有机硅耐磨透明涂层的固化分析

ＦＴＩＲ、ＴＧ、ＴＢＡ等对有机硅耐磨涂料（有机硅溶胶）的热固化过程研究表明有机硅胶体中缔合羟基间的脱水缩合速率很高；羟基脱水程度与固化温度有关，温度越高，达平衡时羟基的浓度越低，在１０５～１３０℃间羟基的浓度变化最大，加入适当的固化剂，对羟基的脱水交联有促进作用，在较高的固化温度下，反应体系中出现了环氧环异构化产生的酮羰基的吸收峰     

测接触角法确定偶联剂的最佳用量

偶联剂是一类能在无机填料和聚合物基材之间形成“分子桥”、改善两者之间相容性或提高两者之间相互作用能力的化合物。将经偶联剂改性的无机填料填充到聚合物中可以制得成本低、性能好的复合材料。由于偶联剂用量多少将对复合材料的性能产生较大影响,因此建立一种准确、简便地确定偶联剂最佳用量的方法有着十分重要的理论和实际应用意义。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Modified modeling of the effect of pH and viscosity on the mass transfer in hydrophobic hollow fiber membrane contactors

This paper studied the effect of pH and the viscosity of feed solution on the mass transfer in two different specifications of hydrophobic hollow fiber membrane contactors. Experimental results showed that the pH of the feed had a significant effect on the rate of mass transfer, the flux and the removal efficiency of easily ionized volatile compounds (VCs), such as ammonia. In unbuffered feed solutions, both the resistance of membrane and the resistance of feed side were affected by the pH of feed and both of them had contributions to the overall mass transfer. A model, , was proposed to predict the effect of pH and gave good agreement with the experimental data for the two contactors. The relationship between viscosities and the mass transfer coefficient could be described by . Based on our experiments, the change of the viscosities in the concentration range of ammonia from 50 to 10,000 mg l⁻¹ caused about 3–4% variation of the mass transfer coefficients. Moreover, it may be more suitable to use the equilibrium concentrations of volatile species instead of the total concentrations of VCs to estimate mass transfer coefficients, removal efficiency and flux. Experimental results also revealed that the choice of the pH of feed might be one of the most crucial factors for removing easily ionized VCs, such as ammonia, from water and wastewater.     

High-efficiency, environment-friendly electroluminescent polymers with stable high work function metal as a cathode: green- and yellow-emitting conjugated polyfluorene polyelectrolytes and their neutral precursors

A series of aminoalkyl-substituted polyfluorene copolymers with benzothiadiazole (BTDZ) of different content were synthesized by Suzuki coupling reaction, and their quaternized ammonium polyelectrolyte derivatives were obtained through a postpolymerization treatment on the terminal amino groups. Copolymers are soluble in environmentally friendlier solvents, such as alcohols. It was found that the efficient energy transfer occurs by exciton trapping on the narrow band gap BTDZ site under UV illumination. Only 1% of BTDZ content is needed to completely quench a fluorene emission for both the neutral and the quaternized copolymers in the neat film. Absolute PL efficiencies of copolymer films were greatly enhanced as a result of the suppression of excimer formation. Light-emitting devices fabricated from these copolymers show high external quantum efficiencies over 3% and 1% for the neutral precursor and the quaternized copolymers, respectively, with high work function metals such as Al as a cathode. To the best of our knowledge, this is the first report on an electroluminescent polymer which bears the high EL efficiency, the electron-injection ability from high work function metals, and the solubility in environment-friendly solvents at the same time. These features make them a promising candidate for the next generation of light-emitting copolymers in PLED flat panel display application.     

Determination of acetone, hexanal and heptanal in blood samples by derivatization with pentafluorobenzyl hydroxylamine followed by headspace single-drop microextraction and gas chromatography–mass spectrometry

In the study, we developed a simple, rapid, sensitive, and inexpensive method for determination of the disease biomarkers of acetone, hexanal and heptanal in human blood. For the first time, derivatization of carbonyls with O-2,3,4,5,6-(pentafluorobenzyl)hydroxylamine (PFBHA) was combined with headspace single-drop microextractin (HS-SDME) and gas chromatography-mass spectrometry (GC–MS) and applied to the analysis of acetone, hexanal, and heptanal in human blood. At first, acetone, hexanal and heptanal in blood were derivatized with PFBHA and formed oximes in several seconds. Sequentially, the oximes were headspace extracted and concentrated by a microdrop solvent. Finally, the extracted oximes were analyzed by GC–MS. HS-SDME conditions and method validations were studied. Due to needing of only 2 μl organic solvent, short extraction time of 8 min, and simple operation, derivatization-HS-SDME was shown to be a rapid, simple, and inexpensive technique for analysis of acetone, hexanal, and heptanal in human blood. Moreover, it had low detection limit values from 0.24 to 0.62 nM, and good reproducibility (R.S.D. less than 12%).     

从头计算方法比较TiSi_2的C54相和C49相

采用平面波超软赝势描述多电子体系,利用密度泛函理论和广义梯度近似,计算出C54相和C49相TiSi2的晶格常数、体弹性模量、形成能、电子态密度(DOS)和Mulliken电荷布居等性质.通过比较这两种物质的性质,发现尽管两者形成能很相近,但C49相结构对称性差、体弹性模量小、熔点低,Ti原子d轨道的反键强、离子性弱.这些性质上的差异和C49相TiSi2在固相反应中优先形成有关.     

Nanoporous TiO2 Coatings for Infrared Detectors

In GaAs based infrared detectors, a considerable part of the incident light will be reflected at the surface, thus it decreases the detectors sensitivity considerably. In this paper, a TiO₂ nanoporous coating was prepared successfully on the GaAs substrate by sol-gel method. The optical parameters of the coating were also controlled successfully. It was proved that the coating could greatly improve the transmittance of the incident light, which agrees with the theoretical results quite well. In the 2.5–6.0 m waveband, the maximum transmittance of GaAs substrate is 56%, while the transmittance of the GaAs substrate coated with a nanostructured TiO₂ coating is about 94%.     

Infrared study of co adsorbed species on ru/silicalite catalyst

Carbon monoxide adsorbed species on Ru/silicalite and their reactivity towards oxygen have been studied using in situ diffuse reflectance infrared spectroscopy (DRIFT). Four species were detected: a bridge bonded CO on metallic Ru (1980 cm ^-1), a linearly adsorbed CO on metallic Ru (2040 cm^-1), a linearly adsorbed CO on partially oxidized Ru (2081 cm^-1), and a multicarbonyl on oxidized Ru (2081 and 2133 cm^-1). Among the four CO species the most strongly held species was the bridge bonded CO on metallic Ru while the multicarbonyl was the most weakly held species. These four species have different reactivities towards oxygen. Only the linearly adsorbed CO on metallic Ru can be oxidized at room temperature.     

香蕉组织膜草酸电极的研究

将香焦组织与氧电极偶合,制成了草酸生物组织电极。在静态和流动条件下,测得电极的线性响应范围分别为8.8×10~(-5)～6.3×10~(-4)mol/L和5.0×10~(-5)～1.8×10~(-3)mol/L,二者的相关系数均为0.9998。研究了介质条件、pH、温度、流速、取样量和固定化等条件的影响。测定了电极的选择性和使用寿命等性能。计算了该实验条件下酶反应的米氏常数。采用静态法和流动注射法测得7份草酸标液的平均回收率分别为98.4％和98.9％。电极已用于一些食品中草酸的测定,所得结果与文献报道基本一致。