Structure and reflective properties of Al-Cu-Fe quasicrystalline thin film prepared by laser induced arc method

Al-Cu-Fe thin films were prepared by laser induced arc (laser-arc) method from a single source—Al₆₃Cu₂₅Fe₁₂ alloy, which was proved to consist of quasicrystalline phase together with approximant phase. The composition of the deposited films meets the requirement for formation of icosahedral symmetry phase. Quasicrystalline phase was obtained after annealing the amorphous as-deposit film samples. The optical properties of the samples were investigated. Thin film samples of Al, Cu and Fe deposited under the same condition were employed for comparison. The results showed specific reflective properties of Al-Cu-Fe quasicrystal thin film in some wavelength range. The optical conductivity of the films exhibited a negative peak, centered about 440 nm in range of 190 to 800 nm. The Al-Cu-Fe quasicrystal thin films could absorb almost all the ray in the wavelength range from 420nm to 450 nm. The ratio of absorption was greater than 99%.     

Preparation,thermal properties,and flame retardance of epoxy–silica hybrid resins

A novel epoxy system was developed through the in situ curing of bisphenol A type epoxy and 4,4′‐diaminodiphenylmethane with the sol–gel reaction of a phosphorus‐containing trimethoxysilane (DOPO–GPTMS), which was prepared from the reaction of 9,10‐dihydro‐9‐oxa‐10‐phosphaphenanthrene‐10‐oxide (DOPO) with 3‐glycidoxypropyltrimethoxysilane (GPTMS). The preparation of DOPO–GPTMS was confirmed with Fourier transform infrared, ¹H and ³¹P NMR, and elemental analysis. The resulting organic–inorganic hybrid epoxy resins exhibited a high glass‐transition temperature (167 °C), good thermal stability over 320 °C, and a high limited oxygen index of 28.5. The synergism of phosphorus and silicon on flame retardance was observed. Moreover, the kinetics of the thermal oxidative degradation of the hybrid epoxy resins were studied. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2354–2367, 2003     

Hydroxyapatite coating on porous silicon substrate obtained by precipitation process

Hydroxyapatite Ca₁₀(PO₄)₆(OH)₂ (HAP) is known as a bioactive and biocompatible material, HAP coatings were used to improve the biocompatible of substrate by many researcher, In this work, HAP thin films on porous silicon (PS) substrates have been prepared by aqueous precipitation method with rapid thermal annealing (RTA) processes. The HAP films had been prepared under the annealing temperature ranging from 300 to 1000 °C. By the measurement of X-ray diffraction (XRD), it was found that for the crystallinity optimization, the heat-treatment at 850–950 °C for 1 h would be favorable. Atomic force microscopy (AFM) and scanning electron microscope (SEM) measurements reveal a dense and smooth surface of the HAP film, and tightly adherence of the coating on porous silicon substrate after sintered. Thus, by this method, porous silicon could be increased its bioactivity and so that could be used in the biomedical area.     

Bahadur efficiency and robustness of studentized score tests

We derive the exact Bahadur slopes of studentized score tests for a simple null hypothesis in a one-parameter family of distributions. The Student's t-test is included as a special case for which a recent result of Rukhin (1993, Sankhy Ser. A, 55, 159–163) was improved upon. It is shown that locally optimal Bahadur efficiency for one-sample location models with a known or estimated scale parameter is attained within the class of studentized score tests. The studentized test has an asymptotic null distribution free of the scale parameter, and the optimality of likelihood scores does not depend on the existence of a moment generating function. We also consider the influence function and breakdown point of such tests as part of our robustness investigation. The influence of any studentized score test is bounded from above, indicating certain degree of robustness of validity, but a bounded score function is needed to cap the influence from below and to ensure a high power breakdown point. We find that the standard Huber-type score tests are not only locally minimax in Bahadur efficiency, but also very competitive in global efficiency at a variety of location models.     

LC Determination of 4-Bromoaniline in Green Algae Chlamydomonas reinhardtii After Continuous-Flow Microextraction

In this study, the determination of 4-Bromoaniline (4-BA) in green algae Chlamydomonas reinhardtii (C. reinhardtii) was investigated by applying continuous-flow microextraction (CFME) combined with high-performance liquid chromatography (HPLC). Continuous-flow microextraction was conducted in a homemade glass chamber, i.e. the sample solution flowed through a constant volume drop of solvent in the chamber at a constant flow rate. The effects of different factors on extraction efficiencies were also investigated and these factors included the kind of extraction solvent, solvent drop volume, sample flow rate, extraction time and addition amount of salt. Under the optimum extraction conditions (extraction solvent, carbon tetrachloride; solvent drop volume, 3.5 μL; sample flow rate, 1.0 mL min⁻¹; extraction time, 10 min; no addition of salt), the calibration plot was set up by plotting peak area against a series of 4-Bromoaniline concentrations (0.01–10 μg mL⁻¹) in aqueous solution. The correlation coefficient (r) was 0.9990. The limit of detection (LOD) was 0.6 ng mL⁻¹. The precision of this method was obtained by successive five time analyses of 100-ng mL⁻¹ standard solution of 4-Bromoaniline, and the relative standard deviation (RSD) was 3.5%. The concentration factor was calculated by the ratio of peak area of the analyte obtained after and before extraction and found to be 10.6. 4-Bromoaniline residues in Chlamydomonas. reinhardtii cells and tap water samples were satisfactorily analyzed according to the method described above.     

An immune algorithm for resolution of multicomponent overlapping chromatograms

A novel immune algorithm for resolution and quantitative determination of the components in overlapping chromatograms was proposed by imitating biological immune systems. The algorithm takes an overlapping chromatogram as its input and subtracts the chromatograms of standard samples from the input by iteration of a network. When the residual does not change, the network will converge and chromatographic information of the components in overlapping chromatogram will be obtained. Both simulated and experimental data sets were investigated by the method. Results showed that both resolved results and recoveries of quantitative determination are satisfactory. Comparing with conventional least-square method, the immune algorithm is fast in calculation.     

Optical properties of ZnO and ZnO:In nanorods assembled by sol-gel method

Self-assembled zinc oxide (ZnO) and indium-doping zinc oxide (ZnO:In) nanorod thin films were synthesized on quartz substrates without catalyst in aqueous solution by sol-gel method. The samples were characterized by x-ray diffraction (XRD), scanning electron microscope (SEM), Raman-scattering spectroscopy, room-temperature photoluminescence (PL) spectra, and temperature-dependent PL spectra measurements. XRD and Raman spectra illustrated that there were no single In2O3 phase in ZnO lattice after indium doping. The PL spectra of ZnO showed a strong UV emission band located at 394 nm and a very weak visible emission associated with deep-level defects. Indium incorporation induced the shift of optical band gap, quenching of the near-band-edge photoluminescence and enhanced LO mode multiphonon resonant Raman scattering in ZnO crystals at different temperatures. Abnormal temperature dependence of UV emission integrated intensity of ZnO and ZnO:In samples is observed. The local state emission peak of ZnO:In samples at 3.37 eV is observed in low-temperature PL spectra. The near-band-edge emission peak at room temperature was a mixture of excitons and impurity-related transitions for both of two samples.     

On-line Separation and Detection of Peptides by Capillary Electrophoresis / Electrospray FT-ICR-MS

Recently, capillary electrophoresis/electrospray ionization mass spectrometry (CE/ESI- MS) has been rapidly developed as a powerful analytical tool for charged species ranged from small molecules such as carboxylic acids1, phenolic compounds2, metal species3, tetramines4, herbicides5, drugs and drug metabolites6 to peptides and proteins7, 8. The ESI mode has proven to be sensitive, versatile and relatively easy to use in combination with CE. CE confers rapid analysis and efficient separ…     

On a lemma of Butzer and Kirschfink

In [1], Butzer and Kirschfink discussed the convergence rates for C[0,1]-valued dependent random functions on Donsker's weak invariance principle and introduced the concept of dependency from below to deal with the martingale difference sequence. They asserted in their Lemma 8 that Lemma A. A martingale difference sequence (X_n,F_n,n≥1) with is dependent from below, i.e., for each 1≤i≤n and each n≥1 . The purpose of this note is to prove that Lemma A is not always true and to improve the conditions of Butzer and Kirschfink. We shall apply the notations in [1].