Kinetics of solvolysis of 1-acetyl-4-(1-ethoxycarbonyl-1-cyano) methylene-1,4-dihydroquinoline in undried DMSO-d6· formation of Acetic Anhydride as an intermediate

The kinetics of solvolysis of the title compound (QAc) in undried DMSO-d₆ to give 4-(1-ethoxycarbonyl-1-cyano)methylquinoline (QH) and HOAc at ambient temperature were investigated by ¹H nmr spectrometry. With a limited excess of water the solvolysis follows a three-step process of $ {\rm QAc} + {\rm H}_2 {\rm O}\mathop \to \limits^{k_1} {\rm QH} + {\rm HOAc}, $ , and $ {\rm Ac}_{\rm 2} {\rm O} + {\rm H}_2 {\rm O}\mathop \to \limits^{k_3} {\rm 2\,HOAc}, $ where k₂ > k₁ and k₃ < k₁. Addition of pyridine-d₅ to the reaction mixture markedly catalyzes the overall solvolysis, while addition of CF₃CO₂D to the reaction mixture simplifies the kinetics to pseudo first-order in [QAc] with k = 4.3 × 10^?3 min^?1.     

The Dinitramide Anion, N(NO(2))(2)(-)

The infrared and Raman spectra of the NH(4)(+), K(+), and Cs(+) salts of N(NO(2))(2)(-) in the solid state and in solution have been measured and are assigned with the help of ab initio calculations at the HF/6-31G and MP2/6-31+G levels of theory. In agreement with the variations observed in the crystal structures, the vibrational spectra of the N(NO(2))(2)(-) anion are also strongly influenced by the counterions and the physical state. Whereas the ab initio calculations for the free N(NO(2))(2)(-) ion indicate a minimum energy structure of C(2) symmetry, Raman polarization measurements on solutions of the N(NO(2))(2)(-) anion suggest point group C(1) (i.e., no symmetry). This is attributed to the very small (<3 kcal/mol) N-NO(2) rotational barrier in N(NO(2))(2)(-) which allows for easy deformation.     

Reduction of soluble colloidal MnO<Subscript>2</Subscript> by <Emphasis Type="SmallCaps">DL</Emphasis>-malic acid in the absence and presence of nonionic TritonX-100

Kinetics of oxidation of DL-malic acid by water soluble colloidal MnO₂ (prepared from potassium permanganate and sodium thiosulfate solutions) have been studied spectrophotometrically in the absence and presence of nonionic Triton X-100 surfactant. The reaction is autocatalytic and manganese(II) (reduction product of the colloidal MnO₂) may be the autocatalyst. The order of the reaction is first in colloidal [MnO₂] as well as in [malic acid] both in the absence and presence of the surfactant. The reaction has acid-dependent and acid-independent paths and, in the former case, the order is fractional in [H⁺]. The effect of externally added manganese(II) is complex. The results show that the rate constant increases as the manganese(II) concentration is increased. It is not possible to predict the exact dependence of the rate constants on manganese(II) concentration, which has a series of reactions with other reactants. In the presence of TX-100, the observed effect on k is catalytic up to a certain [TX-100]; thereafter, an inhibitory effect follows. The catalytic effect is explained in terms of the mathematical model proposed by Tuncay et al. (in Colloids Surf A Physicochem Eng Aspects 149:279 3). Activation parameters associated with the observed rate constants (k_obs/k) have also been evaluated and discussed.     

Enhancing effect of DNA on chemiluminescence from the decomposition of hydrogen peroxide catalyzed by copper(II)

In the absence of any special luminescence reagent, emission of weak chemiluminescence has been observed during the decomposition of hydrogen peroxide catalyzed by copper(II) in basic aqueous solution. The intensity of the chemiluminescence was greatly enhanced by addition of DNA and was strongly dependent on DNA concentration. Based on these phenomena, a flow-injection chemiluminescence method was established for determination of DNA. The chemiluminescence intensity was linear with DNA concentration in the range 2×10^–7–1×10^–5 g L^–1 and the detection limit was 4.1×10^–8 g L^–1 (S/N=3). The relative standard deviation was less than 3.0% for 4×10^–7 g L^–1 DNA (n=11). The proposed method was satisfactorily applied for determination of DNA in synthetic samples. The possible mechanism of the CL reaction is discussed.     

The Degree of Disorder in Hardwood Kraft Pulps Studied by Means of LODP

The amount of disordered material in two types of hardwood kraft pulps was estimated by determining the weight loss at the point where the levelling-off degree of polymerisation (LODP) was reached. The pulps used were commercial pulps viz (1)one conventional birch kraft and (2)one mixed hardwood (MHW) kraft pulp that had been prehydrolysed prior to cooking. The results indicated that the hemicellulose xylan is closely associated with the cellulose in commercial birch pulps. It is therefore only possible to use LODP as a measure of the crystallite length of hardwood cellulose in highly purified pulps, such as prehydrolysed kraft pulp. A model explaining the LODP-results is proposed.     

A combination atmospheric pressure LC/MS:GC/MS ion source: Advantages of dual AP-LC/MS:GC/MS instrumentation

Modification of commercial LC/MS instrumentation to allow both atmospheric pressure (AP) LC/MS and GC/MS is described. Advantages of this additional capability versus LC/MS alone include higher chromatographic resolution in the GC versus LC mode, greater peak capacity for complex mixture analysis, higher sensitivity for a variety of volatile compounds, and the ability to observe compounds of low polarity that are not readily observed in LC/MS. Advantages over conventional GC/MS include the ability to use higher carrier gas flow and shorter columns for passing less volatile materials through the gas chromatograph, selective ionization, and rapid switching between positive and negative ion modes. Other advantages include application of the enhanced capabilities of LC/MS instrumentation to GC/MS analyses such as cone voltage fragmentation, MS(n), high mass resolution, and accurate mass measurement. Limitations of APGC/MS include the inability to observe saturated hydrocarbon and certain other highly nonpolar compounds and less odd-electron fragmentation for computer aided library searching. For some analyses, the limitation related to ionization of highly nonpolar compounds is advantageous, as is the simplified mass spectrum and easy molecular weight identification that results from less fragmentation observed in the AP ionization mode.     

Synthetic studies related to diketopyrrolopyrrole (DPP) pigments. Part 2: The use of esters in place of nitriles in standard DPP syntheses: Claisen-type acylations and furopyrrole intermediates

Ethyl 2-aryl-4,5-dihydro-5-oxopyrrole-3-carboxylates react with esters or acyl halides in the presence of a strong base to give 4-acyl derivatives, which exist predominantly as either E- or Z-enols. These are cyclised, either in solution at temperatures >200 °C or by microwave irradiation, to 3,6-disubstituted 1H-furo[3,4-c]pyrrolediones which, after N-protection, are convertible by reaction with primary amines into novel N,N′-disubstituted DPP derivatives.     

Diamond paste-based electrodes for determination of Cr(III) in pharmaceutical compounds

A new class of monocrystalline diamond paste-based electrodes is proposed for the determination of chromium(III) at trace levels in vitamins. Three types of monocrystalline diamond—natural diamond 1 (natural diamond), synthetic diamond 50 (synthetic-1), and synthetic diamond 1 (synthetic-2)—were used for electrode construction. The linear concentration ranges are between 10^–10 and 10^–8; 10^–9 and 10^–7, and 10^–10 to 10^–8 mol L^–1, with limits of detection of 10^–12, 10^–12, and 10^–11 mol L^–1, when natural diamond, synthetic-1, and synthetic-2, respectively, are used as electrode materials. For electrodes based on natural diamond and synthetic-1 it was found that Cr(III) yields a peak at about +0.275±0.015 V (vs. Ag/AgCl) within a predetermined positive potential range situated between +0.4 and +0.2 V, while for the electrode based on synthetic-2 the peaks are found at +0.300±0.015 V (vs. Ag/AgCl). The proposed method is reliable for the determination of chromium(III) at trace levels in two vitamin tablets (RSD<0.2%).     

The photolysis of platinacycloalkanes in solution

The photolysis of [I₂$\text{PtCH}{}_2\text{CH}{}_2\text{CH}{}_2\text{C}$H₂ (PMe₂ Ph)₂] gives ethylene and but-1-ene as volatile products, the latter probably being formed via a five-coordinate platinum intermediate. However, the formation of propene from the photolysis of [Cl₂$\text{PtCH}{}_2\text{CH}{}_2\text{C}$H₂ (1,10-phenanthroline) appears to involve a direct transfer of a hydrogen atom between neighbouring CH₂ groups in the ring. Other gaseous products, e.g. cyclopropane, ethylene, may be formed via a platinum ion radical.