Determination of carbamazepine by chemiluminescence detection using chemically prepared tris(2,2'-bipyridine)ruthenium(III) as oxidant.

A new chemiluminescence method for the determination of carbamazepine (CBZ) has been developed. The method is based on the chemiluminescence produced in the reaction of tris(2,2'-bipyridine)ruthenium(III) and CBZ in an acidic medium. The chemiluminescence intensity was enhanced by organic solvents in the reaction system. Under the optimum experimental conditions, the calibration curve was linear over the range 4.0 x 10(-3)-8.6 x 10(-7) mol/L for CBZ. The detection limit (S/N = 3) was 2.5 x 10(-7) mol/L and the relative standard deviation of six replicate measurements was 2.6% for 4.0 x 10(-4) mol/L of CBZ. The possible reaction mechanism were also discussed. The chemiluminescence method was successfully applied to assay the CBZ contents in pharmaceutical tablets.     

Quantum Dynamics of Systems Connected by a Canonical Transformation

Quantum Hamiltonian systems corresponding to classical systems related by a general canonical transformation are considered. The differential equation to find the unitary operator, which corresponds to the canonical transformation and connects quantum states of the original and transformed systems, is obtained. The propagator associated with their wave functions is found by the unitary operator. Quantum systems related by a linear canonical point transformation are analyzed. The results are tested by finding the wave functions of the under-, critical-, and over-damped harmonic oscillator from the wave functions of the harmonic oscillator, free-particle system, and negative harmonic potential system, using the unitary operator to connect them, respectively.     

Investigation of the Li1+xV3O8 electrode–organic electrolyte interface by scanning photoelectron microscopy

To investigate the formation of a solid electrolyte interface (SEI) on the Li_1+xV₃O₈ electrode surface in the thermodynamic stability range of the organic electrolyte, we applied scanning photoelectron microscopy (SPEM) to a pristine electrode and to an electrode after ten cycles. The F K-edge absorption spectrum of the cycled electrode showed that LiF forms on the electrode surface during the lithium insertion–extraction process in the Li_1+xV₃O₈/Li cell. The photoelectron spectrum for the cycled electrode showed intense spectral features corresponding to Li 1s, F 2s, F 2p, and P 2p electron signals, whereas these spectral features were of negligible intensity for the pristine electrode. The above results give strong support for the formation of an SEI that consists of LiF and compounds containing phosphorus during operation of the battery. The SPEM images also revealed that the fluorine distribution on the surface of the cycled electrode was inhomogeneous.     

Synthesis and adsorption properties of gold nanoparticles within pores of surface‐functional porous polymer microspheres

Mesoporous polymer microspheres with gold (Au) nanoparticles inside their pores were prepared considering their surface functionality and porosity. The Au/polymer composite microspheres prepared were characterized by transmission electron microscope (TEM), X‐ray diffraction (XRD), and Brunauer–Emmett–Teller (BET) techniques. The results showed that the adsorption of Au nanoparticles could be increased by imparting the pore structure and surface‐functional groups into the supporting polymer microspheres (in this study, poly (ethylene glycol dimethacrylate‐co‐acrylonitrile) and poly (EGDMA‐co‐AN) system). Above all, from this study, it was established that the porosity of the polymer microspheres is the most important factor that determines the distribution and adsorption amount of face‐centered cubic (fcc) Au nanoparticles in the final products. Our study showed that the continuous adsorption of Au nanoparticles with the aid of the large surface area and surface interaction sites formed more favorably the Au/polymer composite microspheres. The BET measurements of Au/poly(EGDMA‐co‐AN) composite microspheres reveals that the adsorption of Au nanoparticles into the pores kept the pore structure intact and made it more porous. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5627–5635, 2004     

Analysis on plasma chemistry and particle growth in corona discharge process for NO/sub x/ removal using discrete-sectional method

The particle formation and growth combined with plasma chemistry in the pulsed corona discharge process (PCDP) to remove NO/sub x/ were analyzed by the discrete-sectional model. In the PCDP, most of the NO is converted into NO/sub 2/ and, later, into HNO/sub 3/ which reacts with NH/sub 3/ to form the NH/sub 4/NO/sub 3/ particle. In the beginning of the reactor, we have the high concentration of small size particles and, later, the particle size distribution in the reactor becomes bimodal with the large size and small size particles and, finally, becomes monodisperse with the large size particles. As the average electron concentration increases, it takes a shorter reactor length to remove the NO/sub x/. As the initial NO and H/sub 2/O concentrations decrease, the NH/sub 3/ is consumed more slowly to form the ammonium nitrates particles. As the averaged electron concentration and initial H/sub 2/O concentration increase, the large size particles grow more quickly and the particle size distribution becomes bimodal earlier. As the initial NO and NH/sub 3/ concentrations increase, the diameter of large size particles becomes larger by the faster coagulation between particles. The predicted NO/sub x/ conversion and particle size distribution were in close agreements with the published experimental results at the averaged electron concentration of 2/spl times/10/sup 5/ cm/sup -3/ in this study.     

The effect of olefinic terminal chains on the mesomorphic properties of 4,4'-disubstituted diphenyldiacetylenes

New diphenyldiacetylenes of the type with A, B = H and/or F; m = 0, 1; n = 1-4; and X = C n H 2n + 1 , F, CF 3 or CN were synthesized and their mesomorphic properties determined by hot stage polarizing microscopy and DSC. When m = 0, all of these compounds showed only a nematic phase except when X = CF 3 when both nematic and smectic A phases were seen. Both clearing and melting temperatures were higher than those reported for substitution with the corresponding alkyl chains but the much larger increase in clearing temperatures produced considerably wider nematic phases. Eutectic mixtures of a few of these olefins yielded nematic materials also having much wider temperature ranges and higher clearing temperatures than the eutectic mixtures of the alkyl compounds, while retaining their high birefringence and low viscosities. Such materials are of interest for beam-steering devices.

Four of the diacetylenes with m = 1 ( A, B = H) were also prepared ( X = C 6 H 13 , F, n = 2, 3). When X was C 6 H 13 ( n = 2), the nematic range was smaller in the 2- than in the 1-olefin but wider than in the alkyl series. When X = F, either no nematic phase or a monotropic one was observed, whereas the 1-olefins gave a much wider nematic phase. Both transition temperatures were lower than those for the corresponding 1-olefin and alkyl analogues. The compound with X = C 6 H 13 and n = 2 had a melting temperature below room temperature.     

Game theoretic analysis of the bargaining process over a long-term replenishment contract

This paper presents supplier–buyer models to describe the bargaining process between a supplier and a buyer over a long-term replenishment contract. Two different models are developed: one for the situation where the supplier has superior bargaining power over the buyer, and the other for the reverse situation. For each model, a method is derived that employs game theory-based analysis to determine the best strategy for each agent. A computational experiment is conducted to estimate the efficiency of the methods and to determine the economic implications of the results. The result indicates that each algorithm is very efficient compared to other strategies. We also verify that the solutions derived from each model are Nash equilibrium. Significantly improved outcomes are obtained for both agents by agreeing to the terms generated by the algorithms over the terms selected in the usual manner.     

Preparation of enantiomerically pure (R)-2-butyryloxymethylglycidol by lipase-catalyzed asymmetric hydrolysis

Optically active epoxy alcohol, (R)-2-butyryloxymethylglycidol3 which is the precursor of a tert-alcohol chiral building block was obtained in high enantiomeric purity, 98.7% e.e., by lipase-catalyzed asymmetric hydrolysis using a phosphate buffer and organic co-solvent system in 95% of chemical yield.     

Precipitation and characterization of uniform submicrometer lead titanate particles. Part II: Reaction mechanism

The chemical mechanism of the precipitation of lead titanium peroxohydroxide particles in a solution of nitrilotriacetate (NTA) complexes of lead and titanium peroxo-hydroxide is envisioned as the interaction between cations of lead hydroxide and anions of polymeric titanium peroxo-hydroxide.