Temperature dependence of pressure broadening of NH3 perturbed by H2 and N2

The temperature dependence of pressure broadening of 134 rovibrational transitions of several branches in the ν₄ and 2ν₂ bands of ammonia perturbed by H₂ and N₂ has been measured using a high-resolution Fourier transform spectrometer. The temperature range covered during the experiments was between 235 and 296 K. The pressure-broadening linewidths were obtained using the method of multipressure fitting to the measured shapes of the lines. These broadenings were also calculated using a semiclassical model leading to a reasonable agreement with the observations and reproduces well the strong systematic experimental J and K quantum number dependencies. The retrieved values of the linewidths, along with those previously determined from the spectra at room temperature, were used to derive the temperature dependence of both H₂ and N₂ broadening of NH₃ lines. The broadening coefficients were shown to fit closely the well-known exponential law. For both experimental and theoretical results, the temperature exponent n has been obtained. Careful inspection of the experimental values shows that, contrary to the linewidths, the coefficient n is nearly K independent within each J multiplet. Also for a given J it does not seem to exhibit any noticeable variation with the type of rotational transition. On the other hand, the calculated n values exhibit a strong J and K systematic dependencies. n increases with K for a given J, decreases with J for a given K and are independent of the type of rotational transition.     

Surface roughness investigation of semi-conductor wafers

Conventionally, surface roughness is predominantly determined through the use of stylus instruments. However, there are certain limitations involved in the method, particularly when a test specimen, such as a silicon wafer, has a smooth mirror-like surface. Hence, it is necessary to explore alternative non-contact techniques. Light scattering has recently been gaining popularity as an optical technique to provide prompt and precise inspection of surface roughness. In this paper, the total integrated scattering (TIS) model is modified to retrieve parameters on surface micro-topography through light scattering. The applicability of the proposed modified TIS model is studied and compared with an atomic force microscope. Experimental results obtained show that the proposed technique is highly accurate for measuring surface roughness in the nanometer range.     

The K–nucleus cross sections in relativistic non-linear models

The K⁺−nucleus cross sections have been calculated in relativistic non-linear models taking into account the in-medium modifications of nucleons and mesons properties. More precisely, we have taken into account both the dressing of the nucleon effective mass by the scalar nuclear field in the target and the coupling of the mesons exchanged between the K⁺ and the nucleons to the polarization of the medium. First, using the most recent relativistic non-linear models, the in-medium σ, ω and ρ meson masses have been obtained in the nuclear matter rest frame. The influence of the non-linear contributions on the K⁺−nucleus cross sections has then been studied. Finally, we have compared our results with the experimental data.     

Synthesis and characterization of poly(methyl methacrylate)‐block‐poly(methylphenylsilane)‐ block‐poly(methyl methacrylate) by atom transfer radical polymerization

ABA block copolymers of methyl methacrylate and methylphenylsilane were synthesized with a methodology based on atom transfer radical polymerization (ATRP). The reaction of samples of α,ω‐dihalopoly(methylphenylsilane) with 2‐hydroxyethyl‐2‐methyl‐2‐bromoproprionate gave suitable macroinitiators for the ATRP of methyl methacrylate. The latter procedure was carried out at 95 °C in a xylene solution with CuBr and 2,2‐bipyridine as the initiating system. The rate of the polymerization was first‐order with respect to monomer conversion. The block copolymers were characterized with ¹H NMR and ¹³C NMR spectroscopy and size exclusion chromatography, and differential scanning calorimetry was used to obtain preliminary evidence of phase separation in the copolymer products. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 30–40, 2003     

Vanishing Fisher Information

There are consistently estimable parameters of interest whose semiparametric Fisher information vanishes at some points of the model in question. Here we investigate how bad this is for estimation.     

A comparison of a theoretical model for quasi-statically and dynamically induced environmental vibration from trains with measurements

This paper presents comparisons between a theoretical ground vibration model and measured data at three sites. The model, which is briefly outlined here, encompasses both the quasi-static and dynamic mechanisms of excitation. The vertical dynamics of a number of vehicles travelling at a constant speed on an infinite track are coupled to a semi-analytical model for a three-dimensional layered ground. This model is also used to demonstrate the roles of the two components of vibration at different frequencies and for train speeds below and above the lowest ground wave speed. It is found that, in most practical cases, the dynamic component gives rise to the higher level of vibration.     

Accurate Gain Flattening Filters Manufactured by Optical Compensation Monitoring Method

GFFs with less than 0.4 dB peak-to-peak error functions are routinely fabricated using commercially available coating machines by utilizing the natural error compensation mechanism of wavelength variable turning point optical monitoring method.     

Microtraps and Atom Chips: Toolboxes for Cold Atom Physics

Magnetic microtraps and Atom Chips are safe, small-scale, reliable and flexible tools to prepare ultra-cold and degenerate atom clouds as sources for various atom-optical experiments. We present an overview of the possibilities of the devices and indicate how a microtrap can be used to prepare and launch a Bose-Einstein condensate for use in an atom clock or an interferometer.     

Conductance of a multiterminal ballistic wire

JETP Letters - An experimental study of the two-, three-, and four-terminal resistance of a ballistic wire is carried out. The wire is fabricated on the basis of high-mobility 2D electron gas in an...     

Sterically stabilized emulsion polymerization of styrene: Pseudo‐semicontinuous approach

The sterically stabilized emulsion polymerization of styrene initiated by a water‐soluble initiator at different temperatures has been investigated. The rate of polymerization (R_p) versus conversion curve shows the two non‐stationary‐rate intervals typical for the polymerization proceeding under non‐stationary‐state conditions. The shape of the R_p versus conversion curve results from two opposite effects—the increased number of particles and the decreased monomer concentration at reaction loci as the polymerization advances. At elevated temperatures the monomer emulsion equilibrates to a two‐phase or three‐phase system. The upper phase is transparent (monomer), and the lower one is blue colored, typical for microemulsion. After stirring such a multiphase system and initiation of polymerization, the initial coarse polymer emulsion was formed. The average size of monomer/polymer particles strongly decreased up to about 40% conversion and then leveled off. The initial large particles are assumed to be highly monomer‐swollen particles formed by the heteroagglomeration of unstable polymer particles and monomer droplets. The size of the “highly monomer” swollen particles continuously decreases with conversion, and they merge with the growing particles at about 40–50% conversion. The monomer droplets and/or large highly monomer‐swollen polymer particles also serve as a reservoir of monomer and emulsifier. The continuous release of nonionic (hydrophobic) emulsifier from the monomer phase increases the colloidal stability of primary particles and the number of polymer particles, that is, the particle nucleation is shifted to the higher conversion region. Variations of the square and cube of the mean droplet radius with aging time indicate that neither the coalescence nor the Ostwald ripening is the main driving force for the droplet instability. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 804–820, 2003