The Effect of Alkane Chain Length on the Liquid–Liquid Critical Temperatures of Oligostyrene/Linear-Alkane Mixtures

Summary. Upper critical solution temperatures (UCSTs) for liquid–liquid demixing in a set of mixtures of linear alkanes (pentane (N ₁=5) to pentacontane (N ₁=50)) with an oligostyrene (1241amu, N ₂=12) are reported. We find strong correlation between the Hildebrand solubility parameters of the alkanes and the UCST. Correlations are developed which enable predictions concerning the miscibility of mixtures of compounds with longer chains.     

Low oxidation state ruthenium chemistry : IV. The reactions of M(CO)2(PPh3)3 complexes (M = Fe,Ru) and the hydrogenation and isomerization of alkenes catalyzed by RuL(CO)2(PPh3)2 (L = H2, PPh3)

The complexes M(CO)₂(PPh₃)₃ (I, M = Fe; II, M = Ru) readily react with H₂ at room temperature and atmospheric pressure to give cis-M(H)₂(CO)₂(PPh₃)₂ (III, M = Fe;IV,M = Ru). I reacts with O₂ to give an unstable compound in solution, in a type of reaction known to occur with II which leads to cis-Ru(O₂)(CO)₂(PPh₃)₂(V). Even compound IV reacts with O₂ to give V with displacement of H₂; this reaction has been shown to be reversible and this is the first case where the displacement of H₂ by O₂ and that of O₂ by H₂ at a metal center has been observed. III and IV are reduced to M(CO)₃(PPh₃)₂ by CO with displacement of H₂; Ru(CO)₃- (PPh₃)₂ is also formed by treatment of IV with CO₂, but under higher pressure. Compounds II and IV react with CH₂CHCN to give Ru(CH₂CHCN)(CO)₂- (PPh₃)₂(VI) which reacts with H₂ to reform the hydride IV.cis-Ru(H)₂(CO)₂(PPh₃)₂(IV) has been studied as catalyst in the hydrogenation and isomerization of a series of monoenes and dienes. The catalysts are poisoned by the presence of free triphenylphosphine. On the other hand the ready exchange of H₂ and O₂ on the “Ru(CO)₂(PPh₃)₂” moiety makes IV a catalyst not irreversibly poisoned by the presence of air. It has been found that even Ru(CO)₂(PPh₃)₃(II) acts as a catalyst for the isomerization of hex-1-ene at room temperature under an inert atmosphere.     

Experiments in Solving Mixed Integer Programming Problems on a Small Array of Transputers

The time-consuming process of solving large-scale Mixed Integer Programming problems using the branch-and-bound technique can be speeded up by introducing a degree of parallelism into the basic algorithm. This paper describes the development and implementation of a parallel branch-and-bound algorithm created by adapting a commercial MIP solver. Inherent in the design of this software are certain ad hoc methods, the use of which are necessary in the effective solution of real problems. The extent to which these ad hoc methods can successfully be transferred to a parallel environment, in this case an array of at most nine transputers, is discussed. Computational results on a variety of real integer programming problems are reported.     

Effect of film thickness on the electro-reduction of molecular oxygen on electropolymerized cobalt tetra-aminophthalocyanine films

We studied the electrocatalytic activity of cobalt tetra-aminophthalocyanine (CoTAPc) for the reduction of molecular oxygen (O₂) on adsorbed monomeric and on electropolymerized films of different thicknesses on glassy carbon (GC) electrode. The polymeric films, denoted poly-CoTAPc, were first characterized by electrochemical impedance spectroscopy and it appears that the types of phenomena revealed to be occurring depend less on the film thickness in basic than in acid media. For O₂ reduction, the results showed that poly-CoTAPc is more active than the monomeric CoTAPc adsorbed on GC. Indeed, rotating ring-disk electrode data showed that polymeric CoTAPc promotes the four-electron reduction of O₂ to water in parallel to a two-electron reduction to give peroxide. On monomeric and thin films of poly-CoTAPc, a two-electron reduction mechanism predominates. In basic media the activity increases very slightly with thickness, whereas in acid media this increase is more pronounced. This parallels the observed behavior revealed by electrochemical impedance spectroscopy.     

Sorption of uranium by non-living water hyacinth roots

Summary Many studies have shown that water hyacinth (Eichhornia crassipes) roots can be used to accumulate high concentrations of organic as well as inorganic pollutants. They are currently used to remediate aquatic environments and aqueous solutions. In the present study, sorption of uranium from aqueous solutions by using dried roots of water hyacinth has been investigated. The sorption of uranium was examined as a function of initial concentration, pH, weight of roots and contact time. Five different concentrations 20, 40, 60, 80, and 100 μg ^. ml^-1 were used. Sorption proves to be very rapid and depend on pH, weight of roots and concentration of uranium. Maximum sorption capacity of water hyacinth roots was 64,000 U⁶⁺ μg/g. The sorption of uranium by water hyacinth roots follows a Langmuir isotherm.     

Stabilization of γ‘ phase in Bi<Subscript>4</Subscript>V<Subscript>2-x</Subscript>Fe<Subscript>x</Subscript><Superscript>II</Superscript>O<Subscript>11-1.5x</Subscript> series

Summary This work reports the room-temperature stabilization of the Bi₄V_2-xFe_x^IIO_11-1.5x γ ‘ phase, a promising ionic conductive material that finds application in solid oxide fuel cell and oxygen sensor devices. The Fe(II) cation proved to be a better stabilizer than Fe(III), which was previously used, since a lower substitution degree of V⁵⁺ is needed for the former. Powder X-ray diffraction, Fourier-transform infrared spectroscopy and differential scanning calorimetry were used in these experiments.     

Trennung,Identifizierung und Bestimmung von Bactericiden auf der Basis von halogenierten Aromaten mittels Gas-Chromatographie

The separation of a mixture of 22 bactericides has been achieved by gas chromatography on columns with silicone rubber W-982 as stationary phase with temperatures between 100° and 300°C. The unchanged compounds as well as their silylation products have been used. The latter are more conveniently used especially for the quantitative determination. To be able to calculate the retention indices after Kovats gas chromatography has been performed isothermally at 180°C for the more volatile compounds and at 250°C for all other bactericides.The retention indices obtained under these conditions are tabulated together with the limits of detection.     

2-Amino-4-bromobutanoic Acid

(2S)- and (2R)-2-Amino-4-bromobutanoic acid were prepared starting from N-Boc-glutamic acid α tert-butyl ester. The double tert-butyl protection was necessary to prevent a partial racemisation during Barton’s radical decarboxylation used to transform the γ-carboxylic group into a bromide. This bromide reacted with different nitrogen, oxygen and sulphur nucleophiles to give nonnatural amino acids characterised by basic or heterocyclic side chains. The title compound was also used to prepare a conformationally constrained peptidomimetic.     

A molecular mechanics approach for analyzing tensile nonlinear deformation behavior of single-walled carbon nanotubes

In this paper, by capturing the atomic information and reflecting the behaviour governed by the nonlinear potential function, an analytical molecular mechanics approach is proposed. A constitutive relation for single-walled carbon nanotubes (SWCNT’s) is established to describe the nonlinear stress-strain curve of SWCNT’s and to predict both the elastic properties and breaking strain of SWCNT’s during tensile deformation. An analysis based on the virtual internal bond (VIB) model proposed by P. Zhang et al. is also presented for comparison. The results indicate that the proposed molecular mechanics approach is indeed an acceptable analytical method for analyzing the mechanical behavior of SWCNT’s. The project supported by the National Natural Science Foundation of China (10121202, 90305015 and 10328203), the Key Grant Project of Chinese Ministry of Education (0306) and the Research Grants Council of the Hong Kong Special Administrative Region, China (HKU 7195/04E).     

Preparation of nano-hydroxyapatite/poly(<Emphasis Type="SmallCaps">l</Emphasis>-lactide) biocomposite microspheres

Nano-hydroxyapatite (HA)/poly(l-lactide) (PLLA) composite microspheres with relatively uniform size distribution were prepared by a solid-in-oil-in-water (s/o/w) emusion solvent evaporation method. The encapsulation of the HA nanopaticles in microshperes was significantly improved by grafting PLLA on the surface of the HA nanoparticles (p-HA) during emulsion process. This procedure gave a possibility to obtain p-HA/PLLA composite microspheres with uniform morphology and the encapsulated p-HA nanoparticle loading reached up to 40 wt% (33 wt% of pure HA) in the p-HA/PLLA composite microspheres. The microstructure of composite microspheres from core-shell to single phase changed with the variation of p-HA to PLLA ratios. p-HA/PLLA composite microspheres with the diameter range of 2–3 μm were obtained. The entrapment efficiency of p-HA in microspheres could high up to 90 wt% and that of HA was only 13 wt%. Surface and bulk characterizations of the composite microspheres were performed by measurements such as wide angle X-ray diffraction (WAXD), thermal gravimetric analysis (TGA), environmental scanning electron microscope (ESEM) and transmission electron microscopy (TEM).