高聚物固体电解质聚氧化乙烯－溴化铜复阻抗谱及介电常数的静水压效应

采用分子量５００万的聚氧化乙烯和无水溴化铜，通过混溶蒸发法制备成高聚物固体电解质Ｐ（ＥＯ）ｎ－ＣｕＢｒ２薄膜，并在０．１～３００ＭＰａ范围不同的流体静水压下详细测量其复平面阻抗谱，分别得到在不同压力下离子电导率和介电常数与测量频率的关系．进一步解谱准确地求出Ｐ（ＥＯ）ｎ－ＣｕＢｒ２（ｎ＝１２、１６）薄膜离子电导率和介电常数的静水压效应，并结合Ｘ－光物相分析，根据离子迁移通道的物理图象和高聚物的极化机构进行了初步的讨论．添加２０％的增塑剂碳酸丙烯酯，较大改进了压力下的导电性．１２０～３００ＭＰａ的离子电导率提高一个数量级     

溶菌酶在裸金电极和疏基乙酸或正十二疏烷基醇修饰电极上的吸附

电化学石英晶体阻抗系统;疏基乙酸;溶菌酶在裸金电极和疏基乙酸或正十二疏烷基醇修饰电极上的吸附     

Fibers and 3D mesh scaffolds from biodegradable starch-based blends: production and characterization

The aim of this work is the production of fibers from biodegradable polymers to obtain 3D scaffolds for tissue engineering of hard tissues. The scaffolds required for this highly demanding application need to have, as well as the biological and mechanical characteristics, a high degree of porosity with suitable dimensions for cell seeding and proliferation. Furthermore, the open cell porosity should have adequate interconnectivity for a continuous flow of nutrients and outflow of cell metabolic residues as well as to allow cell growth into confluent layers. Blends of corn starch, a natural biodegradable polymer, with other synthetic polymers (poly(ethylene vinyl alcohol), poly(epsilon-caprolactone), poly(lactic acid)) were selected for this work because of their good balance of properties, namely biocompatibility, processability and mechanical properties. Melt spinning was used to produce fibers from all the blends and 3D meshes from one of the starch-poly(lactic acid) blends. The experimental characterization included the evaluation of the tensile mechanical properties and thermal properties of the fibers and the compression stiffness, porosity and degradation behavior of the 3D meshes. Light microscopy picture of 3D meshes.     

一种用于空气中二氧化碳现场测定的新方法

一种用于空气中二氧化碳现场测定的新方法于爱民，杨广德，王锐，金钦汉（吉林大学化学系，长春１３００２３）关键词微波诱导等离子体，离子化检测器，气相色谱仪，二氧化碳二氧化碳在植物生长代谢及其生态平衡过程中起着重要作用，现场测定二氧化碳是目前农业、环境科学...     

沐浴海绵Spongia zimocca aubspecles irregularia(Lendenfeld)中的含氮化合物

从沐浴海绵Spongia zimocca aubspecles irregularia(Lendenfeld)分离和处理得到3种含氮化合物,通过波谱法鉴定化学结构,化合物1为新的神经酰胺N-2-(1,3-二羟基-十五烷基)-2′,20′-二十一酰胺,2为神经酰胺(E)-N-2-(1,3-二羟基-4-十八烯基)-十六酰胺,3为醋酸胍.     

A vacuum ultraviolet photoionization mass spectrometric study of acetone

The photoionization and dissociative photoionization of acetone have been studied at the photon energy range of 8-20 eV. Photoionization efficiency spectra for ions CH3COCH3+, CH3+, C2H3+, C3H3+, C3H5+, CH(2-)CO+, CH3CO+, C3H4O+, and CH3COCH2+ have been measured. In addition, the energetics of the dissociative photoionization has been examined by ab initio Gaussian-3 (G3) calculations. The computational results are useful in establishing the dissociation channels near the ionization thresholds. With the help of G3 results, the dissociation channels for the formation of the fragment ions CH3CO+, CH2CO+, CH3+, C3H3+, and CH3COCH2+ have been established. The G3 results are in fair to excellent agreement with the experimental data.     

水热法合成Ce0.67Zr0.33O0.2固溶体研究

采用两种不同前驱体通过水热法合成了Ce0.67Zr0.33O0.2固溶体,并通过XRD,BET,TPR等手段考察了样品的相结构,比表面及还原特性.结果表明,在180℃,12 h的水热条件下,以共沉淀产物为前驱体所制得的Ce0.67Zr0.33O0.2固溶体比表面积较高,但存在一定程度的相分离;以凝胶产物为前驱体制得的Ce0.67Zr0.33O0.2固溶体结构更完整,具有良好的还原特性及热稳定性.     

超声提取-超高效液相串联质谱分析沉积物中15种抗生素

在现有方法基础上对沉积物中磺胺类、喹诺酮类、大环内脂类和四环素类抗生素的提取、富集、净化以及仪器分析方法进行了优化。以EDTA-Mcllvaine缓冲溶液与乙腈(V:V,1:1)混合液作为提取液,利用超声波细胞破碎仪进行超声提取,串联强阴离子交换柱(SAX)和HLB固相萃取柱进行固相萃取(SPE),通过超高效液相/串联质谱(UPLC-MS/MS)测定沉积物中抗生素的含量。抗生素基质加标回收率在56.4%~110%,相对标准偏差为1.1%~24.3%,方法检出限0.0055~0.716 ng/g。本方法有效地提高了沉积物中抗生素的提取效率,并应用于实际样品的测定中。     

典型无机含氧酸自由基的特性

碳酸自由基、硝酸自由基、磷酸自由基和硫酸自由基是化学反应的重要中间体，都具有氧化性，对污染物在自然和人为环境中的迁移转化会产生重要的影响.文中较为详细地介绍这几种自由基的电极电位、产生方式、检测方法及与有机物的反应方式.总结四种自由基的特性及与有机物的反应方式可发现，四种自由基和羟自由基电极电位不同，导致它们和有机物反应速率的不同；碳酸自由基并不是羟自由基去除剂，对于一些容易被氧化的化合物，碳酸自由基氧化效果比羟自由基好；四种自由基均可由羟自由基转化而来，并且这四种自由基和羟自由基与有机物反应方式基本一致，都通过电子转移、夺氢和加成的方式进行.可以预测四种自由基和羟自由基降解有机物的机理将非常相似，今后应研究四种自由基与羟自由基相互转化的规律，以及与代表性有机物的反应机理.     

新型杂多蓝化合物[NH3(CH2)2NH3]5[Cd(H2O)][CdMoV12O30(HPO4)6(H2PO4)2]·5H2O的合成与晶体结构

利用水热法首次合成了具有两种配位环境Cd原子的新型杂多蓝化合物[NH3(CH2)2NH3]5[Cd(H2O)][CdMoV12O30(HPO4)6(H2PO4)2]·5H2O.通过元素分析、ICP、TG和X射线单晶衍射确定了其组成,使用IR和EPR进行了结构表征.通过N2吸附脱附测定了比表面积和孔径,为催化研究提供了基础数据.结果表明:该晶体为三斜晶系,P-1空间群;晶胞参数a=1.200 2(2)nm,b=1.465 1(3)nm,c=2.119 2(4)nm,V=3.5642(12)nm3,β=83.01(3)°,Z=2,F(000)=293 2,R1=0.0300,wR3=0.071 6.