Formation and dielectric properties of anodic oxide films on Zr–Al alloys

Zr–Al alloys containing up to 26 at.% aluminum, prepared by magnetron sputtering, have been anodized in 0.1 mol dm⁻³ ammonium pentaborate electrolyte, and the structure and dielectric properties of the resultant anodic oxide films have been examined by grazing incidence X-ray diffraction, transmission electron microscopy, Rutherford backscattering spectroscopy, and AC impedance spectroscopy. The anodic oxide film formed on zirconium consists of monoclinic and tetragonal ZrO₂ with the former being a major phase. Two-layered anodic oxide films, comprising an outer thin amorphous layer and an inner main layer of crystalline tetragonal ZrO₂ phase, are formed on the Zr–Al alloys containing 5 to 16 at.% aluminum. Further increase in the aluminum content to 26 at.% results in the formation of amorphous oxide layer throughout the thickness. The anodic oxide films become thin with increasing aluminum content, while the relative permittivity of anodic oxide shows a maximum at the aluminum content of 11 at.%. Due to major contribution of permittivity enhancement, the maximum capacitance of the anodic oxide films is obtained on the Zr–11 at.% Al alloy, being 1.7 times than on zirconium at the formation voltage of 100 V.     

Fluorescence studies on phenylene moieties embedded in a framework of periodic mesoporous organosilica

The excited state characteristics of phenylene (Ph)-bridged periodic mesoporous organosilica (PMO) powders with crystal-like and amorphous wall structures are investigated. Crystal-like Ph-PMO has a molecular ordering of the bridging organic moieties with intervals of 0.76 and 0.44 nm parallel and perpendicular to the mesochannel direction, respectively, whereas amorphous Ph-PMO has no molecular-level periodicity in the wall. Fluorescence from the exciton and excimer of the Ph moieties and the defect center in the silicate network were detected at room temperature, but fluorescence from the excimer and the defect center were not detected at 77 K for crystal-like Ph-PMO dispersed in a methanol/ethanol mixed solvent. The decay curve of the exciton fluorescence of crystal-like Ph-PMO at room temperature was analyzed successfully using a one-dimensional diffusion model quenched by the defect center and the excimer site. The results were discussed in comparison with those for the crystal-like biphenylene-bridged PMO reported in the preceding paper (Yamanaka et al., Phys. Chem. Chem. Phys., 2010, 12, 11688-11696). The existence of excited states with various conformations including ground state dimers or aggregates of the Ph moieties was suggested for amorphous Ph-PMO. It was clearly apparent that the differences in the excited state dynamics reflected the differences in the molecular-level structure in the wall.     

A Semiconductor Waveguide-Type Optical Frequency Shifter

A waveguide-type optical frequency shifter based on a rotating half-wave plate is proposed. The underlying principle can be used to realize a bit-rate-free and modulation-code-free optical frequency shifter. The waveguide was formed along the ≪1 1 1> direction on a GaAs (1 1 0) substrate by molecular beam epitaxy (MBE) and reactive ion beam etching (RIBE). A 10-MHz optical frequency shift with 16 V_p-p applied voltage and 22.5% shift efficiency is demonstrated.     

Thermosensitive polyalcohols: Synthesis via living cationic polymerization of vinyl ethers with a silyloxy group

Thermosensitive homopolymers and copolymers with hydroxy groups were synthesized via the living cationic polymerization of Si‐containing vinyl ethers. The cationic homopolymerization and copolymerization of five vinyl ethers with silyloxy groups, each with a different spacer length, were examined with a cationogen/Et_1.5AlCl_1.5 initiating system in the presence of an added base. When an appropriate base was added, the living cationic polymerization of Si‐containing monomers became feasible, giving polymers with narrow molecular weight distributions and various block copolymers. Subsequent desilylation gave well‐defined polyalcohols, in both water‐soluble and water‐insoluble forms. One of these polyalcohols, poly(4‐hydroxybutyl vinyl ether), underwent lower‐critical‐solution‐temperature‐type thermally induced phase separation in water at a critical temperature (T_PS) of 42 °C. This phase separation was quite sensitive and reversible on heating and cooling. The phase separation also occurred sensitively with random copolymers of thermosensitive and hydrophilic or hydrophobic units, the T_PS values of which in water could be controlled by the monomer feed ratio. The thermal responsiveness of this polyalcohol unit made it possible to prepare novel thermosensitive block and random copolymers consisting solely of alcohol units. One example prepared in this study was a 20 wt % aqueous solution of a diblock copolymer consisting of thermosensitive poly(4‐hydroxybutyl vinyl ether) and water‐soluble poly(2‐hydroxyethyl vinyl ether) segments, which transformed into a physical gel above 42 °C. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 3300–3312, 2003     

Nanoparticles in Emissions and Atmospheric Environment: Now and Future

Journal of Nanoparticle Research -     

A generating function of higher-dimensional Apostol-Zagier sums and its reciprocity law

We introduce higher-dimensional Dedekind sums with a complex parameter z, generalizing Zagier's higher-dimensional Dedekind sums. The sums tend to Zagier's higher-dimensional Dedekind sums as z→∞. We show that the sums turn out to be generating functions of higher-dimensional Apostol-Zagier sums which are defined to be hybrids of Apostol's sums and Zagier's sums. We prove reciprocity law for the sums. The new reciprocity law includes reciprocity formulas for both Apostol and Zagier's sums as its special case. Furthermore, as its application we obtain relations between special values of Hurwitz zeta function and Bernoulli numbers, as well as new trigonometric identities.