镁掺杂氧化铈整体式催化剂催化CO2和CH3OH直接合成碳酸二甲酯

采用共沉淀法成功地合成了不同Mg掺杂量的Ce_1-xMg_xO₂(x=0.05、0.10、0.15、0.20)固溶体催化材料,并运用透射电子显微镜(TEM)、X射线衍射(XRD)、氮气吸附-脱附测试、拉曼光谱、X射线光电子能谱(XPS)、CO₂程序升温脱附(CO₂-TPD)等技术对这些材料进行了表征。结果发现,通过调控CeO₂晶格中Mg的含量,可以调控所制备的Ce_1-xMg_xO₂催化材料的粒径、比表面积、表面缺陷等。其中Ce_0.90Mg_0.10O₂展现了最佳的表面性质,具有最小的平均粒径(约5.8 nm),最大的比表面积(约136 m2·g^-1)以及最高的表面氧含量(31.98%)。将Ce_1-xMg_xO₂催化材料涂覆在堇青石蜂窝陶瓷上制成整体催化剂,考察其对CO₂和CH₃OH直接合成碳酸二甲酯的催化性能。在140℃、2.4 MPa、反应2 h的条件下,Ce_0.90Mg_0.10O₂整体催化剂上碳酸二甲酯的收率高达20.21%,催化效果明显优于CeO₂和其余的Ce_1-xMg_xO₂(x=0.05、0.15、0.20)催化材料。     

改进布里奇曼法生长HgCdTe晶体的生长速度对固液界面形态的影响

为选择合理的晶体生长速度,在用改进Bridgman法生长直径为φ19mm的HgCdTe(x=0.21)晶体过程中,对正在生长的单晶体及熔体进行淬火,以观察其固液界面形态.初步的实验结果表明:在2mm/d及9mm/d的两种生长速度条件下,石英安瓶中的固液界面形态均为凹形抛物面,但其凹陷深度分别为10mm和14mm.较低的晶体生长速度条件下,凹陷深度较小,固液界面形态较平.由实验和讨论得知,宜选择较低的晶体生长速度用改进Bridgman法生长HgCdTe晶体.     

时域边界元法分析撞水响应

基于势流理论，考虑流场的可压缩性，首先利用积分变换导得了势流问题的一个动力学倒易定理，在此基础上，进而求得问题对应的时空边界积分方程，然后通过对边界和时间轴同时离散，建立了一组有递推形式的时间边界元方程最后结合液面条件和物体运动方程耦全求解得到了刚体的撞水响应。     

An Optimal Nonlinear Feedback Control Strategy for Randomly Excited Structural Systems

A strategy for optimal nonlinear feedback control of randomlyexcited structural systems is proposed based on the stochastic averagingmethod for quasi-Hamiltonian systems and the stochastic dynamicprogramming principle. A randomly excited structural system isformulated as a quasi-Hamiltonian system and the control forces aredivided into conservative and dissipative parts. The conservative partsare designed to change the integrability and resonance of the associatedHamiltonian system and the energy distribution among the controlledsystem. After the conservative parts are determined, the system responseis reduced to a controlled diffusion process by using the stochasticaveraging method. The dissipative parts of control forces are thenobtained from solving the stochastic dynamic programming equation. Boththe responses of uncontrolled and controlled structural systems can bepredicted analytically. Numerical results for a controlled andstochastically excited Duffing oscillator and a two-degree-of-freedomsystem with linear springs and linear and nonlinear dampings, show thatthe proposed control strategy is very effective and efficient.     

大开口复合材料加筋壁板稳定性分析

运用大型有限元软件Patran/Nastran分析了大开口复合材料加筋壁板的稳定性,并对不同加筋方式下壁板屈曲特征值和屈曲模态图进行了比较。结果表明:补强提高了大开口复合材料壁板的稳定性,但往往无法达到很好的效果,需要通过加筋改善其稳定性;加筋复合材料壁板稳定性较原有模型有较大提高;加筋大开口复合材料壁板屈曲特征值随筋条距开口中心距离的增加而减小,其屈曲分界线均位于筋条布置处;纵筋大开口复合材料加筋壁板一阶屈曲特征值为2.13,而横筋只达到1.08;纵筋布置对复合材料壁板稳定性影响明显高于横筋布置,可在实际工程应用中适当增加纵筋的布置。     

含氮杂环类润滑油添加剂CoMFA-QSTR及CoMSIA-QSTR抗磨损性能模型的构建

依据摩擦学定量构效关系理论(QSTR),采用比较分子力场分析(CoMFA)和比较分子相似性指数分析(CoMSIA)这两种方法研究了含氮杂环类润滑油添加剂的抗磨损性能的摩擦学三维定量构效关系(3D-QSTR),并建立了相应的3D-QSTR模型.结果表明:仅利用静电场构建CoMFA或CoMSIA模型时,模型预测能力最好,r~2,q~2均大于0.5.根据CoMFA或CoMSIA模型等高线图分析得出:分子静电场对含氮杂环类润滑油添加剂的抗磨损性能影响最大,在特定区域的引入带负电荷或带正电荷的基团将有助于抗磨性能的提高.     

不同倾角预制裂纹缺陷与运动裂纹的相互作用

为了研究运动裂纹与不同倾角预制裂纹缺陷之间的作用机制,采用数字激光动态焦散线方法对含不同倾角预制裂纹缺陷的三点弯曲梁进行冲击实验。研究结果表明,在冲击载荷作用下,预制裂纹缺陷尖端均产生了次生裂纹;当运动主裂纹与预制裂纹缺陷贯通时,次生裂纹不会立即起裂,而是经过0~10 μs的能量积蓄后,次生裂纹才起裂;运动主裂纹应力强度因子峰值与次裂纹起裂时的应力强度因子值均随预制裂纹倾角的增大而增大。     

仿生非光滑表面铸铁材料的常温摩擦磨损性能

模仿动物体表形态,在试样表面通过激光雕刻出有规则分布的凹坑以及条纹等非光滑单元体,研究了具有非光滑表面材料的摩擦磨损性能.结果表明:非光滑表面材料的耐磨性较光滑表面提高1倍以上,摩擦系数提高66%以上;当非光滑表面的单元体硬度越高、直径越大和间距越小时,其耐磨性能越好,摩擦系数越大.这是由于激光加工的单元体相当于在母体上增加了许多强化质点,比母体具有较高的硬度和致密性,能够提高抗磨性,增加表面粗糙度,所以其耐磨性提高,摩擦系数增大.     

A SIMPLIFIED CALCULATING METHOD OF NONLINEAR FREQUENCY OF CABLE NET UNDER MEAN WIND LOAD

The cable net supported glass curtain wallas the most advanced technique in dot point supported glass curtain wall, is widely used in China. Because of its large deflection and high nonlinearity under wind load, the dynamic performance of the cable net is greatly different from that of the conventional linear structures. The continuous membrane theory is used to construct the nonlinear vibration differential equation of the cable net, and the harmonic balance method is used to solve the analytic formula of the nonlinear frequency. In order to verify the accuracy of the above analytic formula, the results of the formula and the nonlinear FEM time-history method are compared and found to be in good agreement. Furthermore, the nonlinear vibration differential equation and the nonlinear frequency obtained in this paper are the basis for the wind-induced response analysis of a cable net under fluctuating wind load.     

The reactions of ground state Cu+ and Fe+ with the 20 common amino acids

A systematic investigation of the gas-phase reactions of Cu⁺ and Fe⁺ with the 20 common amino acids is reported. Metal ions are formed by laser ablation of a metal target and are trapped in the analyzer cell of a Fourier transform mass spectrometer. By using quadrupolar excitation to axialize the metal ions, tens of thousands of thermalizing collisions occur prior to their reactions with laser-desorbed amino acid neutral molecules. Amino acids with nonpolar side chains are found to be more reactive toward Cu⁺ and Fe⁺ than amino acids with polar side chain. Many of the nonpolar amino acids are found to undergo dissociative metal attachment with a neutral loss of 46 u. A ¹³C-labeling experiment shows that the carboxyl group is lost during dissociative metal attachment to amino acids. Together these results suggest that these metal ions interact primarily with the carboxyl functional group in these molecules.