Sensing lymphoma cells based on a cell-penetrating/apoptosis-inducing/electron-transfer peptide probe

To electrochemically sense lymphoma cells (U937), we fabricated a multifunctional peptide probe that consists of cell-penetrating/apoptosis-inducing/electron-transfer peptides. Electron-transfer peptides derive from cysteine residue combined with the C-terminals of four tyrosine residues (Y₄). A peptide whereby Y₄C is bound to the C-terminals of protegrin 1 (RGGRLCYCRRRFCVCVGR-NH₂) is known to be an apoptosis-inducing agent against U937 cells, and is referred to as a peptide-1 probe. An oxidation response of the peptide-1 probe has been observed due to a phenolic hydroxyl group, and this response is decreased by the uptake of the peptide probe into the cells. To improve the cell membrane permeability against U937 cells, the RGGR at the N-terminals of the peptide-1 probe was replaced by RRRR (peptide-2 probe). In contrast, RNRCKGTDVQAWY₄C (peptide-3 probe), which recognizes ovalbumin, was constructed as a control. Compared with the other probes, the change in the peak current of the peptide-2 probe was the greatest at low concentrations and occurred in a short amount of time. Therefore, the cell membrane permeability of the peptide-2 probe was increased based on the arginine residues and the apoptosis-inducing peptides. The peak current was linear and ranged from 100 to 1000 cells/ml. The relative standard deviation of 600 cells/ml was 5.0% (n = 5). Furthermore, the membrane permeability of the peptide probes was confirmed using fluorescent dye.     

Pulsed-field ionization electron spectroscopy and conformation of copper-diammonia

Copper-diammonia, Cu(NH3)2, and its deuterated species, Cu(ND3)2, are produced in supersonic molecular beams and studied by pulsed-field ionization zero electron kinetic energy photoelectron spectroscopy and ab initio calculations. Structural isomers with a copper atom binding to an ammonia dimer or two ammonia molecules are obtained by the calculations. By comparing the experimental measurements to the theoretical calculations, the neutral and ionic forms of copper-diammonia are determined to be in a doubly bound linear conformation in their ground electronic states. The adiabatic ionization potentials of Cu(NH3)2 and Cu(ND3)2 are measured as 29,532 (5) and 29,313 (5) cm(-1), respectively. The metal-ligand symmetric stretching frequencies are measured to be 436 cm(-1) for Cu+-(NH3)2 and 398 cm(-1) for Cu+-(ND3)2, and the metal-ligand bending frequencies 75,139 cm(-1) for CuCu+-(NH3)2 and 70125 cm(-1) for CuCu+-(ND3)2. Moreover, the dissociation energy of Cu(NH3)2-->CuNH3+NH3 is determined to be 11(3) kcal mol(-1) through a thermodynamic relationship.     

Pentamethylcyclopentadienylrhodium(III) and -iridium(III) Complexes Showing P,O Coordination: Unprecedented Insertion of tcne and tcnq into a C−H Bond

Strongly electron withdrawing cyanoolefins tetracyanoethylene (tcne) and 7,7,8,8-tetracyano-p-quinodimethane (tcnq) react with [(η⁵-C₅Me₅)MCl(MDMPP-P,O)] (M=Rh, Ir; MDMPP-P,O=PPh₂(2-O-6-MeO-C₆H₃), a P,O chelating phosphane) by insertion into the C−H bond adjacent to the M−O σ bond. The crystal structure of the iridium complex formed upon insertion of tcne is shown.     

Synthesis and thermal properties of cellulose-based polycaprolactones

Cellulose-based polycaprolactone (CAPCL) sheets were prepared from cellulose acetate (CA) and ϵ-caprolactone (CL). Thermal properties of the obtained CAPCL's were studied by differential scanning calorimetry (DSC), thermogravimetry (TG) and TG-Fourier transform infrared spectrometry (TG-FTIR). The glass transition temperatures (T_g 's) of CAPCL decreased with increasing CL/OH ratio, until CL/OH ratio reached 15 and then increased above that ratio. Melting of CAPCL was observed when CL/OH ratio was over 10. The thermal degradation temperatures (T_d 's) of CAPCL increased from ca. 350 °C to 390 °C with increasing CL/OH ratio. The results obtained by TG-FTIR analysis of CAPCL showed that gases with OH, CH, C=O, C-O-C groups evolved by thermal degradation.     

Synthesis, structure, and reactivity of novel 3,4-diphosphacyclobutenes bearing silyl groups

[reaction: see text] Copper-mediated homocoupling of sterically hindered 2-(2,4,6-tri-tert-butylphenyl)-1-trialkylsilyl-2-phosphaethenyllithiums afforded 1,2-bis(trialkylsilyl)-3,4-diphosphacyclobutenes (1,2-dihydrodiphosphetenes) through a formal electrocyclic [2+2] cyclization in the P=C-C=P skeleton as well as 2-trimethylsilyl-1,4-diphosphabuta-1,3-diene. Reduction of 1,2-bis(trimethylsilyl)-3,4-diphosphacyclobutenes followed by quenching with electrophiles afforded ring-opened products, (E)-1,2-bis(phosphino)-1,2-bis(trimethylsilyl)ethene and (Z)-2,3-bis(trimethylsilyl)-1,4-diphosphabut-1-ene. The structures of the ring-opened products indicated E/Z isomerization around the C=C bond after P-P bond cleavage of 5, and the isomerization of the P-C=C skeleton. Ring opening of 1,2-bis(trimethylsilyl)-3,4-diphosphacyclobutenes affording (E,E)- and (Z,Z)-1,4-diphosphabuta-1,3-dienes was observed upon desilylation.     

Protonation-induced structural change of lyotropic liquid crystals in oley- and alkyldimethylamine oxides/water systems

Lyotropic phase behavior of the nonionic and the half-ionized oleyldimethylamine oxide (OlDMAO)/water systems was investigated using polarized light microscopy, small-angle X-ray diffraction, and differential scanning calorimetry. Nonionic OlDMAO formed isotropic micellar solution, nematic, hexagonal, cubic, and lamellar liquid crystalline phases as the surfactant concentration increased. In contrast, half-ionized OlDMAO (i.e., 1:1 mixture of the nonionic and the protonated species) had a greater tendency to form bilayer structures, and the phase diagram became quite similar to those of double-chained ionic surfactants rather than single-chained ones, despite the introduction of positive charges to the nonionic one. The preference of the bilayer structures in the half-ionized OlDMAO was interpreted in terms of the dimers stabilized by the hydrogen bond between the nonionic and protonated species. For alkyldimethylamine oxides with a saturated hydrocarbon chain (CnDMAO, chain length: n = 14, 16, and 18), the phase sequence of lyotropic liquid crystals was hardly affected by the protonation, but an elongation of the cylinders of the hexagonal phase was observed for the half-ionized C14DMAO. Consequently, it can be considered that the dominant bilayer formation of the half-ionized OlDMAO is attributed to the combined effect of the hydrogen-bonded dimer formation and the cis-double-bond configuration of the alkyl chain.     

Cyclic esters of aliphatic diacids with pyrocatechol and hydroquinone

Cyclic esters of adipic acid, suberic acid and sebacic acid were prepared by reaction of the acid dichlorides and pyrocatechol or hydroquinone in benzene under high dilution conditions. While only the cyclic dimers could be obtained from hydroquinone, pyrocatechol formed cyclic monomers as well as cyclic dimers (and also a cyclic dimer with succinic acid). The structure of all compounds was confirmed by¹H-NMR- and mass spectra. The crystal structures of the pyrocatechol esters were determined by single crystal X-ray analysis.

---

Cyclische Ester aliphatischer Dicarbonsäuren mit Brenzcatechin und Hydrochinon

Zusammenfassung Es wurden cyclische Ester von Adipinsäure, Korksäure und Sebacinsäure durch Reaktion der entsprechenden Säure-Dichloride mit Brenzcatechin oder Hydrochinon bei hoher Verdünnung hergestellt. Während mit Hydrochinon lediglich die cyclischen Dimeren erhalten werden konnten, wurden mit Brenzcatechin sowohl cyclische Monomere als auch cyclische Dimere erhalten (ebenfalls das cyclische Dimer mit Bernsteinsäure). Die Strukturen wurden mittels¹H-NMR und Massenspektren gesichert. Die Kristallstrukturen der Brenzcatechin-Ester wurden mittels Röntgenstrukturanalyse bestimmt.

     

Adduct formation properties of mono- and bidentate phosphine oxide compounds in the liquid—liquid extraction of some divalent metals with 1-phenyl-3-methyl-4-benzoyl-5-pyrazolone

The bidentate phosphine oxide compounds bis(diphenylphosphinyl)methane (BDPPM) and bis(diphenylphosphinyl)ethane (BDPPE) were synthesized and the liquid—liquid extraction equilibria of some divalent metal ions such as Co(II), Ni(II), Zn(II) and Cd(II) with 1-phenyl-3-methyl-4-benzoyl-5-pyrazolone (HPMBP) and the neutral phosphine oxide compounds were investigated. BDPPM was found to be much more powerful than BDPPE and the monodentate neutral ligand trioctylphosphine oxide (TOPO). The composition of the extracted species were determined by a graphical method to be M(PMBP)₂(TOPO)_s (s = 2 for Co, Ni, Cd and s = 1 for Zn), M(PMBP)₂(BDPPM) and M(PMBP)₂(BDPPE). The adduct formation constants between the acylpyrazolone chelates and the neutral ligands were determined and are discussed in terms of the molecular structure.     

Unified interpretation of exciplex formation and marcus electron transfer on the basis of two-dimensional free energy surfaces

The mechanism of exciplex formation proposed in a previous paper has been refined to show how exciplex formation and Marcus electron transfer (ET) in fluorescence quenching are related to each other. This was done by making simple calculations of the free energies of the initial (DA*) and final (D+A-) states of ET. First it was shown that the decrease in D-A distance can induce intermolecular ET even in nonpolar solvents where solvent orientational polarization is absent, and that it leads to exciplex formation. This is consistent with experimental results that exciplex is most often observed in nonpolar solvents. The calculation was then extended to ET in polar solvents where the free energies are functions of both D-A distance and solvent orientational polarization. This enabled us to discuss both exciplex formation and Marcus ET in the same D-A pair and solvent on the basis of 2-dimensional free energy surfaces. The surfaces contain more information about the rates of these reactions, the mechanism of fluorescence quenching by ET, etc., than simple reaction schemes. By changing the parameters such as the free energy change of reaction, solvent dielectric constants, etc., one can construct the free energy surfaces for various systems. The effects of free energy change of reaction and of solvent polarity on the mechanism and relative importance of exciplex formation and Marcus ET in fluorescence quenching can be well explained. The free energy surface will also be useful for discussion of other phenomena related to ET reactions.