RF-PACVD of water repellent and protective HMDSO coatings on bell metal surfaces: Correlation between discharge parameters and film properties

Hexamethyldisiloxane (HMDSO) films have been deposited on bell metal using radiofrequency plasma assisted chemical vapor deposition (RF-PACVD) technique. The protective performances of the HMDSO films and their water repellency have been investigated as a function of DC self-bias voltage on the substrates during deposition. Plasma potential measurements during film deposition process are carried out by self-compensated emissive probe. Optical emission spectroscopy (OES) analyses of the plasma during deposition reveal no significant change in the plasma composition within the DC self-bias voltage range of −40 V to −160 V that is used. Raman and X-ray photoelectron spectroscopy (XPS) studies are carried out for film chemistry analysis and indicate that the impinging ion energy on the substrates influences the physio-chemical properties of the HMDSO films. At critical ion energy of 113 qV (corresponding to DC self-bias voltage of −100 V), the deposited HMDSO film exhibits least defective Si-O-Si chemical structure and highest inorganic character and this contributes to its best corrosion resistance behavior. The hardness and elastic modulus of the films are found to be bias dependent and are 1.27 GPa and 5.36 GPa for films deposited at −100 V. The critical load for delamination is also bias dependent and is 11 mN for this film. The water repellency of the HMDSO films is observed to be dependent on the variation in surface roughness. The results of the investigations suggest that HMDSO films deposited by RF-PACVD can be used as protective coatings on bell metal surfaces.     

XRD and bulk magnetic studies on Ni-Cd and Ti doped Ni-Cd ferrites

For the ferrites Ni _x Cd_1–x Fe₂O₄ (x=0.3, 0.4,1) the lattice parameter, grain size, electrical resistivity, initial permeability, Curie temperature and squareness of the magnetization curve were measured. The results are discussed in terms of the model of the canted spin structure taking into account the domain structure of the polycrystalline ferrite.     

Synthesis of 3′-fluoro-4′-amino-hexitol nucleosides with a pyrimidine nucleobase as building blocks for oligonucleotides

The synthesis of 3′-fluoro-4′-amino-hexitol nucleosides with a uracil and cytosine nucleobase was performed. The synthesis started from 1,5:2,3-dianhydro-4,6-benzylidene-allitol and afforded the target compounds in 15 steps. These protected hexitol nucleosides are valuable building blocks for the preparation of a new class of oligonucleotides.     

Iodine-transfer polymerization and CuAAC “click” chemistry: A versatile approach toward poly(vinylidene fluoride)-based amphiphilic triblock terpolymers

This study presents the synthesis and properties of linear PVDF-based amphiphilic triblock terpolymers with PS and PEO, [PVDF-b-PS-b-PEO], by adopting a procedure that involves: (a) iodine-transfer polymerization (ITP) of VDF with 1-iodoperfluorohexane (C₆F₁₃I) serving as chain-transfer agent (CTA) to afford C₆F₁₃-PVDF-I, (b) ITP of styrene with the C₆F₁₃-PVDF-I macromolecular-CTA to obtain C₆F₁₃-PVDF-b-PS-I diblock copolymer, (c) end-group exchange from iodo- to azido-group by nucleophilic substitution reaction with NaN_3, and (d) copper-catalyzed azide-alkyne cycloaddition (CuAAC) with alkyne-terminated PEO to achieve C₆F₁₃-PVDF-b-PS-b-PEO triblock terpolymers. The ¹H and ¹⁹F NMR spectroscopy confirmed the presence of all blocks, while gel permeation chromatography traces showed the living nature of ITP technique. The self-assembly of these terpolymers was investigated in films (atomic force microscopy and DSC), as well as in aqueous and organic solvents (DLS). The analysis of crystalline phases based on the FTIR spectroscopy indicated the conversion of PVDF α-phase into α + β-phases and β + γ-phases upon the incorporation of PS and PEO blocks, respectively. The synthesized amphiphilic copolymers were evaluated (fluorescence spectroscopy) as carriers of small hydrophobic molecules in water. © 2019 Wiley Periodicals, Inc. J. Polym. Sci. 2020 , 58, 163–171     

NHC-Pd complex heterogenized on graphene oxide for cross-coupling reactions and supercapacitor applications

N-heterocyclic carbene (NHC)-palladium(II) complex (GO@NHC-Pd) was synthesized on graphene oxide (GO) support via a simple and cost-effective multistep approach. The spectroscopic, microscopic, thermal, and surface analyses of GO@NHC-Pd confirmed the successful formation of the catalyst. The investigation of catalytic activity showed that GO@NHC-Pd was very effective in Suzuki–Miyaura as well as Hiyama cross-coupling. Being heterogeneous in nature, GO@NHC-Pd was recovered after each reaction cycle easily and reused for up to nine and six cycles in Suzuki–Miyaura and Hiyama cross-coupling, respectively, without significant loss of activity. Further exploration of the supercapacitor performance of GO@NHC-Pd catalyst assembled in a two-electrode cell configuration shown a maximum attained capacitance of 105.26 F/g at a current density of 0.1 A/g with good cycling stability of 96.89% over 2,500 cycles.     

Magnetic nanoparticle‐tethered Schiff base–palladium(II): Highly active and reusable heterogeneous catalyst for Suzuki–Miyaura cross‐coupling and reduction of nitroarenes in aqueous medium at room temperature

As a continuation of our efforts to develop new heterogeneous nanomagnetic catalysts for greener reactions, we identified a Schiff base–palladium(II) complex anchored on magnetic nanoparticles (SB‐Pd@MNPs) as a highly active nanomagnetic catalyst for Suzuki–Miyaura cross‐coupling reactions between phenylboronic acid and aryl halides and for the reduction of nitroarenes using sodium borohydride in an aqueous medium at room temperature. The SB‐Pd@MNPs nanomagnetic catalyst shows notable advantages such as simplicity of operation, excellent yields, short reaction times, heterogeneous nature, easy magnetic work up and recyclability. Characterization of the synthesized SB‐Pd@MNPs nanomagnetic catalyst was performed with various physicochemical methods such as attenuated total reflectance infrared spectroscopy, UV–visible spectroscopy, inductively coupled plasma atomic emission spectroscopy, energy‐dispersive X‐ray spectroscopy, field‐emission scanning electron microscopy, transmission electron microscopy, powder X‐ray powder diffraction, thermogravimetric analysis and Brunauer–Emmett–Teller surface area analysis.     

Free carrier absorption in a ferromagnetic semiconductor below Curie temperature

The free carrier absorption (FCA) in a non-degenerate ferromagnetic semiconductor due to electron-two-magnon scattering is calculated below the Curie temperature, assuming a wide conduction band model. It has been found that in EuO FCA due to two-magnon scattering is proportional to λ^2·1 (wavelength of radiation) and it has been noticed that for high conductivity samples, explanation of FCA requires the inclusion of ionized impurity scattering of electrons besides the two-magnon process.     

TDDFT Investigation of the Electronic Structures and Photophysical Properties of Fluorescent Extended Styryl Push-Pull Chromophores Containing Carbazole Unit

Push-pull chromophores attached to carbazole based π-conjugating spacers bearing N-alkylamino donors, cyanovinyl and carbethoxy acceptors have been studied by the means of UV-Visible measurements. The intramolecular charge transfer (ICT) of these π-conjugated systems has also been tested by investigating the ability of the solute molecules to undergo shifts in their fluorescence emission maxima with increasing solvent polarity. Density Functional Theory [B3LYP/6-31G(d)] and Time Dependent Density Functional Theory [TD-B3LYP/6-31G(d)] computations have been used to have more understanding of the structural, molecular, electronic and photophysical parameters of push-pull dyes. The largest wavelength difference between the experimental and computed electronic absorption maxima was 45 nm. For emission, a largest difference of 61 nm was observed. The ground state and excited state dipole moments in different solvents were determined using experimental solvatochromic data and computed Onsager radii. The dipole moments of the molecules in the excited state were observed to be higher than in the ground state.