Millimeter wave attenuation in relation to rain rate distribution over a tropical station

Rain, perhaps, is the worst offender for utilising Millimeterwaves in practice. This paper describes the rain rate distribution from which millimeterwave attenuation distribution have been attempted. Results reveal that in our location (Calcutta: lat 23°N long 88.5°E) the rain rate distribution fits well with normal distribution. The cumulative distribution of rain rate also prompted the present authors to find out rain attenuation cumulative distribution for both terrestrial and earth-space paths in millimeterwave band.     

Phonon dispersion in aluminium arsenide and antimonide

The phonon dispersion curves for aluminium arsenide and antimonide have been investigated by using a deformation bond approximation model. The results obtained from this model are compared with the experimental values wherever it is available. Since there is no complete experimental phonon dispersion curves for AlAs, we could not compare our calculated results, but the results of AlSb have been compared with the inelastic neutron scattering measurements at 15 K. However, we compare the phonon frequencies of AlAs and AlSb at critical points of the Brillouin zone obtained by our calculations and Raman spectroscopy measurements. This model predicts the phonon modes satisfactorily in all the symmetry directions of the Brillouin zone (BZ). The spectrum has similar features as observed in other III–V compound semiconductors.     

Phonon dispersion in quasiperiodic semiconductor superlattices

The phonon spectra of unstrained and strained quasiperiodic semiconductor superlattices (QSSL) have been calculated using one-dimensional linear chain model. We consider two types of quasiperiodic systems, namely cantor triadic bar (CTB) and Fibonacci sequences (FS), constituting of AlAs, GaAs and GaSb of which the latter two have a lattice mismatch of about 7%. The calculations have been made using transfer matrix method and also with and without the inclusion of strain. We present the results on phonon spectra of two component CTB and two as well as three component FS semiconductor superlattices (SSL), thickness and order dependence on LO mode of GaAs, effect of strain on LO frequency of GaAs. The calculated results show that the strain generated due to lattice mismatch reduces significantly the magnitudes of the confined optical phonon frequency of GaAs.     

Effect of strain on vibrational modes in strained layer superlattices

We have investigated the lattice vibrational properties of a two-component strained layer semiconductor superlattice (GaAs) _n1 (GaSb) _n2 using a one-dimensional linear chain model and transfer matrix method [1]. Effect of strain, arising due to the lattice mismatch (∼ 7%) has been considered explicitly in the equation of motion. We show for the first time that the optical vibrational frequency increases (in the case of (GaAs)₄ (GaSb) _n ) or decreases (in the case of (GaAs) _n (GaSb)₄) with increase of layer thicknessn, in either type of superlattices. Raman scattering measurements on some other similar systems support our findings.     

Adsorption behaviour of some metal complexes with ferron on Zeo-Karb-226: An atomic absorption spectrophotometric (AAS) study

Summary The adsorption behaviour of ten metal complexes Cr(III), Cr(VI), Mn(II), Fe(II), Fe(III), Co(II), Ni(II), Cu(II), Cd(II) and Pb(II) with ferron on Zeo-Karb-226 in the H⁺ form was investigated at eight different pH-values in order to develop a preconcentration technique for trace amounts of these elements in aqueous solution. The concentrations of the remaining unadsorbed metal ions were determined by atomic absorption spectrophotometry. Under the present experimental conditions, Cr(III) and Pb(II) can be quantitatively determined within the pH range 4–8, while for Cd(II), the optimum pH-range is 7–11. But at pH 11, more than 95% of Cu(II) and Co(II) can be extracted from aqueous solution. The suitability of the technique has been evaluated by analyzing cadmium in simulated water samples. The results indicate that as low as 5 g 1^–1 of CD can be recovered with more than 96% efficiency from 11 of simulated water solution.

---

Adsorptionsverhalten einiger Metallkomplexe mit Ferron an Zeokarb-226: eine AAS-Untersuchung

Zusammenfassung Das Adsorptionsverhalten der Komplexe von Cr(III), Cr(VI), Mn(II), Fe(II), Fe(III), Co(II), Ni(II), Cu(II), Cd(II) und Pb(II) mit Ferron an Zeokarb-226 in der H⁺-Form wurde bei acht verschiedenen pH-Werten untersucht, um eine Anreicherungsmethode für Spuren dieser Elemente zu entwickeln. Die Konzentrationen der verbliebenen nicht adsorbierten Metallionen wurden mit Hilfe der AAS bestimmt. Cr(III) und Pb(II) können im pH-Bereich 4–8 quantitativ erfaßt werden, während der optimale Bereich für Cd(II) bei pH 7–11 liegt. Bei pH 11 werden jedoch mehr als 95% Cu(II) und Co(II) aus der wäßrigen Lösung extrahiert. Der Nutzen des Verfahrens wurde durch Bestimmung von Cd(II) in simulierten Wasserproben erwiesen. Noch 5 g/l Cd können zu mehr als 96% aus 11 Wasserprobe wiedergefunden werden.

     

151Eu-Mössbauer investigation in some new ternary Eu2M3Si5 systems (M=Ni,Pd, Cu,Rh)

The series Eu₂M₃Si₅ (M=Ni, Cu, Pd, Rh) have been synthesised for the first time. The Ni, Cu, Pd systems form in U₂Co₃Si₅ type structure.¹⁵¹Eu Mössbauer spectroscopy shows that Eu is in valence fluctuating (VF) state in Ni system, while in Cu and Pd systems it is in stable divalent state. These observations are further confirmed by magnetic susceptibility studies. The material Eu₂Rh₃Si₅ shows two lines in the Mössbauer resonance, one of which shows VF behaviour.     

Decay of luminescence and dielectric loss in calcite single crystals irradiated by X-rays

Measurements have been taken on the decay of luminescence and dielectric loss of calcite single crystals after X-ray irradiation. These parameters exhibit similar decay behaviour. In the time range 12–60 min, the decay seems to be connected with the depletion of shallow traps in the forbidden energy region and at longer times, it is apparently due to emptying of comparatively deeper traps.     

Adhesion and fingering in the lifting Hele-Shaw cell: Role of the substrate

The lifting Hele-Shaw cell (LHSC) is used to study adhesion as well as viscous fingering. In the present paper we report a series of observations of development of the interface for different viscous fluids, both Newtonian and non-Newtonian, in a LHSC operated at a constant lifting force. Glass and perspex are used as the plates in two different sets of experiments. The objectives are 1) to measure the time required to separate the plates as a function of the lifting force and 2) to note the force above which viscous fingering appears. We find that for the Newtonian fluids, the plate separation time follows a universal power law with the lifting force, irrespective of fluid and substrate. The non-Newtonian fluids too, with proper scaling obey the same power law. The appearance of fingering, however, depends on the properties of the fluid as well as the substrate. We suggest a modified form of the capillary number which controls the onset of fingering; this new quantity, termed the “fingering parameter” involves the dielectric constants of the substrate and fluid in addition to the viscosity and surface tension.     

One step cascade synthesis of 4,5-disubstituted-1,2,3-(NH)-triazoles

A Lewis base-catalyzed three-component cascade reaction was developed for the synthesis of 4,5-disubstituted-1,2,3-(NH)-triazoles. More than 25 new (NH)-triazoles were prepared in good to excellent yields under mild conditions. The availability of the C-4 vinyl group allows easy conversion into other triazole derivatives.