TINS, target immobilized NMR screening: an efficient and sensitive method for ligand discovery

We propose a ligand screening method, called TINS (target immobilized NMR screening), which reduces the amount of target required for the fragment-based approach to drug discovery. Binding is detected by comparing 1D NMR spectra of compound mixtures in the presence of a target immobilized on a solid support to a control sample. The method has been validated by the detection of a variety of ligands for protein and nucleic acid targets (K(D) from 60 to 5000 muM). The ligand binding capacity of a protein was undiminished after 2000 different compounds had been applied, indicating the potential to apply the assay for screening typical fragment libraries. TINS can be used in competition mode, allowing rapid characterization of the ligand binding site. TINS may allow screening of targets that are difficult to produce or that are insoluble, such as membrane proteins.     

Alignment of low‐dose X‐ray fluorescence tomography images using differential phase contrast

X‐ray fluorescence nanotomography provides unprecedented sensitivity for studies of trace metal distributions in whole biological cells. Dose fractionation, in which one acquires very low dose individual projections and then obtains high statistics reconstructions as signal from a voxel is brought together (Hegerl & Hoppe, 1976), requires accurate alignment of these individual projections so as to correct for rotation stage runout. It is shown here that differential phase contrast at 10.2 keV beam energy offers the potential for accurate cross‐correlation alignment of successive projections, by demonstrating that successive low dose, 3 ms per pixel, images acquired at the same specimen position and rotation angle have a narrower and smoother cross‐correlation function (1.5 pixels FWHM at 300 nm pixel size) than that obtained from zinc fluorescence images (25 pixels FWHM). The differential phase contrast alignment resolution is thus well below the 700 nm × 500 nm beam spot size used in this demonstration, so that dose fractionation should be possible for reduced‐dose, more rapidly acquired, fluorescence nanotomography experiments.     

Heterogeneous Alkane Reactions over Nanoporous Catalysts

Pt-USY-712 (Si/Al = 6) and three SBA-15 catalysts (metal-loaded with 1 wt% Pt, 1 wt% Ni or 0.5 wt% Pt and 0.5 wt% Ni) were prepared and characterised using scanning electron microscopy (SEM), X-ray diffraction (XRD), N \(_{2}\) adsorption porosimetry / BET and transmission electron microscopy (TEM). The catalysts were then tested in the hydroisomerisation and hydrocracking of \(n\) -heptane using a micro-reactor at atmospheric pressure, and the products were analysed by GC-FID. Reaction temperatures ranged from 250– \(400\,\,^{\circ }\hbox {C}\) while the W/F values of \(n\hbox {-C}_{7}\) varied from 224.70–550.57 kg \(\hbox {mol}^{-1}\) . The coke content of each catalyst was measured using thermo gravimetric analysis (TGA). The catalytic activity was highest on Pt-USY-712 at the lowest reaction temperatures due to (a) the presence of strong Brønsted acids sites on the zeolite and (b) the smaller and more highly dispersed metal clusters on Pt-USY-712, relative to Pt-SBA-15. The activity was higher on the bimetallic Pt/Ni-SBA-15 than on mono-metallic Pt-SBA-15 as the co-impregnation of Ni with Pt enhanced the distribution of the metal clusters on the catalyst and resulted in improved surface area for reaction. The Pt-SBA-15 and Pt/Ni-SBA-15 catalysts both had the lowest and approximately equal coke percentages with 0.116 and 0.119 wt%, respectively.     

Butane and propane oxidation by engineered cytochrome P450cam

The haem monooxygenase cytochrome P450cam has been engineered to oxidise the gaseous alkanes butane and propane to butan-2-ol and propan-2-ol, respectively, by the use of bulky amino acid substitutions to reduce the volume of the substrate pocket and thus improve the enzyme-substrate fit: the F87W/Y96F/T101L/V247L mutant oxidizes butane with a turnover rate of 750 min-1 and 95% yield based on NADH consumed while the wild-type enzyme has an activity of 0.4 min-1 with 4% yield.     

An Unusual Stable Mononuclear MnIII Bis‐terpyridine Complex Exhibiting Jahn–Teller Compression: Electrochemical Synthesis,Physical Characterisation and Theoretical Study

The mononuclear manganese bis‐terpyridine complex [Mn(tolyl‐terpy)₂](X)₃ ( 1 (X)₃; X=BF₄, ClO₄, PF₆; tolyl‐terpy=4′‐(4‐methylphenyl)‐2,2′:6′,2“‐terpyridine), containing Mn in the unusual +III oxidation state, has been isolated and characterised. The 1 ³⁺ ion is a rare example of a mononuclear Mn^III complex stabilised solely by neutral N ligands. Complex 1 ³⁺ is obtained by electrochemical oxidation of the corresponding Mn^II compound 1 ²⁺ in anhydrous acetonitrile. Under these conditions the cyclic voltammogram of 1 ²⁺ exhibits not only the well‐known Mn^II/Mn^III oxidation at E_1/2=+0.91 V versus Ag/Ag⁺ (+1.21 V vs. SCE) but also a second metal‐based oxidation process corresponding to Mn^III/Mn^IV at E_1/2=+1.63 V (+1.93 V vs. SCE). Single crystals of 1 (PF₆)₃?2 CH₃CN were obtained by an electrocrystallisation procedure. X‐ray analysis unambiguously revealed its tetragonally compressed octahedral geometry and high‐spin character. The electronic properties of 1 ³⁺ were investigated in detail by magnetic measurements and theoretical calculations, from which a D value of +4.82 cm^?1 was precisely determined. Density functional and complete active space self consistent field ab initio calculations both correctly predict a positive sign of D, in agreement with the compressed tetragonal distortion observed in the X‐ray structure of 1 (PF₆)₃?2 CH₃CN. The different contributions to D were calculated, and the results show that 1) the spin–orbit coupling part (+2.593 cm^?1) is predominant compared to the spin–spin interaction (+1.075 cm^?1) and 2) the excited triplet states make the dominant contribution to the total D value.     

Unexpected Self‐Assembly of a Homochiral Metallosupramolecular M4L4 Catenane

Two enantiomerically pure 9,9′‐spirobifluorene‐based bis(pyridine) ligands 1 and 2 were prepared to study their self‐assembly behavior upon coordination to cis‐protected palladium(II) ions. Whereas the sterically more demanding ligand, 2 , gave rise to the expected dinuclear metallosupramolecular M₂L₂ rhombi, the sterically less demanding ligand, 1 , acts as a template to give rise to a homochiral metallosupramolecular M₄L₄ catenane.     

Silver‐Free Two‐Component Approach in Gold Catalysis: Activation of [LAuCl] Complexes with Derivatives of Copper,Zinc, Indium,Bismuth, and Other Lewis Acids

Complexes of type [LAuCl] (L=phosphine, phosphite, NHC and others) are widely employed in homogeneous catalysis, however, they are usually inactive as such and must be used jointly with a halide scavenger. To date, this role has mostly been entrusted to silver salts (AgSbF₆, AgPF₆, AgBF₄, AgOTf, etc.). However, silver salts can be the source of deactivation processes or side reactions, so it is sometimes advisable to use silver‐free cationic gold complexes, which can be difficult to synthesize and to handle compared with the more robust chloride. We show in this study that various Lewis acids of the transition and main group metal families are expedient substitutes to silver salts. We have tested Cu^I, Cu^II, Zn^II, In^III, Si^IV, Bi^III, and other salts in a variety of typical Au^I‐catalyzed transformations, and the results have revealed that [LAuCl] can form active species in their presence.     

Electrochemical Characterization of Self‐Assembled Monolayer of a Novel Manganese Tetrabenzylthio‐Substituted Phthalocyanine and Its Use in Nitrite Oxidation

Manganese phthalocyanine MnPc(SPh)₄ has been synthesized and used to form self assembled monolayers on gold electrodes. The well packed SAM monolayer was characterized by analyzing the blocking of a number of Faradic processes by cyclic voltammetry, evaluating the electrical characteristics of the modified electrode by electrochemical impedance and imaging the modified surface by electrochemical scanning microscopy. Finally, MnPc(SPh)₄‐SAM modified electrode displayed an electrocatalytic behavior toward the oxidation of nitrite.     

Design of cross-linked semicrystalline poly(ε-caprolactone)-based networks with one-way and two-way shape-memory properties through Diels-Alder reactions

Cross‐linked poly(ε‐caprolactone) (PCL)‐based polyesterurethane (PUR) systems have been synthesized through Diels–Alder reactions by reactive extrusion. The Diels–Alder and retro‐Diels–Alder reactions proved to be useful for enhancing the molecular motion of PCL‐based systems, and therefore their crystallization ability, in the design of cross‐linked semicrystalline polymers with one‐way and two‐way shape‐memory properties. Successive reactions between α,ω‐diol PCL (PCL₂), furfuryl alcohol, and methylene diphenyl 4,4′‐diisocyanate straightforwardly afforded the α,ω‐furfuryl PCL‐based PUR systems, and subsequent Diels–Alder reactions with N,N‐phenylenedimaleimide afforded the thermoreversible cycloadducts. The cross‐linking density could be modulated by partially replacing PCL‐diol with PCL‐tetraol. Interestingly, the resulting PUR systems proved to be semicrystalline cross‐linked polymers, the melting temperature of which (close to 45 °C) represented the switching temperature for their shape‐memory properties. Qualitative and quantitative measurements demonstrated that these PUR systems exhibited one‐way and two‐way shape‐memory properties depending on their cross‐linking density.