Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Fluorescence decay and quenching of pyrene labeled on sulfonate polyelectrolytes in salt-free aqueous solutions

Fluorescence decay and quenching of pyrene labels on copolymers of 2-acrylamido-2-methylpropanesulphonic acid (AMPS) and N,N-dimethylacrylamide were observed in dilute salt-free aqueous solutions as a function of the mole fraction F_AMPS of AMPS from 0 to 0.896. Monoexponential decay was found for the samples of F_AMPS<0.35 and biexponential decay for the samples of F_AMPS>0.35. The fast decay component is 80%, and the averaged lifetime 〈τ〉 and lifetime τ₁ of the fast decay is decreased with increasing F_AMPS. Quenching efficiency of Cu²⁺, I⁻, CH₃NO₂, and dinitrobenzene to the pyrene label was investigated in the framework of Stern-Volmer plot. With increasing F_AMPS the quenching efficiency of Cu²⁺ is increased while that of I⁻ decreased. For the neutral quenchers, the quenching rate constant k_q increases when F_AMPS<0.449 then decreases, showing a decline of accessibility to the pyrene label. These results were interpreted consistently with the counterion condensation concept, where condensed counterions caused the polyelectrolyte chains to aggregate. The existence of less-polar “temporal aggregated domain” in highly charged polyelectrolytes appears to lead to the slower decay and lower accessibility of the pyrene labels.     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

Equilibrium interaction of solid surfaces across a polymer melt

Forces across polymer melts are poorly understood despite their importance for adhesion and fabricating composite materials. Using an atomic force microscope (AFM), this interaction was measured for poly(dimethyl siloxane) (PDMS). The structure of the polymer at the surface changed during the first approximately 10 h. Afterward, short-range attractive forces were observed with short-chain PDMS (M(w) = 4200 g/mol). Using PDMS with a molecular weight (M(w) = 18 000 g/mol) above the entanglement limit, we measured a monotonically decaying repulsive force, which indicates that a quasi-immobilized layer had formed at the solid surface. Due to the small radius of curvature of the tip, forces could be measured in equilibrium.     

Host-guest complexes of crown ethers with HN-proton-donor molecules

Crown ethers were reacted with HN-proton-donor molecules to obtain crystalline molecular host-guest complexes. It was found that complexes with crown ethers of different structure are formed, depending on the linear dimensions and mode of steric shielding of active centers of the proton-donor molecules.Translated from Zhurnal Obshchei Khimii, Vol. 74, No. 12, 2004, pp. 2030–2033.Original Russian Text Copyright © 2004 by Wang, Ganin.This revised version was published online in April 2005 with a corrected cover date.     

Molecular Beam Mass Spectrometry System for Characterization of Thermal Plasma Chemical Vapor Deposition

A molecular beam mass spectrometry system for in situ measurement of the concentration of gas phase species including radicals impinging on a substrate during thermal plasma chemical vapor deposition (TPCVD) has been designed and constructed. Dynamically controlled substrate temperature was achieved using a variable thermal contact resistance method via a backside flow of an argon/helium mixture. A high quality molecular beam with beamtobackground signal greater than 20 was obtained under film growth conditions by sampling through a small nozzle (75 m) in the center of the substrate. Mass discrimination effects were accounted for in order to quantify the species measurements. We demonstrate that this system has a minimum detection limit of under 100 ppb. Quantitative measurements of hydrocarbon species (H, H₂, C, CH₃, CH₄, C₂H₂, C₂H₄) using Ar/H₂/CH₄ mixtures and silicon species (Si, SiH, SiH₂, SiCl, SiCl₂, Cl, HCl) using Ar/H₂/SiCl₄ mixtures were obtained under thermal plasma chemical vapor deposition conditions.     

Synthesis and structural characterization of a fully conjugated macrocyclic tetraaza(14)-membered Schiff base and its bivalent metal complexes

A novel 14-membered macrocyclic Schiff base derived from 3-cinnamalideneacetoacetanilide and o-phenylenediamine acts as a tetradentate and strongly conjugated ligand to form a cationic solid complex with CuCl₂/NiCl₂/CoCl₂/ZnCl₂. The ligand and the complexes were characterized by the usual spectral and analytical techniques. The main i.r. band of the macrocyclic Schiff base was compared to that of its metal complexes. The C=N bands are shifted to the lower wave number. The cyclic voltammogram of the copper complex shows that the macrocyclic ligand is able to stabilize the copper(III) oxidation state. The e.s.r. spectra of the copper complex in DMSO solution at room temperature and liquid N₂ temperature were recorded and their salient features thoroughly discussed. The antimicrobial screening tests were also recorded and gave good results in the presence of metal ions in the ligand system.