial decomposition temperature above 310.0℃. They crystallized similarly as Nylon-66 did and were flexible thermoplastic materials with tensile strength up to 25.64 MPa and strain at break up to 737%.     

钙钛矿型氧化物负载纳米金属催化剂结构的动态调变及其催化氧化CO反应性能

研究了钛酸钡和钛酸钙担载的Ag和Pt纳米催化剂的表面结构随氧化-还原处理过程的动态变化及其对CO完全氧化反应性能的影响.发现氧化物担载的Ag催化剂在氧化处理后其催化活性较还原处理的高; X射线衍射(XRD)和X射线光电子能谱(XPS)表征结果表明,氧化处理能够提高载体表面Ag颗粒的分散度,而还原处理导致Ag颗粒的聚集,从而降低了催化氧化CO反应的活性.氧化-还原处理改变了担载Ag纳米粒子的尺寸并影响其CO氧化反应活性.与此相反,氧化物担载的Pt催化剂在还原处理后所表现出的CO氧化反应活性较氧化处理的高; 对比研究发现,氧化和还原处理后Pt纳米粒子的尺寸基本相同,但是氧化处理的样品中Pt表面物种以氧化态为主,而还原处理后Pt表面物种主要为金属态.Pt纳米粒子表面化学状态随氧化-还原处理的调变是导致表面催化活性差异的主要原因.