Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

Rb saturation spectroscopy with an optically narrowed FM diode laser

A fast-frequency modulated (FM) diode laser has been optically narrowed using the technique of resonant optical feedback, to provide linewidths in each FM mode of ≈ 200 kHz peak-to-peak. With a drive frequency of 50 MHz and modulation index of 0.2, the FM laser has been used for the first time to obtain Doppler-free FM spectra of the Rb D₁ line at 795 nm. The potential use of this system for laser frequency stabilisation is discussed.     

Diffraction in a nonlinear defocusing medium

Diffraction by a semitransparent screen is considered in the framework of the nonlinear Schrödinger equation. The case of a defocusing medium is investigated. The method used represents a synthesis of the method of Riemann's matrix problem and the technique of Whitham's deformations of spectral curves.Translated from Zapiski Nauchnykh Seminarov Leningradskogo Otdeleniya Matematicheskogo Instituta im. V. A. Steklova, Vol. 179, pp. 23–31, 1989.     

Electron traps and positive DLTS signals in VPE GaAs MESFETs

Capacitance DLTS measurements have been performed in VPE GaAs MESFETs prepared on Bridgman Cr-doped and LEC undoped semi-insulating substrates. A band of electron traps not intrinsically related to the VPE growth process and accumulating near the metal (gate) — semiconductor interface was detected in all the samples. Deeper regions into the channel were free from any detectable trap. Near pinch-off conditions, a positive capacitance signal was found to dominate the DLTS spectra only in the case of samples prepared on Cr-doped substrates. The hypothesis of this positive transient being related to changes in the occupation of surface states in the ungated surface access regions has been checked by comparing experimental and calculated dependencies of the signal amplitude on reverse gate voltage. Unexplained discrepancies, together with the absence of positive signal in MESFETs prepared on LEC undoped substrates, suggest the possibility of hole emission from hole traps within the bulk of the device.     

Global fit analysis including the ν9 + ν4 − ν4 hot band of ethane: Evidence of an interaction with the ν12 fundamental

The ν₉ fundamental band of ethane occurs in the 12 μm region. It is the strongest band of ethane in a terrestrial window and is commonly used for the identification of ethane in the Jovian planets. The ν₉ + ν₄ − ν₄ band occurs in the same region; neither can be analysed as an isolated band, since both are embedded in the torsional bath of the ground vibrational state. We report here two global fit models including data from both of these bands as well as the ν₃ fundamental and the ν₄, 2ν₄ − ν₄, and 3ν₄ torsional transitions. The first is restricted to −5 ? KΔK ? 15 in the hot band and gives an excellent fit to the included data. Three resonant interactions are identified in this fit—a Coriolis interaction with two resonant cases between the ν₉ torsional stack and that of the ground vibrational state (gs) and a resonant Fermi interaction between the ν₃ fundamental and the gs. Hot band lines with KΔK < −5 are influenced by a fourth perturbation, with a crossing at −11 < KΔK < −10, which has been attributed to an interaction with the ν₁₂ fundamental. A second fit, demonstrating a promising treatment of this interaction, is also presented.     

INFLUENCE OF A LEVELNESS DEFECT IN A THRUST BEARING ON THE DYNAMIC BEHAVIOUR OF AN ELASTIC SHAFT

This paper examines the non-linear dynamic behaviour of a flexible shaft. The shaft is mounted on two journal bearings and the axial load is supported by a defective hydrodynamic thrust bearing at one end. The defect is a levelness defect of the rotor. The thrust bearing behaviour must be considered to be non-linear because of the effects of the defect. The shaft is modelled with typical beam finite elements including effects such as the gyroscopic effects. A modal technique is used to reduce the number of degrees of freedom. Results show that the thrust bearing defects introduce supplementary critical speeds. The linear approach is unable to show the supplementary critical speeds which are obtained only by using non-linear analysis.     

Effect of hydrogen on the photoelectronic properties of GaAs/InGaAs quantum-well heterostructures with an island palladium layer on the surface

The effect of hydrogen on the photoluminescence and planar conductivity of GaAs/InGaAs quantum-well heterostructures with an island Pd layer at the anodically oxidized surface was studied. Unlike continuous deposited Pd layers, island layers do not cause the formation of defects in the GaAs surface region and yet the Pd layer maintains high catalytic activity with respect to hydrogen. It is found that the thermal treatment of such a structure in a hydrogen atmosphere causes atomic-hydrogen passivation of the defects in quantum wells. Studies of the characteristics of planar photoresistors with an island Pd layer acting as hydrogen sensors show that their hydrogen detectivity is approximately two orders of magnitude higher than that of diode structures with continuous Pd layers.     

Hydromagnetic instability of streaming fluids in porous medium

The instability of the plane interface between two uniform, superposed, electrically conducting and counter-streaming fluids through a porous medium is considered in the presence of a horizontal magnetic field. In the absence of surface tension, perturbations transverse to the direction of streaming are found to be unaffected by the presence of streaming if perturbations in the direction of streaming are ignored. For perturbations in all other directions there exists instability for a certain wavenumber range. The instability of this system is postponed by the presence of magnetic field. The magnetic field and surface tension are able to suppress this Kelvin-Helmholtz instability for small wavelength perturbations and the medium porosity reduces the stability range given in terms of a difference between the streaming velocities and the Alfvén velocity.This research forms a part of the research project awarded to the first author (R.C.S.) by the University Grants Commission.     

High-throughput screening of fuel cell electrocatalysts

The drawbacks of our earlier report of preparing fuel cell catalyst arrays by borohydride reduction of inkjet prepared arrays of metal salts are discussed along with the need for inclusion of state-of-the-art metrics in all array screening. An alternative method for screening of hydrogen/air cathode catalysts, direct methanol fuel cell (DMFC) anode catalysts, and catalyst loading studies is provided. State-of-the-art Johnson Matthey catalysts were used in control experiments to demonstrate the utility of the array fuel cell for high throughput screening of fuel cell catalysts in the 3-4 mg/cm² range. This report lays out hard learned rules for high throughput screening and demonstrates that the array fuel cell can be used for very precise screening of libraries of membrane electrode assembly (MEA) components without the pitfalls discussed in the introduction.