Effect of heat-pretreatment of the graphite rod on the quality of SWCNTs by arc discharge

Single-walled carbon nanotubes (SWCNTs) have been synthesized in high yield by the dc arc discharge technique under heat-pretreatment of the graphite rod conditions. Before executing arc discharge, the graphite rods containing the catalysts were heat treated at 600, 700, 800 and 900 °C for 1–3 h, respectively. Effects of heat-pretreatment of the graphite rod on the quality of SWCNTs by arc discharge were investigated. The heat-treatment temperature and time were found to be crucial for a high yield of high-purity SWCNTs. Optimum parameter was found to be at the heat-treatment temperature of 800 °C for 2 h. The SWCNTs synthesized under the optimum condition have better field-emission characteristics. The turn-on field needed to produce a current density of 10 μA/cm² is found to be 1.9 V/μm and the threshold field where current density reaches 10 mA/cm² is 3.9 V/μm.     

A Millimeter Wave Phase Locked and Frequency Multiplying Source

A millimeter wave phase locked and frequency multiplying source is proposed in this paper. The design includes an X-band phase locked loop (PLL) frequency synthesizer as the base frequency source, and a monolithic millimeter wave frequency tripler, which is developed by using OMMIC 0.18μm pHEMT process. The PLL and the tripler are integrated in a single circuit board to make a low-cost and compact frequency source with the size of 6cm × 5cm. Measurement shows an output power of more than 4.8dBm at the frequency range from 35 to 36.7GHz. A phase noise of about -92dBc/Hz at 100kHz offset is achieved.     

食管癌患者指甲的红外光谱研究

利用傅里叶红外光谱对正常人,食管癌患者,食管癌术后5个月者的指甲进行了研究。发现他们指甲的红外光谱在频率,强度,峰形等方面均有差异。主要表现在:食管癌患者νs(PO2-)和νas(PO2-)的振动峰均向高波数偏移,术后者回落;癌患者蛋白质C—O基团峰强度增强,术后者峰强度有所减弱,但仍比正常人强;癌患者角蛋白脂质CH2和CH3伸缩振动峰波数有所下降。术后者介于癌患者与正常人之间;食管癌患者角蛋白脂质CH2和CH3弯曲振动峰稍向高波数偏移,术后者恢复至正常人水平;癌患者酰氨Ⅰ带和Ⅱ带都向低波数偏移,术后者介于两者之间。这些差异是应用红外光谱诊断食管癌的基础,表明FTIR光谱在食管癌的早期诊断和快速诊断方面有着十分美好的前景。     

不同厚度CdSe阱层的表面上自组织CdSe量子点的发光性质

利用变温和变激发功率分别研究了不同厚度CdSe阱层的自组织CdSe量子点的发光。稳态变温光谱表明:低温下CdSe量子阱有很强的发光,高温猝灭,而其表面上的量子点发光可持续到室温,原因归结于量子点的三维量子尺寸限制效应;变激发功率光谱表明:量子点激子发光是典型的自由激子发光,且在功率增加时。宽阱层表面上的CdSe量子点有明显的带填充效应。通过比较不同CdSe阱层厚度的样品的发光,发现其表面上量子点的发光差异较大,这可以归结为阱层厚度不同导致应变弛豫的程度不同,直接决定了所形成量子点的大小与空间分布^[1]。     

基于LPC2210和SSD1339的PM-OLED驱动控制电路

为了避免早期无源矩阵有机电致发光器件驱动控制电路的一些缺陷,如:"串扰"和"交叉"效应以及电路连接比较复杂,用两种方法实现了基于飞利浦公司生产的LPC2210控制芯片和晶门科技公司的SSD1339驱动芯片的驱动控制电路。首先介绍了有机电致发光器件的结构和发光原理以及芯片SSD1339和LPC2210的主要的特点;分析和比较了SSD1339的8080系列并行口和LPC2210外部存储控制单元的读写时序;分别利用LPC2210的通用输入输出单元和外部存储控制单元,成功的控制SSD1339驱动128RGB×128点阵有机电致发光屏。实验结果表明:两种方法不仅可以有效地克服早期驱动控制电路的缺陷,而且可以使有机电致发光屏显示出高质量的图片;用外部存储控制单元实现的驱动控制电路,可以实现约80 Hz的驱动帧频;而使用通用输入输出单元实现的驱动控制电路,可以单步跟踪数据的传输,因此它具有方便查错的优势。本次实验为在不同的集成环境下无源矩阵有机电致发光器件驱动控制电路的设计奠定基础。     

离子对rod-pinch二极管工作特性的影响

 利用PIC粒子模拟方法,结合对同轴结构二极管工作模式的半解析描述,研究了离子存在与否对rod-pinch二极管（RPD）工作特性的影响。模拟给出了二极管的伏安特性、不同时刻电子和离子的相空间分布以及空间电流分布等。结果表明随着电流逐渐增大,其工作模式从空间电荷限制流依次向弱箍缩流和磁绝缘流转变。只有存在离子的情况下,电子才能沿着阳极杆表面运动并在其末端发生箍缩,表明RPD中离子电流的存在对于RPD工作是必需的。     

太赫兹波光子晶体光纤传输特性分析

利用矢量有限元法分析了太赫兹波光子晶体光纤单模截止频率和波导色散随光纤结构的变化特性．结果表明，太赫兹波光子晶体光纤的单模截止频率随着光纤空气孔占空比的变大而降低，零波导色散点频率随着空气孔占空比变大而增加，约束损耗随着空气孔的圈数增加而降低．     

Optical properties of Dy ions in sodium gadolinium tungstates crystal

Dy³⁺-doped NaGd(WO₄)₂ crystal with sizes of about Φ20×40 mm² was grown by the Czochralski technique along the (0 0 1) orientation. Polarized absorption spectra, fluorescence spectra, and fluorescence decay curve of Dy³⁺-doped NaGd(WO₄)₂ have been recorded at room temperature. Based on the Judd-Ofelt (J-O) theory, the intensity parameters from the measured line strengths were evaluated. The J-O parameters were used to predict radiative transition probabilities, radiative lifetimes and branching ratios for various excited levels of Dy³⁺-doped NaGd(WO₄)₂ crystal. The luminescent quantum efficiency of the ⁴F_9/2 level was determined to be approximately 63% for this material. The emission cross-section of the ⁴F_9/2→⁶H_13/2 transition was estimated by using the Füchtbauer-Ladengurg method.     

Tm3+/Yb3+共掺氧卤碲酸盐玻璃上转换发光研究

研究了Tm3+/Yb3+共掺氧卤碲酸盐玻璃的上转换发光光谱,分析了TmO3量对Tm3+/Yb3+共掺氧卤碲酸盐玻璃上转换发光的影响机理.结果表明:在Tm3+/Yb3+共掺氧卤碲酸盐玻璃的上转换发光中,Tm3+存在较强的浓度猝灭效应.随Tm2O3含量增加,Tm3+的上转换蓝光和红光强度先增加,后降低,在0.1 mol% Tm2O3达到最大.该结果有助于进一步提高Tm3+的上转换发光效率.