Rb saturation spectroscopy with an optically narrowed FM diode laser

A fast-frequency modulated (FM) diode laser has been optically narrowed using the technique of resonant optical feedback, to provide linewidths in each FM mode of ≈ 200 kHz peak-to-peak. With a drive frequency of 50 MHz and modulation index of 0.2, the FM laser has been used for the first time to obtain Doppler-free FM spectra of the Rb D₁ line at 795 nm. The potential use of this system for laser frequency stabilisation is discussed.     

Electron traps and positive DLTS signals in VPE GaAs MESFETs

Capacitance DLTS measurements have been performed in VPE GaAs MESFETs prepared on Bridgman Cr-doped and LEC undoped semi-insulating substrates. A band of electron traps not intrinsically related to the VPE growth process and accumulating near the metal (gate) — semiconductor interface was detected in all the samples. Deeper regions into the channel were free from any detectable trap. Near pinch-off conditions, a positive capacitance signal was found to dominate the DLTS spectra only in the case of samples prepared on Cr-doped substrates. The hypothesis of this positive transient being related to changes in the occupation of surface states in the ungated surface access regions has been checked by comparing experimental and calculated dependencies of the signal amplitude on reverse gate voltage. Unexplained discrepancies, together with the absence of positive signal in MESFETs prepared on LEC undoped substrates, suggest the possibility of hole emission from hole traps within the bulk of the device.     

3D-TOFSIMS characterization of black spots in polymer light emitting diodes

The occurrence and formation of black spots areas in PolyLED devices has been studied by time-of-flight SIMS (TOFSIMS). The composition, shape and position of the black spots is visualised by three-dimensional (3D)-TOFSIMS depth-profiling. It has been established that the formation of non-emissive spots is due to the growth of aluminium oxide clusters at the AlBa/polymer interface. Electron injection in the black spots is lost by the resulting local increase of the resistivity of the cathode.     

INFLUENCE OF A LEVELNESS DEFECT IN A THRUST BEARING ON THE DYNAMIC BEHAVIOUR OF AN ELASTIC SHAFT

This paper examines the non-linear dynamic behaviour of a flexible shaft. The shaft is mounted on two journal bearings and the axial load is supported by a defective hydrodynamic thrust bearing at one end. The defect is a levelness defect of the rotor. The thrust bearing behaviour must be considered to be non-linear because of the effects of the defect. The shaft is modelled with typical beam finite elements including effects such as the gyroscopic effects. A modal technique is used to reduce the number of degrees of freedom. Results show that the thrust bearing defects introduce supplementary critical speeds. The linear approach is unable to show the supplementary critical speeds which are obtained only by using non-linear analysis.     

Efficient computation of natural convection in a concentric annulus between an outer square cylinder and an inner circular cylinder

In this work, the natural convection in a concentric annulus between a cold outer square cylinder and a heated inner circular cylinder is simulated using the differential quadrature (DQ) method. The vorticity‐stream function formulation is used as the governing equation, and the coordinate transformation technique is introduced in the DQ computation. It is shown in this paper that the outer square boundary can be approximated by a super elliptic function. As a result, the coordinate transformation from the physical domain to the computational domain is set up by an analytical expression, and all the geometrical parameters can be computed exactly. Numerical results for Rayleigh numbers range from 104 to 106 and aspect ratios between 1.67 and 5.0 are presented, which are in a good agreement with available data in the literature. It is found that both the aspect ratio and the Rayleigh number are critical to the patterns of flow and thermal fields. The present study suggests that a critical aspect ratio may exist at high Rayleigh number to distinguish the flow and thermal patterns. Copyright © 2002 John Wiley & Sons, Ltd.     

Effect of hydrogen on the photoelectronic properties of GaAs/InGaAs quantum-well heterostructures with an island palladium layer on the surface

The effect of hydrogen on the photoluminescence and planar conductivity of GaAs/InGaAs quantum-well heterostructures with an island Pd layer at the anodically oxidized surface was studied. Unlike continuous deposited Pd layers, island layers do not cause the formation of defects in the GaAs surface region and yet the Pd layer maintains high catalytic activity with respect to hydrogen. It is found that the thermal treatment of such a structure in a hydrogen atmosphere causes atomic-hydrogen passivation of the defects in quantum wells. Studies of the characteristics of planar photoresistors with an island Pd layer acting as hydrogen sensors show that their hydrogen detectivity is approximately two orders of magnitude higher than that of diode structures with continuous Pd layers.     

Hydromagnetic instability of streaming fluids in porous medium

The instability of the plane interface between two uniform, superposed, electrically conducting and counter-streaming fluids through a porous medium is considered in the presence of a horizontal magnetic field. In the absence of surface tension, perturbations transverse to the direction of streaming are found to be unaffected by the presence of streaming if perturbations in the direction of streaming are ignored. For perturbations in all other directions there exists instability for a certain wavenumber range. The instability of this system is postponed by the presence of magnetic field. The magnetic field and surface tension are able to suppress this Kelvin-Helmholtz instability for small wavelength perturbations and the medium porosity reduces the stability range given in terms of a difference between the streaming velocities and the Alfvén velocity.This research forms a part of the research project awarded to the first author (R.C.S.) by the University Grants Commission.     

An extended technicolour model for grand unification

An extended technicolour grand unification model based on the gauge groupE ₆×SU(7) extended technicolour is presented. The symmetry-breaking based on extended technicolour theory is discussed. It is shown that the existing phenomenology is well explained by the model. The strangeness changing neutral currents may not be a problem with this model.     

High-throughput screening of fuel cell electrocatalysts

The drawbacks of our earlier report of preparing fuel cell catalyst arrays by borohydride reduction of inkjet prepared arrays of metal salts are discussed along with the need for inclusion of state-of-the-art metrics in all array screening. An alternative method for screening of hydrogen/air cathode catalysts, direct methanol fuel cell (DMFC) anode catalysts, and catalyst loading studies is provided. State-of-the-art Johnson Matthey catalysts were used in control experiments to demonstrate the utility of the array fuel cell for high throughput screening of fuel cell catalysts in the 3-4 mg/cm² range. This report lays out hard learned rules for high throughput screening and demonstrates that the array fuel cell can be used for very precise screening of libraries of membrane electrode assembly (MEA) components without the pitfalls discussed in the introduction.