A study on the role of gelatin in methacrylic-acid-based gel dosimeters

In radiotherapy treatment, polymer gel dosimetry can be used for verifying three-dimensional (3D) dose distributions. Gelatin is generally used as a gelling agent in the dosimeters. In this paper, another role of gelatin in a methacrylic-acid-based gel dosimeter (MAGAT) is investigated. Temperature increases due to exothermic polymerization in the irradiated gel are measured directly. Dose–R₂ responses are also obtained using MRI. It is shown that no appreciable increases in either temperature or R₂ are observed in MAGAT dosimeters made without gelatin, and that significant temperature and R₂ increases are observed when very low gelatin concentrations are used. These results indicate that gelatin is an important enabler for radiation-induced free-radical polymerization in methacrylic-acid-based gels. When gelatin is replaced by amino acids, changes in temperature are observed, along with small changes in R₂. The resulting dosimeter solutions remain transparent because the polymer does not precipitate as it does in regular MAGAT dosimeters containing gelatin. When the amino acids are replaced by acids without amino groups, no temperature or R₂ changes are observed, indicating that no polymer forms. These results show that amino groups (and possibly other functional groups) on the gelatin catalyze the radiation-induced free-radical polymerization that occurs in MAGAT dosimeters.     

Revised structures of gambiriins A1, A2, B1, and B2, chalcane-flavan dimers from gambir (Uncaria gambir extract)

Gambir, the aqueous extract from Uncaria gambir (Rubiaceae), has been used as an astringent medicine in Asian countries. Investigation of the constituents in the extract led to the isolation of four chalcane-flavan dimers, gambiriin A1 (6), A2 (7), B1 (8), and B2 (9), in addition to (+)-catechin (1), (+)-epicatechin (2), and dimeric proanthocyanidins, procyanidin B1 (3), procyanidin B3 (4), and gambiriin C (5). The spectroscopic and chemical data obtained in the present study indicated that their previously proposed structures 6a, 7a, 8a, and 9a should be revised to 6, 7, 8, and 9, respectively.     

Physicochemical characterization of tamoxifen citrate pseudopolymorphs, methanolate and ethanolate

Two novel pseudopolymorphs, methanolate and ethanolate of tamoxifen [(Z)-2-[4-(1,2-diphenyl-1-butenyl)phenoxy]-N,N-dimethylethylamine]citrate, were prepared in addition to forms A and B reported previously. Their crystalline forms were identified and characterized by powder and single crystal X-ray diffractometry, differential scanning calorimetry, thermogravimetric analysis, hot-stage microscopy, scanning electron microscopy and diffuse reflectance infrared Fourier-transform spectroscopy, and their physicochemical stability was also evaluated. The results of single crystal X-ray analysis and thermogravimetric analysis of methanolate and ethanolate suggested that the stoichiometry of tamoxifen citrate : methanol and tamoxifen citrate : ethanol could be composed of a 1 : 1 molecular ratio for both solvates. The results of physicochemical stability evaluations at 75 and 97% RH at 40 and 60 degrees C indicated that the metastable form A was quite stable for at least 2 months even under severe storage conditions, whereas methanolate immediately transformed to a crystalline mixture of forms A and B, and subsequently changed to the stable form B.     

Enhanced skin permeation of diclofenac by ion-pair formation and further enhancement by microemulsion

Enhancement of skin permeability of anionic diclofenac from non-aqueous vehicle isopropyl myristate (IPM) by ion-pair formation with either alkylamines or benzylamine as model cationic ions was examined in guinea pig dorsal skin. Diclofenac ion flux increased in the presence of these amines due to an increase in solubility. Maximum flux was observed in the presence of n-hexylamine, which induced 7.3-fold increase accompanied by a 45-fold increase in solubility. Permeability coefficients of the ionic form of diclofenac in the presence of benzylamine, n-hexylamine and iso-octylamine as counter ions in IPM were larger than those of the non-ionic form of diclofenac. Since the solubility of diclofenac was still limited, to obtain further enhancement of skin permeation, the effects of microemulsions as a vehicle consisting of phosphate buffered saline (PBS), isopropyl myristate (IPM), polyoxyethylene sorbitan monooleate (Tween 80) and ethanol were examined for transport of diclofenac-benzylamine ion-pairs. All microemulsion formulations tested increased diclofenac flux 4.9-fold to 10.7-fold over the value without a microemulsion accompanied by a 217-fold to 302-fold improvement in the solubility of diclofenac-benzylamine ion-pairs, but permeability coefficients were decreased 28-44 fold. Maximum enhancement was observed for a microemulsion with a ratio of PBS, IPM, ethanol and Tween 80 of 25 : 8 : 47 : 20 (w/w). The present findings suggest the usefulness of combined use of ion-pairs with microemulsions for enhancement of skin permeation of ionic drugs.     

Comparative study of the water oxidizing reactions and the millisecond delayed chlorophyll fluorescence in photosystem II at different pH

Water splitting activity, the multiline EPR signal associated with S(2)-state of the CaMn(4)-cluster and the fast and slow phases of the induction curve of the millisecond delayed chlorophyll fluorescence from photosystem II (PSII) in the pH range of 4.5-8.5 were studied in the thylakoid membranes and purified PSII particles. It has been found that O(2) evolution and the multiline EPR signal were inhibited at acidic (pK approximately 5.3) and alkaline (pK approximately 8.1) pH values, and were maximal at pH 6.0-7.0. Our results indicate that the loss of O(2) evolution and the S(2)-state multiline EPR signal associated with the decrease of the millisecond delayed chlorophyll fluorescence only in alkaline region (pH 7.0-8.5). Possible correlations of the millisecond delayed chlorophyll fluorescence components with the donor side reactions in PSII are discussed.     

Utilization of gamma-ray irradiation for hydrogen production from water

A technique has been proposed to promote hydrogen production from water by increasing the energy deposition in water through the conversion of γ-ray to low-energy electrons, which is achieved by putting solid materials into water. Simulation studies by the MCNP code indicate that the average deposited energy in water can be increased by optimizing geometry of the materials. In the present experiments using Al₂O₃ particles of various average diameters, the maximum amount of hydrogen produced is 3.48 μmol/cm³ for the water containing Al₂O₃ particles of 3 μm diameter, which is more than two order of magnitude larger of the H₂ produced in water-only configuration.     

Charge-induced spin alignment in diradical donor molecules: numerical calculations of correlated many-electron-spin systems

The mechanism of charge-induced high spin is studied in pi-conjugated molecules by means of a model-Hamiltonian approach. Intersite Coulomb interactions are taken into account in a pi-conjugated moiety, which is coupled with two localized spins through exchange interactions. We clarify spin alignment in neutral and oxidized states by exact numerical calculations including all the correlation effects. In thianthrene-based molecules, one-electron oxidation induces strong ferromagnetic correlation between the localized spins irrespective of the spin alignment in the neutral state. The localized spins are coupled to the delocalized hole spin ferromagnetically, leading to a high-spin state in the oxidized molecule. Our calculations on structural dependence and effective exchange interaction are consistent with the recent experiment of thianthrene bis(nitronyl nitroxide). By comparing the thianthrene-based molecule with the anthracene-based one, we clarify the role of superexchange interactions via the sulfur atoms.     

Hydrogenation of benzaldehyde and cinnamaldehyde in compressed CO2 medium with a Pt/C catalyst: a study on molecular interactions and pressure effects

The hydrogenation of benzaldehyde and cinnamaldehyde has been studied with a 5% Pt/C catalyst in compressed CO(2). The effect of CO(2) pressure on the total conversion was found to be different between the two aldehydes. The total conversion of benzaldehyde merely decreases with increasing CO(2) pressure, while that of cinnamaldehyde shows a maximum at a certain pressure. High-pressure FTIR measurements indicate the existence of interactions of CO(2) with the aldehydes. The absorption of nu(C=O) red-shifts at increasing CO(2) pressure, and this red-shift is more significant for cinnamaldehyde than for benzaldehyde, indicating that the C=O bond of the former becomes more reactive than the latter. The difference in the mode of interactions of CO(2) with these aldehydes has also been indicated by changes of nu(C=O) of CO(2). Thus, the conversion of benzaldehyde will decrease with increasing CO(2) pressure because of a simple dilution by introducing a larger quantity of CO(2). For cinnamaldehyde, the conversion will increase at low pressures because of increasing interactions with CO(2) molecules (increasing the reactivity of the C=O bond) but decrease at high pressures because of the simple dilution effect, similar to the case of benzaldehyde. The dense CO(2) molecules are not likely to change the catalytic activity of supported Pt particles, which was previously suggested from optical absorption of supported fine metal (Au) particles in a compressed CO(2) medium.     

Synthesis of ladder polymers containing polydiacetylene backbones connected with methylene chains and their optical properties

The polymers consisting of polydiacetylene (PDA) backbones were obtained from the novel monomer derivatives, R CC CC R′ CC CC R [where R =  (CH₂)₄OCONHCH₂COOC₄H₉, R′ =  (CH₂)_n ; n = 2, 4, 8] [4BCMU4A(n)], in which linear methylene chain is sandwiched between two diacetylene moieties by solid-state 1,4-addition reaction. The polymerization process was investigated in detail by using spectroscopic techniques such as solid-state ¹³C-NMR, visible absorption, and IR absorption spectra. It was estimated that the polymerization of 4BCMU4A(8) and 4BCMU4A(4) takes place by two consecutive 1,4-addition reactions to form two PDA backbones, which constitute the two poles of the respective ladders. The bridging methylene chain length in the monomer was found to play a vital role as far as the polymerization process is concerned. Thus, the monomers with eight or four methylene units could form the ladder–PDAs by a two-step process, whereas the monomer containing two methylene units could only undergo one-step of 1,4-addition reaction. Further, it was found that the crystallinity of the polymers depends on the methylene chain length in the monomers, 4BCMU4A(8) being the most crystalline of all. These structural features strongly affect their absorption spectra. The third-order nonlinear optical susceptibilities (χ⁽³⁾) for these polymers were measured using third-harmonic generation method. The largest χ⁽³⁾ value obtained was 3.4 × 10⁻¹¹ esu for the poly[4BCMU4A(8)] thin film in resonant region. © 1999 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 37: 3537–3548, 1999