酸性模拟油的油水界面扩张粘弹性研究

考察了不同链长脂肪酸模拟油的扩张模量随扩张频率的变化规律,研究了碱和十二烷基磺酸钠对酸性模拟油界面扩张性质的影响.结果表明,不同脂肪酸模拟油的扩张模量随扩张频率和碳链长度的增加而增大.水相中加入十二烷基磺酸钠对酸性模拟油的扩张模量影响不大,对低工作频率下相角影响较大.无论有无十二烷基磺酸钠,水相中加入NaOH的浓度较低时酸性模拟油的扩张模量变化不大;NaOH浓度较高时,酸性模拟油的界面扩张模量增加,慢弛豫过程在界面上起主要作用,此时界面上可能形成了特殊结构.     

界面张力弛豫法研究不同分子量原油活性组分界面扩张粘弹性

采用界面张力弛豫法研究了不同分子量原油活性组分在正癸烷-水界面上的扩张粘弹性质,阐述了界面扩张模量的弹性和粘性随扩张频率的变化规律.研究发现,随着原油活性组分分子量的增大,极限扩张粘度明显增大,而极限扩张弹性逐渐增大;当分子量大于某一数值后,极限扩张弹性变化不明显.对界面张力弛豫实验结果进行拟合得到的参数表明,界面上和界面附近的微观弛豫过程的数目随原油活性组分分子量的增加而增加,弛豫过程的特征频率也呈规律性变化.不同原油活性组分的界面扩张粘弹性质可从其不同特征的微观弛豫过程得到解释.     

驱油体系化学剂间相互作用对界面吸附膜的影响

采用界面张力弛豫技术研究了不对称Gemini表面活性剂C12COONa-p-C9SO3Na、部分水解聚丙烯酰胺Mo-4000、疏水缔合水溶性聚丙烯酰胺(HMPAM)等驱油体系化学剂在癸烷/水界面上的扩张流变性质,考察了不同离子强度、不同类型电解质对体系界面流变性质的影响,计算得到界面扩张弹性模量和粘性模量的全频率谱,并通过归一化方法(cole-cole图)探讨了界面吸附膜的弛豫过程。研究发现,界面膜内分子重排和界面与体相间分子扩散交换是影响膜性质的主要弛豫过程。表面活性剂体相浓度增大有利于界面分子重排过程,而低频有利于扩散交换过程;不同结构聚合物以及不同离子强度、不同类型电解质对表面活性剂吸附膜有不同的影响。     

基于低相干光的阵列透镜束匀滑技术研究

基于激光加载的材料状态方程的实验研究对靶面光强分布的均匀性及稳定性提出了极高的要求,靶面光强的上述两大特性在很大程度上决定了实验结果的精度和可重复性.本文针对传统窄带高相干激光装置在激光加载材料状态方程实验中表现出的靶面光强均匀性和光强分布稳定性两方面可能存在的问题,提出了基于宽带低相干激光,利用消衍射阵列透镜联合诱导非相干技术的束匀滑方案,并重点分析了波前相位畸变对靶面不均匀性及稳定性的影响.模拟结果表明,该方法明显降低了靶面不均匀性,提高了对波前相位畸变的包容度,获得了均匀、稳定的光强分布.统计分析显示,焦斑强度分布极差和不均匀性与波前相位畸变均方根梯度相关性较强.因此,可以根据统计结果以及实验对焦斑强度分布的要求,给出波前相位畸变的容差范围,对状态方程实验中激光驱动器参数的设计与优化具有指导意义.     

Electrical, dielectric and surface wetting properties of multi-walled carbon nanotubes/nylon-6 nanocomposites

This paper reports that the multi-walled carbon nanotubes(MWCNT)/nylon-6 (PA6) nanocomposites with different MWCNT loadingshave been prepared by a simple melt-compounding method. Theelectrical, dielectric, and surface wetting properties of theCNT/PA6 composites have been studied. The temperature dependence ofthe conductivity of the CNT/PA6 composite with 10.0 wt{\%} CNTloading ($\sigma _{\rm RT} \sim 10^{-4}$ S/cm) are measured, andafterwards a charge-energy-limited tunnelling model (ln $\sigma (T)\sim T^{-1/2})$ is found. With increasing CNT weight percentage from0.0 to 10.0 wt%, the dielectric constant of the CNT/PA6composites enhances and the dielectric loss tangent increases twoorders of magnitude. In addition, water contact angles of theCNT/PA6 composites increase and the composites with CNT loadinglarger than 2.0 wt%even become hydrophobic. The obtainedresults indicate that the electrical and surface properties of thecomposites have been significantly enhanced by the embedded carbonnanotubes.     

Isotropic ferromagnetic resonance field shift in as-prepared permalloy/FeMn bilayers

Exchange-coupled wedged-permalloy (Py)/FeMn bilayers are studied by ferromagnetic resonance (FMR) technique at room temperature. In comparison, Py single layer films were also made. For Py single layer films and Py/FeMn bilayers, only one uniform resonance peak was observed at high magnetic fields, indicating no interfacial diffusion at the Py/FeMn and Py/Cu interfaces. Negative isotropic in-plane resonance field does exist in Py/FeMn bilayers and its magnitude increases with decreasing Py layer thickness. In order to explain above phenomena, interfacial perpendicular anisotropy must be considered simultaneously, in addition to irreversible rotation of spins in FeMn layers. This is because the perpendicular resonance field of the bilayers is larger than that of Py single layer films.     

Fusion of conventional ultrasound imaging and acousto-optic sensing by use of a standard pulsed-ultrasound scanner

Acousto-optic sensing (AOS) is a dual-wave sensing technique based on the ultrasound modulation of diffuse light in a turbid medium. We experimentally demonstrate the feasibility of combining AOS and conventional ultrasound imaging by use of a commercially available pulsed-ultrasound scanner coupled with a photorefractive crystal-based optical interferometry system. Optically absorbing targets embedded in highly diffusive phantoms (mus'= 10 cm(-1)) are imaged through a thickness of 27 mm with millimeter resolution. The acousto-optic images are intrinsically coregistered with the ultrasound images.