Static and dynamic light-scattering studies on micellar solutions of alkyldimethylbenzylammonium chlorides

Static (SLS) and dynamic (DLS) light-scattering techniques were applied to the study of the aggregation of dodecyl- (C12DBACl), tetradecyl- (C14DBACl), and hexadecyldimethylbenzylammonium (C16DBACl) chlorides in water and in 0.01 and 0.05 m NaCl aqueous solutions at 25 degrees C. Results of SLS measurements yielded critical micelle concentration (cmc) values for aqueous and NaCl solutions. The aggregation numbers of the micelles for the homologous surfactants are low but increase with chain length and ionic strength of the solution. Various patterns of changes of the diffusion coefficient, D, as a function of chain length, molality, and with ionic strength were found for the studied surfactants. Transformations in the structure of micelles of C14DBACl in 0.01 m NaCl occur at a concentration of surfactant of about 0.01 m. Such transformations, presumably due to rodlike structure, are the more extensive the higher the concentration of NaCl. The concentration of C16DBACl in 0.05 m NaCl covers the range where already repulsive interactions between micelles occur, as judged by the strongly negative slope of the D versus molality plot. To provide additional information on the suggested transformations, complementary viscosity measurements for C14DBACl in 0.01 m of NaCl have been performed.     

Counterions in poly(allylamine hydrochloride) and poly(styrene sulfonate) layer-by-layer films

The amount of counterions in layer-by-layer (LBL) films of poly(allylamine hydrochloride) (PAH) and poly(styrene sulfonate) (PSS) has been determined with X-ray photoelectron spectroscopy (XPS) for films prepared from solutions with various NaCl concentrations. Sodium and chloride counterions are present in LBL films produced from salt solutions, which are located at the surface and in the bulk of the films. The percentage of bulk counterions increases with the ionic strength of the polyelectrolyte before reaching a constant value. The bulk sodium/sulfur percentage ratios tend to 0.8 for samples washed with pure water and for samples washed with NaCl aqueous solutions, while the bulk chlorine/nitrogen percentage ratios tend to 0.5 for the same samples. The ratio between the percentages of polyelectrolyte ionic groups lies close to unity for all samples, indicating that counterions do not contribute to charge compensation in the polyelectrolyte during the adsorption process. The presence of counterions in LBL films is explained by Manning condensation near the polyelectrolyte ionic groups, leading to inter-polyelectrolyte ionic bondings via ionic networks. It is believed that condensation leads to the formation of NaCl crystallites in these LBL films, which was confirmed by X-ray diffraction measurements.     

Synthesis of beta-lactams from a N-rhenaimine: effect of the transition metal on the energetic profile of the Staudinger reaction

As depicted in the scheme, the alkylidenamido complex 1, a N-rhenaimine, reacts with ketenes to afford the beta-lactams 2-4, which possess a {Re(CO)3(bpy)} fragment as substituent at nitrogen. Clean demetalations using HOTf or MeOTf yield the free beta-lactams or N-methyl-beta-lactams along with [Re(OTf)(CO)3(bpy)]. DFT calculations help to rationalize why the reaction is faster than those of non transition metal N-substituted imines.     

Synthesis, Crystal Structure, and IR Spectroscopic Characterization of 1,6-Hexanediammonium Dihydrogendecavanadate

Summary.  Anhydrous 1,6-hexanediammonium dihydrogendecavanadate ((HdaH₂)₂H₂V₁₀O₂₈, 1) was prepared by reaction of V₂O₅ with 1,6-hexanediamine in aqueous solution. The crystal structure of 1 was determined, and the proton positions in the H₂V₁₀O₂₈ ⁴⁻ anion were calculated by the bond length/bond number method. The protons are bound to the centrosymmetrically oriented μ–OV₃ groups of the decavanadate anion. Based on the analysis of IR spectra of 1 prepared from H₂O and D₂O, the absorption band at 871 cm⁻¹ can be attributed to δ(V–O_b–H) vibrations. Received August 3, 2001. Accepted (revised) October 8, 2001     

Preparation of trout liver microsomes for iron speciation in P-450 enzymes by AE–FPLC with ICP–(ORS)MS detection

Cytochromes P-450 are members of a superfamily of hemoproteins involved in the oxidative metabolism of various physiological and xenobiotic compounds in eukaryotes and prokaryotes. The multiplicity of this group of enzymes has been widely studied by chromatographic techniques, mainly high-performance liquid chromatography (HPLC). Because these enzymes are membrane-bound proteins, sample preparation for chromatographic separation of P-450 enzymes requires a solubilization step. The sample-preparation procedures are critical, because detergents affect not only the efficiency of protein solubilization but also their further chromatographic resolution. Trout liver microsomes have been taken here as a model sample to investigate iron speciation in cytochrome P-450. Trouts were treated intraperitoneally with -naphthoflavone, a potent inducer of some P-450 enzymes, and a microsomal suspension containing 7.4±0.1 nmol mL^–1 P-450 enzymes was obtained by ultracentrifugation. Lubrol PX was selected as detergent for solubilization, resulting in about 90% solubilization recovery. The solubilized cytochromes P-450 were further separated by AE–FPLC, with UV detection, or coupled to ICP–MS with an octapole reaction system, ICP–(ORS)MS (monitoring Fe signals at masses 54, 56, and 57). A sampling procedure and chromatographic conditions are developed and were successfully applied to iron speciation in trout liver P-450 enzymes. ICP–(ORS)MS detection of P-450 enzymes is Fe-specific and so will give accurate information on the prosthetic group of the protein, which can constitute an advantageous alternative to classical methods for detection of these hemoproteins.     

Analysis of organic acids in wines by Fourier-transform infrared spectroscopy

Fourier-transform infrared (FTIR) spectroscopy has been a major point of development in many wine laboratories in recent years. It enables almost instant analysis of several properties of wine, usually with very good precision and accurate results. Nevertheless, validation procedures should not be forgotten and should be fully performed. Recovery experiments were performed by spiking wine samples with different amounts of organic acids (tartaric, malic, lactic, acetic and citric—the most prominent in wines). After FTIR analysis of the total acidity and of each organic acid concentration, recoveries were calculated. For total acidity recovery results were, in general, good and very close to 100% (64–111%). On the other hand, for individual organic acid concentrations, the recovery results were lower than 100% (11–73%) for all spiking additions. These results could be explained by spectroscopic interferences between the organic acids. Because they have similar infrared spectra, it is not easy to distinguish between them and, therefore, to achieve accurate calibration. When total acidity, with a different infrared spectrum from the other abundant compounds in the wine, was taken as a single property the recovery results were acceptable.     

Protein adsorption in fused-silica and polyacrylamide-coated capillaries

The model proteins cytochrome c, myoglobin, ovalbumin, and beta-lactoglobulin were investigated with regard to their adsorption properties on capillaries for electrophoresis. The model compounds were selected to cover a wide range of properties. Cytochrome c is a basic protein (isoelectric point (pI): 9.6; M(r): 11.7 kDa), beta-lactoglobulin is rather acidic (pI: 5.4, M(r): 18.4 kDa), myoglobin was chosen as a neutral reference protein (pI: 6.8-7.4, M(r): 17.8 kDa), and ovalbumin (pI: 5.1, M(r): 45.0 kDa) was selected as a relatively larger analyte. First, the pH dependence of adsorption was investigated for the bare fused silica. A clear correlation to the respective pIs was noted. For myoglobin and ovalbumin, none or negligible adsorption was found above the pI, whereas strong adsorption was noted just below this parameter. Cytochrome c and beta-lactoglobulin already showed distinct adsorption above their pIs. However, none of the proteins showed any significant adsorption more than one pH unit above the pIs. For linear polyacrylamide-coated capillaries, a decreased but not a complete lack of adsorption was observed. Here, pH-dependent adsorption was noted as well. Regeneration of the capillaries by rinsing with buffers containing 200 mM SDS was also investigated. This method was completely successful for myoglobin, but that too for only freshly-adsorbed protein. After a storage time of 24 h and due to the aging of the adsorbate, a sufficient regeneration was no longer possible.     

A density functional theory study on the electrocyclization of 1,2,4,6-heptatetraene analogues: converting a pericyclic to a pseudopericyclic reaction

A comprehensive B3LYP/6-31+G* study on the electrocyclization of 1,2,4,6-heptatetraene analogues was conducted. Starting from the cyclization of (2Z)-2,4,5-hexatrienal, a pericyclic disrotatory process favored by the assistance of a electron lone pair, we incorporated small modifications in its molecular structure to obtain a truly pseudopericyclic process. To this purpose electronegative atoms (fluorine and nitrogen) were added to give a more electrophilic character on the carbon atom which is attacked by the electron lone pair of the oxygen atom. The complete pathway for each reaction was determined, and changes in magnetic properties were monitored with a view to estimating the aromatization associated with each process. This information, together with the energetic and structural results, allowed us to classify the reactions as pseudopericyclic or pericyclic. Among all studied reactions only one was a truly pseudopericyclic process and another was a borderline case. The features of this unequivocally pseudopericyclic case were analyzed in depth.     

Evaluation of different quantitative approaches for the determination of noneasily ionizable molecules by different atmospheric pressure interfaces used in liquid chromatography tandem mass spectrometry: Abamectin as case of study

The liquid chromatography tandem mass spectroscopy residue determination of compounds without any acidic or basic centers such as abamectin has been investigated. Several approaches regarding the interface used and adduct formation have been compared. The low acidity of the hydroxyl groups only made deprotonation feasible using the atmospheric pressure chemical ionization (APCI) interface. To obtain sufficient sensitivity for residue analysis, the Ion Sabre APCI interface was necessary. However, the sensitivity attained was lower than for monitoring adducts in positive ion mode. Using electrospray ionization, different adducts with Na+, NH4+, and Li+ were tested and compared. The best results were obtained for the ammoniated adduct in electrospray ionization (ESI) because of its high sensitivity and the presence of several product ions with similar abundance. The highest sensitivity was reached using an in-source fragment as precursor ion, leading to a limit of detection (LOD) of 2 microg/L with low relative standard deviation. The relatively high abundance of other transitions allowed abamectin confirmation at concentrations close to the LOD (6 microg/L). Alkali ions were found to be a suitable alternative to determine and confirm abamectin at residue levels. The [M + Na]+ also presented various product ions with similar abundance, which allowed confirmation at LOD levels. However, this LOD was found to be almost four times higher than with [M + NH4]+ because of the poor sensitivity of the transitions obtained. Although the use of Li+ facilitated the fragmentation of the adduct [M + Li]+, with similar sensitivity to [M + NH4]+, this fragmentation preferentially generated only one product ion, which did not allow confirmation at concentration levels lower than 15 microg/L. The use of APCI for monitoring adducts was also feasible, but with less sensitivity. The sensitivity increased with the Ion Sabre APCI, although it was still five times lower than with ESI. Other adduct formers such as Co2+ and Ni2+ also were tested with unsatisfactory results.     

Considerations on the modelling and optimisation of resolution of ionisable compounds in extended pH-range columns

The problems associated to the modelling and optimisation of the chromatographic resolution of mixtures involving ionisable solutes at varying pH and acetonitrile content are discussed. Several retention models that separate the contributions of solute, column and stationary phase, were used. The retention was predicted with low errors in large pH domains (2-12), which was an essential requirement to face the optimisation of resolution. The selected mixture was particularly problematic under the viewpoint of resolution, owing to the excessively diverse acid-base behaviour of solutes. This variety led to sudden drops in retention at different pH for each solute, yielding numerous peak crossing, which made finding shared regions of high resolution especially difficult. Conventional resolution diagrams for these situations are scarcely informative, since both the overall and the worst elementary resolutions drop to zero if at least two compounds remain overlapped, even when all the others are baseline resolved. A new chromatographic objective function is proposed to address this drawback. This function, called "limiting peak count", is based on the limiting peak purity concept, and measures the success in the resolution focusing on the resolved solutes, in contrast to conventional resolution assessments that attend mainly to the least resolved solutes. Limiting peak count yields the same result as conventional assessments when full resolution is possible, but it is also able to discriminate the maximal resolving power in low-resolution situations. It offers a different perspective to that given by the complementary mobile phases approach, and the computation is far simpler.