Synthesis and characterization of polyaniline doped with organic acids

Spectroscopic [UV–visible and Fourier transform IR (FTIR)] and thermal properties of chemically synthesized polyanilines are found to be affected by varying the protonation media (acetic, citric, oxalic, and tartaric acid). The optical spectra show the presence of a greater fraction of fully oxidized insulating pernigraniline phase in polyaniline doped with acetic acid. In contrast, the selectivity in the formation of the conducting phase is higher in oxalic acid as a protonic acid media. The FTIR spectra of these polymers reveal a higher ratio of the relative intensities of the quinoid to benzenoid ring modes in acetic acid doped polyaniline. Scanning electron micrographs revealed a sponge‐like structure derived from the aggregation of the small granules in acetic acid and oxalic acid doped polyaniline. A three‐step decomposition pattern is observed in all the polymers, regardless of the protonic acid used for the doping. The second step loss related to the loss of dopant is found to be higher in the oxalic acid doped polymer. In accordance with these results the conductivity is also found to be higher in oxalic acid doped material. The temperature dependent conductivity measurements show the thermal activated behavior in all the polymers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2043–2049, 2004     

Microstructural assessment of InN-on-GaN films grown by plasma-assisted MBE

The structural properties of InN thin films, grown by rf plasma-assisted molecular beam epitaxy on Ga-face GaN/Al₂O₃(0001) substrates, were investigated by means of conventional and high resolution electron microscopy. Our observations showed that a uniform InN film of total thickness up to 1 μm could be readily grown on GaN without any indication of columnar growth. A clear epitaxial orientation relationship of , was determined. The quality of the InN film was rather good, having threading dislocations as the dominant structural defect with a density in the range of 10⁹–10¹⁰ cm⁻². The crystal lattice parameters of wurtzite InN were estimated by electron diffraction analysis to be a=0.354 nm and c=0.569 nm, using Al₂O₃ as the reference crystal. Heteroepitaxial growth of InN on GaN was accomplished by the introduction of a network of three regularly spaced misfit dislocation arrays at the atomically flat interface plane. The experimentally measured distance of misfit dislocations was 2.72 nm. This is in good agreement with the theoretical value derived from the in-plane lattice mismatch of InN and GaN, which indicated that nearly full relaxation of the interfacial strain between the two crystal lattices was achieved.     

New Heat-Resistant Polyimidates Derived from Bisphenols and Mono- and Dicarboxylic Acid Imidoyl Chlorides

New polyimidates were prepared from bisphenols and mono- and dicarboxylic acid imidoyl chlorides. The structures of the polymers were determined, and their physicochemical, chemical, and thermal properties were studied. The possibility of preparing film and compression materials with good mechanical characteristics from these polymers was examined.     

A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Effective thermal conductivity of water-saturated sintered powder-metal plates

An experimental apparatus and related procedures for the determination of the effective thermal conductivity of sintered powder-metal plates saturated with distilled water at temperatures in the range 20–150°C are discussed. The apparatus and procedures are applied to two samples of sintered powder-metal plates, one made of nickel 200 and the other of stainless steel 316, with porosities of 28.10 and 46.45%, respectively, and each of nominal dimensions 127 mm × 127 mm × 6.35 mm. The experimental results are compared with corresponding predictions yielded by several correlations available in the literature. The correlations based on experimental data for packed beds of spherical particles and also porous plates made of cold-pressed (but not sintered) particles of angular shapes do not apply well to sintered powder-metal plates. A new correlation, which is based on extensions of ideas contained in earlier works and provides improved predictions, is proposed.     

Two-limit problems for almost semicontinuous processes defined on a Markov chain

We consider almost upper-semicontinuous processes defined on a finite Markov chain. The distributions of functionals associated with the exit of these processes from a finite interval are studied. We also consider some modifications of these processes. __________ Translated from Ukrains’kyi Matematychnyi Zhurnal, Vol. 59, No. 4, pp. 555–565, April, 2007.     

Inverse problems for a mathematical model of redox sorption

We consider a mathematical model of sorption that allows for external diffusion kinetics and a redox reaction. Two inverse problems are considered for this model, uniqueness is proved, and numerical solution methods are proposed. The efficiency of the numerical methods is investigated by computer experiments. __________ Translated from Prikladnaya Matematika i Informatika, No. 23, pp. 15–23, 2006.     

Ultrashort pulse laser osteotomy

Laser treatment of bone tissue has already been the subject of many studies to find substitutes for mechanical instruments that are nowadays used in implantology and orthopaedics. Mainly lasers with pulse durations in the μs region have been tested leaving surface features that are not always satisfactory. Therefore, in the present study laser osteotomy has been performed with a 330 fs Yb:glass laser, λ = 1040 nm, at a pulse repetition rate of 1 kHz. For bovine spongiosa, compacta, and cartilage, the ablation thresholds as well as the ablation rates for various pulse energies have been determined. Additionally, quadratic areas have been ablated in bone tissue. The remaining morphology has been analyzed via scanning electron microscopy. Laser ablation has also been performed with an Er, Cr:YSGG laser, λ = 2780 nm, PRR = 20 Hz, τ ～ 50 μs. The results of USPL and Erbium laser ablation are compared.     

Diffusion,solubility, and electrical properties of scandium and praseodymium in silicon

An integrated study of diffusion, solubility, and electrical properties of scandium and praseodymium in silicon annealed in various media and temperature ranges (1100–1280 °C) was performed for the first time. The tracer technique, autoradiography, measurements of isothermic capacity and current relaxation, conductivity, and the Hall effect were used for the investigations. The diffusion parameters, solubility, and an acceptor character of scandium and praseodymium impurities in silicon were determined. __________ Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 1, pp. 75–77, January, 2007.