A comparison of master equation and Fokker-Planck equation in the thermodynamic limit

The master equation and the Fokker-Planck equation are compared thoroughly in both of the stationary and the time-dependent cases for a one-dimensional system. The comparison includes the master equation without detailed balance.     

灰色Verhulst模型的样条插值函数的残差修正

本用样条函数对灰色Verhulst模型的残差序列进行插值拟合，然后作用于二阶线性微分方程，并以此修正原模型，得到一种新的预测模型的数值解，提高了拟合的精确度。     

纯生跳跃扩散型交换期权定价公式

在假定标的资产价格服从纯生跳跃过程的条件下,研究一类多资产期权——资产权重不同的交换期权,并在风险中性的条件下建立相应的定价方程,运用条件期望等相关知识得出交换期权的解析公式。文中最后列出一些特殊纯生跳跃扩散型交换期权的定价的例子.     

Matrix representation of three-dimensional astigmatic resonators

Three-dimensional astigmatic resonators, typical examples of which are the resonators bounded by cylindrical-spherical mirrors and cylindrical-cylindrical mirrors oriented at an arbitrary crossed angle, are investigated in detail by using a complex curvature tensor concept and generalized tensor ABCD law. Computerized numerical calculations illustrate some interesting characteristics of these astigmatic resonators.     

Effect of carbon content on the microstructure and the cracking susceptibility of Fe-based laser-clad layer

The laser cladding of Fe-based alloys on a medium carbon steel substrate was performed using a CO₂ laser and Ar shielding gas that was blown into a molten pool. The microstructure and cracking susceptibility of the laser-clad layers were studied in terms of carbon additions. Results show that the small change of the carbon content in the alloy powders can obviously change the microstructure and properties of the layers. When the carbon content is in the range of 0.3–0.4 wt.%, the decrease of the carbon content in alloy powders will increase the hardness and toughness of the layers simultaneously under the same process parameters. As a result, crack-free coatings with high hardness can be obtained. As the carbon content increases from 0.2 wt.% to 0.4 wt.%, the segregation ratio of chromium increases, while the segregation ratios of nickel, manganese, and silicon first decrease and then increase. At the same time, a new designing principle concerning the composition and microstructure has been put forward, and the principal mechanisms of strengthening and toughening of the layers are fine-grain strengthening and low carbon martensitic phase transformation strengthening.     

矩阵方程（A^TXA，B^TXB=（C，D）的反对称解及其最佳逼近

本利用矩阵对的标准相关分解，得到了矩阵方程(A^TXB，B^TXB)=(C，D)反对称解存在的充分必要条件及通解表达式，同时给出了解关于已知矩阵的最佳逼近．     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

Triterpenoid Constituents of Huperzia miyoshiana

Thirteen triterpenoids, including three new ones, miyoshianois A (1), B (2) and C (3), were isolated from Huperzia miyoshiana. The structures of these new compounds were established as 3-O-dihydroferuloyltohogenol (1), 16-oxo-3β,21β-dihydrox-y-serrat-14-en-24-ferulate (2) and 16-oxo-3a, 21β-dihydroxy-serrat-14-en-24-ferulate (3), respectively, on the basis of their spectroscopic analysis.     

求解非对称线性方程组的QMRGCGS方法

1 引言 求解非对称线性方程组Ax=b的双共轭梯度方法(BCG)[3]和它的变形共轭梯度平方方法(CGS)[6]都有典型的不规则收敛行为,后来Freund和Nachtigal提出一种BCG类方法,即拟极小剩余方法(QMR)[7],用来补救BCG方法的收敛性并且产生了光滑的收敛曲线。然而,象BCG方法一样,QMR方法要用到系数矩阵A及其转置A~T与向量的乘积,为了解决这一问题,Freund提出TFQMR方法,此方法具有拟极小剩余性,同时不需用到A~T与向量的乘积。