Development of metrological models for internal standard single-point and multi-point calibrations for the assessment of tear gas weapons compliance with legislation

Tear gases are the most widely used non-lethal weapons, both by security forces and by the general public. The pepper spray, whose active agent is capsaicin, is the only self-defence aerosol allowed in Portugal, where capsaicin concentration must be below 5 g/100 mL. The cost-effective evaluation of the compliance of self-defence weapons with legislation involves the use of two measurement procedures with increasing quantitative capability. Samples are first assessed by preliminary measurement procedure based on single-point GC–MS calibration. Whenever the measurement uncertainty from this assessment makes evaluation inconclusive, the evaluation of sample compliance using multi-point GC–MS calibration is performed. Metrological models including sound criteria for the evaluation of sample compliance with legislation were developed for both measurement procedures. Such models include the evaluation of the impact of instrumental performance, calibration model, sample dilution and standards preparation on measurement uncertainty. The relative expanded uncertainty, in the studied range (capsaicin 3–7 g/100 mL), of measurements supported in single-point calibrations ranged from 10 to 22% and the ones supported on multi-point calibrations from 8 to 12% depending on capsaicin concentration and daily GC–MS repeatability. Measurements are fit for the intended use since they present a relative expanded uncertainty smaller than a target value of 30, or 15%, for measurements supported in single- or multi-point calibrations, respectively.     

Introduction of Primary Amino Groups on Poly(ethylene terephthalate) Surfaces by Ammonia and a Mix of Nitrogen and Hydrogen Plasma

With the aim of introducing primary amino groups on the surface of poly(ethylene terephthalate) (PET), two methods were compared—the use of ammonia or a combination of nitrogen and hydrogen low-pressure microwave plasma. Several plasma parameters were optimized on the reactor to increase the –NH₂ surface density, which was estimated by colorimetric titration and X-ray photoelectron spectroscopy (XPS). These techniques show that whatever the plasma treatment, almost 2 –NH₂/nm2 are incorporated on PET films. Emission spectroscopy highlighted a correlation between the density of primary amino groups and the ratio between an NH peak intensity and an Ar peak intensity (I_NH/I_Ar). Variation in surface hydrophilicity with aging in air after plasma treatment was monitored with contact angle measurements and showed a hydrophobic recovery. This was confirmed by XPS, which suggests also that surfaces treated by NH₃ plasma are more stable than surfaces treated by N₂/H₂.     

Maximum Saccharification of Cellulose Complex by an Enzyme Cocktail Supplemented with Cellulase from Newly Isolated <Emphasis Type="BoldItalic">Aspergillus fumigatus</Emphasis> ECU0811

Either the natural biodegradation process or the industrial hydrolytic process requires synergistic interactions between various cellulases. However, it is sometimes impeded by low hydrolytic rate of existing cellulases and the lack of accessory enzymes. Herein, the ability of a commercial cellulase (Spezyme CP, from Genencor) to degrade steam explosion-pretreated corn stover was significantly improved. Firstly, a fungal cellulase producer, Aspergillus fumigatus ECU0811, was isolated from hundreds of soil samples. A 96-deep-well microscale-based platform was developed here to reduce the labor-intensive screening work and proved to be consistent with macroscale screening work. After optimization of fermentation, 3% corn cob could induce A. fumigatus ECU0811 to yield the highest cellulase production. Based on the high activities of β-glucosidase and xylanase by A. fumigatus ECU0811, 0.91 and 125 U/mg protein, respectively, an enzyme cocktail was composed with a fixed dosage of Spezyme CP (CPCel) at 14.2 filter paper units (FPU)/g glucan and varied dosages of A. fumigatus cellulase (AFCel). Consequently, the glucan-to-glucose conversion of corn stover was increased from 25.6% in the presence of CPCel at a dosage of 14.2 FPU/g glucan to 99.5% in the presence of the enzyme cocktail (14.2 FPU CPCel plus 1.21 FPU AFCel per gram of glucan). On the other side, it reduced the total protein amount of CPCel by as much as tenfold, which extremely improved the hydrolytic rate of Spezyme CP and reduced its dosage.     

Speciation of heavy metals in sewage sludge after mesophilic and thermophilic anaerobic digestion

Two types of sewage sludge anaerobic digestion were carried out: mesophilic and thermophilic. Metal speciation analysis was performed revealing some changes in the chemical form of the metals during the stabilization process of sludge. After both methane fermentation processes, a comparable level of organic matter distribution was obtained (≈ 40 %). The amount of produced methane during thermophilic and mesophilic digestion was 560 mL of CH4 and 580 mL of CH₄ from 1 g of removed organic matter, respectively. Low concentration of heavy metal ions in the liquid phase of sludge was observed. Metal ions precipitated and remained bound throughout the stabilization process. No accumulation of heavy metals in the mobile fractions of sludge (exchangeable and carbonate) was observed for either digestion process. The highest increase of zinc, copper, nickel, cadmium, and chromium concentration was observed in the organic-sulfide fraction, whereas the highest increase of lead was found in the residual fraction.     

Novel Copolymers of 4-Fluorostyrene. 11. Some Ring-substituted 1,1-dicyano-2-(1-naphthyl)ethylenes

Novel copolymers of trisubstituted ethylene monomers, ring-substituted 1,1-dicyano-2-(1-naphthyl)ethylenes, RC₁₀H₆CH?C(CN)₂ (where R is H, 2-OCH₃, 4-OCH₃) and 4-fluorostyrene were prepared by solution copolymerization in the presence of a radical initiator (ABCN) at 70°C. The composition of the copolymers was calculated from nitrogen analysis, and the structures were analyzed by IR, ¹H and ¹³C-NMR. The order of relative reactivity (1/r ₁) for the monomers is (5.86) > 2-CH₃O (4.28) > 4-CH₃O (2.87). Relatively high T_g of the copolymers in comparison with that of poly(4-fluorostyrene) indicates a decrease in chain mobility of the copolymer due to the high dipolar character of the trisubstituted ethylene monomer unit. Decomposition of the copolymers in nitrogen occurred in two steps, first in the 200–500°C range with residue (7.3–7.7% wt.), which then decomposed in the 500–800°C range.     

Random Copolymers of 1,5-Dioxepan-2-one

ABSTRACT

Copolymers of 1,5-dioxepan-2-one (DXO) and e-caprolactone (?-CL), δ-valerolactone (δ-VL) or L-lactide (LLA) have been synthesized and characterized. High molecular weight copolymers were obtained using stannous-2-ethyl hexanoate as catalyst in bulk. Reactivity ratios for the copolymerization of DXO and δ-VL were determined at 110°C as r_VL=0.5 and r_DXO=2.3. At high conversion, depolymerization of δ-VL occurred, resulting in lower molecular weight and variations in the copolymer composition.

Physical properties, such as crystallinity and melting temperature of the DXO-copolymers proved to be strongly dependent on the choice of comonomer and on the molar composition of the copolymers. DXO appears to be incorporated into the poly-?-caprolactone (PCL) crystals and to some extent into the poly-δ-valerolactone (PVL) crystals, resulting in a more gradual decrease in crystallinity with increasing amount of DXO.     

Determination of non-steroidal anti-inflammatory drugs in urine by the combination of stir membrane liquid–liquid–liquid microextraction and liquid chromatography

A stir membrane liquid phase microextraction procedure working under the three-phase mode is proposed for the first time for the determination of six anti-inflammatory drugs in human urine. The target compounds are isolated and preconcentrated using a special device that integrates the extractant and the stirring element. An alkaline aqueous solution is used as extractant phase while 1-octanol is selected as supported liquid membrane solvent. After the extraction, all the analytes are determined by liquid chromatography (LC) with ultraviolet detection (UV). The analytical method is optimized considering the main involved variables (e.g., pH of donor and acceptor phases, extraction time, stirring rate) and the results indicate that the determination of anti-inflammatory drugs at therapeutic and toxic levels is completely feasible. The limits of detection are in the range from 12.6 (indomethacin) to 30.7 μg/L (naproxen). The repeatability of the method, expressed as relative standard deviation (RSD, n = 5) varies between 3.4% (flurbiprofen) and 5.7% (ketoprofen), while the enrichment factors are in the range from 35.0 (naproxen) to 72.5 (indomethacin).     

Characterization of non-stoichiometric co-sputtered Ba0.6Sr0.4(Ti1???x Fe x )1?+?x O3???δ thin films for tunable passive microwave applications

The fabrication of novel iron-doped barium strontium titanate thin films by means of radio frequency (RF) magnetron co-sputtering is shown. Investigations of the elemental composition and the dopant distribution in the thin films obtained by X-ray photoelectron spectroscopy, Rutherford backscattering spectrometry, and time-of-flight secondary ion mass spectroscopy reveal a homogeneous dopant concentration throughout the thin film. The incorporation of the iron dopant and the temperature-dependent evolution of the crystal structure and morphology are analyzed by electron paramagnetic resonance spectroscopy, X-ray diffraction, Raman spectroscopy, atomic force microscopy, and scanning electron microscopy. In summary, these results emphasize the RF magnetron co-sputter process as a versatile way to fabricate doped thin films.     

High toxicity and specificity of the saponin 3-GlcA-28-AraRhaxyl-medicagenate, from Medicago truncatula seeds, for Sitophilus oryzae

Background

Because of the increasingly concern of consumers and public policy about problems for environment and for public health due to chemical pesticides, the search for molecules more safe is currently of great importance. Particularly, plants are able to fight the pathogens as insects, bacteria or fungi; so that plants could represent a valuable source of new molecules.

Results

It was observed that Medicago truncatula seed flour displayed a strong toxic activity towards the adults of the rice weevil Sitophilus oryzae (Coleoptera), a major pest of stored cereals. The molecule responsible for toxicity was purified, by solvent extraction and HPLC, and identified as a saponin, namely 3-GlcA-28-AraRhaxyl-medicagenate. Saponins are detergents, and the CMC of this molecule was found to be 0.65?mg per mL. Neither the worm Caenorhabditis elegans nor the bacteria E. coli were found to be sensitive to this saponin, but growth of the yeast Saccharomyces cerevisiae was inhibited at concentrations higher than 100???g per mL. The purified molecule is toxic for the adults of the rice weevils at concentrations down to 100???g per g of food, but this does not apply to the others insects tested, including the coleopteran Tribolium castaneum and the Sf9 insect cultured cells.

Conclusions

This specificity for the weevil led us to investigate this saponin potential for pest control and to propose the hypothesis that this saponin has a specific mode of action, rather than acting via its non-specific detergent properties.     

Substantial improvements in large-scale redocking and screening using the novel HYDE scoring function

The HYDE scoring function consistently describes hydrogen bonding, the hydrophobic effect and desolvation. It relies on HYdration and DEsolvation terms which are calibrated using octanol/water partition coefficients of small molecules. We do not use affinity data for calibration, therefore HYDE is generally applicable to all protein targets. HYDE reflects the Gibbs free energy of binding while only considering the essential interactions of protein-ligand complexes. The greatest benefit of HYDE is that it yields a very intuitive atom-based score, which can be mapped onto the ligand and protein atoms. This allows the direct visualization of the score and consequently facilitates analysis of protein-ligand complexes during the lead optimization process. In this study, we validated our new scoring function by applying it in large-scale docking experiments. We could successfully predict the correct binding mode in 93% of complexes in redocking calculations on the Astex diverse set, while our performance in virtual screening experiments using the DUD dataset showed significant enrichment values with a mean AUC of 0.77 across all protein targets with little or no structural defects. As part of these studies, we also carried out a very detailed analysis of the data that revealed interesting pitfalls, which we highlight here and which should be addressed in future benchmark datasets.