Comparison of the boundary theory with the contact rule of phase regions and Gupta’s method

The phase boundary theory and the contact rule of phase regions are compared, and some weaknesses of the latter are manifested. The comparison between the Gupta’s method and the boundary theory method for constructing multicomponent isobaric sections is also presented.     

High energy quantum teleportation using neutral kaons

We describe a scheme of stochastic implementations of quantum teleportation and entanglement swapping in terms of neutral kaons. In this scheme, the kaon whose state is to be teleported collides with one of the two entangled kaons in an Einstein–Podolsky–Rosen state. Subsequent detection of the outgoing particles of the collision completes the two-qubit projection on Alice side. There appear novel features, which connects quantum information science with fundamental laws of particle physics.     

Non-Euler–Lagrangian Pareto-optimality Conditions for Dynamic Multiple Criterion Decision Problems

In this paper the problem of verifying the Pareto-optimality of a given solution to a dynamic multiple-criterion decision (DMCD) problem is investigated. For this purpose, some new conditions are derived for Pareto-optimality of DMCD problems. In the literature, Pareto-optimality is characterized by means of Euler-Lagrangian differential equations. There exist problems in production and inventory control to which these conditions cannot be applied directly (Song 1997). Thus, it is necessary to explore new conditions for Pareto-optimality of DMCD problems. With some mild assumptions on the objective functionals, we develop necessary and/or sufficient conditions for Pareto-optimality in the sprit of optimization theory. Both linear and non-linear cases are considered.     

纳米颗粒悬浮液池内泡状沸腾的实验研究

本文对纳米颗粒悬浮液在平壁面上池内沸腾进行了实验研究。实验用的纳米粒子为26 nm的铁粉和13 nm的三氧化二铝纳米粉末,基液为去离子水。分别配成体积浓度为0．1％, 1％和2％的悬浮液。实验结果表明,纳米悬浮颗粒对液体沸腾换热过程的影响会随着纳米颗粒性质,颗粒浓度及热流密度大小的不同而出现不同的效果;加入纳米颗粒后, 对基液沸腾换热的影响存在着两个相反的作用机制,它们分别为:纳米颗粒增强了液体内部的热量迁移能力(热物性的影响)和改变了加热面的表面结构特性(加热面特性的影响)。     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

Recognition of the Finite Simple Groups F 4(2m) by Spectrum

The spectrum of a finite group is the set of its element orders. A finite group G is said to be recognizable by spectrum, if every finite group with the same spectrum as G is isomorphic to G. The purpose of the paper is to prove that for every natural m the finite simple Chevalley group F ₄(2 ^m ) is recognizable by spectrum.     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

Lame Function and Its Application to Some Nonlinear Evolution Equations

In this paper, based on the Lame function and Jacobi elliptic function, the perturbation method is appliedto some nonlinear evolution equations to derive their multi-order solutions.     

Approximate confidence limits of the reliability performances for a cold standby series system

This paper is to investigate the approximate confidence limits of the reliability performances (such as failure rate, reliability function and average life) for a cold standby series system. The Bayesian approximate upper confidence limit of failure rate is obtained firstly, and next Bayesian approximate lower confidence limits for reliability function and average life are presented. The expressions for calculating Bayesian lower confidence limits of the reliability function and average life are also obtained, and an illustrative example is examined numerically by means of the Monte-Carlo simulation. Finally, the accuracy of confidence limits is discussed.