Research problems

This section appears from time to time. Contributions are invited, and should be submitted to R. C. Thompson, Mathematics Department, University of California, Santa Barbara, CA 93106.     

Synthesis and characterization of polyaniline doped with organic acids

Spectroscopic [UV–visible and Fourier transform IR (FTIR)] and thermal properties of chemically synthesized polyanilines are found to be affected by varying the protonation media (acetic, citric, oxalic, and tartaric acid). The optical spectra show the presence of a greater fraction of fully oxidized insulating pernigraniline phase in polyaniline doped with acetic acid. In contrast, the selectivity in the formation of the conducting phase is higher in oxalic acid as a protonic acid media. The FTIR spectra of these polymers reveal a higher ratio of the relative intensities of the quinoid to benzenoid ring modes in acetic acid doped polyaniline. Scanning electron micrographs revealed a sponge‐like structure derived from the aggregation of the small granules in acetic acid and oxalic acid doped polyaniline. A three‐step decomposition pattern is observed in all the polymers, regardless of the protonic acid used for the doping. The second step loss related to the loss of dopant is found to be higher in the oxalic acid doped polymer. In accordance with these results the conductivity is also found to be higher in oxalic acid doped material. The temperature dependent conductivity measurements show the thermal activated behavior in all the polymers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2043–2049, 2004     

Numerical study of simultaneous natural convection heat transfer from both surfaces of a uniformly heated thin plate with arbitrary inclination

 Numerical studies were conducted to investigate the natural convection heat transfer around a uniformly heated thin plate with arbitrary inclination in an infinite space. The numerical approach was based on the finite volume technique with a nonstaggered grid arrangement. For handling the pressure–velocity coupling the SIMPLE-algorithm was used. QUICK scheme and first order upwind scheme were employed for discretization of the momentum and energy convective terms respectively. Plate width and heating rate were used to vary the modified Rayleigh number over the range of 4.8×10⁶ to 1.87×10⁸. Local and average heat transfer characteristics were compared with regarding to the inclination angle. The empirical expressions for local and average Nusselt number were correlated. It has been found that for inclination angle less than 10^∘, the flow and heat transfer characteristics are complicated and the average Nusselt number can not be correlated by one equation while for inclination angle larger than 10^∘, the average Nusselt number can be correlated into an elegant correlation. Received on 18 April 2001 / Published online: 29 November 2001     

A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Effective thermal conductivity of water-saturated sintered powder-metal plates

An experimental apparatus and related procedures for the determination of the effective thermal conductivity of sintered powder-metal plates saturated with distilled water at temperatures in the range 20–150°C are discussed. The apparatus and procedures are applied to two samples of sintered powder-metal plates, one made of nickel 200 and the other of stainless steel 316, with porosities of 28.10 and 46.45%, respectively, and each of nominal dimensions 127 mm × 127 mm × 6.35 mm. The experimental results are compared with corresponding predictions yielded by several correlations available in the literature. The correlations based on experimental data for packed beds of spherical particles and also porous plates made of cold-pressed (but not sintered) particles of angular shapes do not apply well to sintered powder-metal plates. A new correlation, which is based on extensions of ideas contained in earlier works and provides improved predictions, is proposed.     

Finite element method in the solution of the Euler and Navier-Stokes equations for internal flow

Finite element solutions of the Euler and Navier-Stokes equations are presented, using a simple dissipation model. The discretization is based on the weak-Galerkin weighted residual method and equal interpolation functions for all the unknowns are permitted. The nonlinearity is iterated upon using a Newton method and at each iteration the linear algebraic system is solved by a direct solver with all unknowns fully coupled. Results are presented for two-dimensional transonic inviscid flows and two- and three-dimensional incompressible viscous flows. Convergence of the algorithm is shown to be quadratic, reaching machine accuracy in very few iterations. The inviscid results demonstrate the existence of nonunique numerical solutions to the steady Euler equations.     

Inverse problems for a mathematical model of redox sorption

We consider a mathematical model of sorption that allows for external diffusion kinetics and a redox reaction. Two inverse problems are considered for this model, uniqueness is proved, and numerical solution methods are proposed. The efficiency of the numerical methods is investigated by computer experiments. __________ Translated from Prikladnaya Matematika i Informatika, No. 23, pp. 15–23, 2006.