Extremely large binding energy of biexcitons in an organic-inorganic quantum-well material (C4H9NH3)2PbBr4

We have confirmed biexciton formation in an organic-inorganic hybrid quantum-well material (C₄H₉NH₃)₂PbBr₄ by photoluminescence and two-photon absorption measurements. The biexciton has extremely large binding energy, 60 meV, which to our knowledge is the largest value ever reported for a semiconductor. By analyzing the spectrum of biexciton luminescence, the biexciton gas temperature was found to be much higher than the bath temperature due to a higher local temperature arising from the large biexciton binding energy.     

A facile non-oxidative method for synthesizing 1,3-disubstituted pyrroles from pyrrolidine and aldehydes

Reactions of pyrrolidine with 2 equiv of aldehydes without any catalyst in a pressurized vessel at 140–200 °C yielded 1,3-disubstituted pyrroles. -Branched aldehydes gave fairly good yields of the corresponding products by this method, which provides a facile non-oxidative procedure for synthesizing 1,3-dialkylpyrroles from inexpensive pyrrolidine and aldehydes.     

Method of observation of low density interface states by means of X-ray photoelectron spectroscopy under bias and passivation by cyanide ions

X-ray photoelectron spectroscopy (XPS) measurements under bias can observe low density interface states for metal-oxide-semiconductor (MOS) diodes with low densities. This method can give energy distribution of interface states for ultrathin insulating layers for which electrical measurements cannot be performed due to a high density leakage current. During the XPS measurements, a bias voltage is applied to the rear semiconductor surface with respect to the ∼3 nm-thick front platinum layer connected to the ground, and the bias voltage changes the occupation of interface states. Charges accumulated in the interface states shift semiconductor core levels at the interface, and thus the analysis of the bias-induced shifts of the semiconductor core levels measured as a function of the bias voltage gives energy distribution of interface states. In the case of Si-based MOS diodes, the energy distribution and density of interface states strongly depend on the atomic density of silicon dioxide (SiO₂) layers and the interfacial roughness, respectively. All the observed interface state spectra possess peaked-structures, indicating that they are due to defect states. An interface state peak near the Si midgap is attributable to isolated Si dangling bonds at the interface, while those above and below the midgap to Si dangling bonds interacting weakly with Si or oxygen atoms in the SiO₂ layers. A method of the elimination of interface states and defect states in Si using cyanide solutions has been developed. The cyanide method simply involves the immersion of Si in KCN solutions. Due to the high Si-CN bond energy of ∼4.5 eV, the bonds are not ruptured at 800 °C and upon irradiation. The cyanide treatment results in the improvement of the electrical characteristics of MOS diodes and solar cells.     

Adsorption of fission products onto soils using a fission multitracer

The adsorption behavior of fission products to various soils was studied using a multitracer. The multitracer was prepared by neutron irradiation of ²³⁵U. Distribution coefficients of fission products were obtained for seventeen kinds of Japanese soils. It was found that zirconium, niobium, and rare earth elements show high distribution coefficients for all soil samples, however, elements like alkali metals show varied values.     

Antiparasitic agents produced by microorganisms

Microorganisms produce many useful antiparasitic agents. Antiparasitic activities and biochemical targets of antiprotozoal and anthelmintic antibiotics are reviewed. Antimalarial apicidin, thiolactomycin, fosmidomycin, and borrelidin, antitrypanosomal ascofuranone, and nematocidal emodepside, 2-deoxoparaherquamide A, and nafuredin are recently discovered antibiotics, and they have potential as useful drugs.     

Potential-dependent structure of the interfacial water on the gold electrode

Doubly tunable sum frequency generation (SFG) spectra demonstrate that the water molecules at gold/electrolyte interface change their orientation with applied potential. At negative potentials, water molecules in the double layer align with their oxygen atom pointing to the solution. As potential became positive to be close to the potential of zero charge (PZC), the SFG signal decreased, suggesting the OH groups of the water molecule are either in random orientation or parallel to the electrode. As potential became more positive than the PZC, the SFG signal increased again with the oxygen-up orientation as same as in the negative potential region, indicating that water molecules interact with the adsorbed sulfate anions. The peak position of the SFG spectra indicates a relatively disordered state of water molecules at the gold electrode surface, in contrast to the previously observed ice-like structure of water at electrolyte/oxide interfaces.     

Precise synthesis of porphyrin array scaffolding polyisocyanides

Aryl isocyanides bearing free‐base and metallo‐porphyrins were prepared and polymerized with a Pd–Pt μ‐ethynediyl complex as the initiator to give polymers with narrow polydispersity indices. The molecular weights of the resulting polymers were precisely controlled by the initial feed ratio of the porphyrin monomer to the initiator. The UV–VIS spectra suggested that the porphyrin pendants are regularly arranged to form stacked columns. Metallo‐porphyrin polymers were also prepared by reacting free‐base porphyrin polymers with metal salts. The successive reactions of free‐base and zinc‐porphyrin monomers resulted in the formation of diblock polymers. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 585–595, 2006     

Control of the bioluminescence starting time by inoculated cell density.

In this study, we attempted to control the timing of light-emission from bioluminescent bacteria, by changed cell numbers inoculated into medium. Luminous bacteria express bioluminescence when the number of cells reached a threshold. Inoculated cell density had an effect on the time of bioluminescence starting. Samples were prepared by varying cell density of inoculation. In the results, all the vials showed different luminescence profiles in the order of inoculated cell population.     

Seven novel seco-prezizaane-type sesquiterpenes from the pericarps of Illicium merrillianum

Seven new seco-prezizaane-type sesquiterpenes were isolated from the methanol extract of the pericarps of Illicium merrillianum. Their structures were elucidated as 3-deoxypseudoanisatin (1), 2beta-hydroxy-3,6-dedioxypseudoanisatin (2), 8alpha-hydroxy-10-deoxycyclomerrillianolide (3), 10beta-hydroxypseudoanisatin (4), 10beta-hydroxycyclopseudoanisatin (5), 1,6-dihydroxy-3-deoxyminwanensin (6), and 8-deoxymerrilliortholactone (7) by analyses of their spectroscopic data and chemical transformation. Compounds 4 and 5 as well as 6 and 7 coexist as a keto/acetal equilibrated mixture in methanol solution.