无标度网络上队列资源分配研究

研究了节点队列资源有限的条件下,无标度网络上的信息流动力学过程,发现了网络由自由流通到拥塞的相变现象,提出了一种基于节点度的队列资源分配模型.模型的核心是使节点i的队列长度与kβi成正比(ki为节点i的度,β为分配参数).仿真结果表明,在网络使用最短路径算法进行信息包传送的条件下,β近似等于1.25时队列资源分配最合理,网络容量最大,且该最佳值与队列总资源多少以及网络的规模无关.     

混沌光场光子统计分布及二阶相干度的分析与测量

利用通信波段双通道单光子探测器,采用Hanbury Brown-Twiss关联测量方案,理论分析并实验测量了光反馈半导体激光器产生的混沌光场的光子统计分布及不同混沌状态光场的二阶相干度.通过对混沌光场二阶相干度g~((2))(τ)的理论分析,得出随着延迟时间和相干时间的变化,其与相干光、热光及单光子态的二阶相干度可明显区分并呈现出不同分布.同时实验上产生了频谱宽度6.7 GHz的混沌光场,测量了不同光子数分布的结果,并用高斯随机分布、泊松分布、玻色-爱因斯坦分布对光子数分布进行理论拟合,发现随着入射平均光子数的增加,光子数分布从玻色-爱因斯坦分布过渡到泊松分布,但整个过程都与高斯随机分布符合较好,且光场的二阶相干度g~((2))(0)由2降至1.通过改变偏置电流(I=1.0Ith-2.0Ith)和反馈强度(0—10%),实验上研究了混沌光场由低频起伏到相干塌陷的过程中不同状态宏观动力学特性与二阶相干度的对应关系.结果表明:混沌光场在此过程中始终呈现出明显的聚束效应,并在频谱宽度最大时达到最强;同时给出了光子计数测量中聚束效应减弱的物理原因.实验表明该系统及方法能很好地揭示不同状态混沌光场的光子统计特性.     

Enhanced flux-pinning in fluorine-free MOD YBCO films by chemical doping

YBCO films without and with dilute cobalt and zinc doping were prepared on (0 0 l) LaAlO₃ substrate by non-fluorine metal organic deposition method. Effects of dilute cobalt and zinc doping on biaxial texture, microstructure and flux-pinning properties of YBCO films were investigated. The surface density and smoothness of the doped YBCO films have been distinctly improved compared with that of the pure film. Dilute cobalt- and zinc-doped YBCO films exhibit significantly enhanced J_c values in the magnetic field. The best result is achieved in the cobalt-doped YBCO film. At 77 K, J_c values of cobalt-doped film are 1.7 and 5.4 times higher than that of pure film in 0.5 T and 1.5 T, respectively. These results strongly suggest that dilute cobalt and zinc doping is a promising way to increase the current carrying capability of YBCO films.     

Coherent Beam Combination of Eight Watt-Level Polarization-Maintained Fiber Amplifiers

We demonstrate the coherent beam combination of eight Watt-level polarization-maintained fiber amplifiers. The phase control signal of each amplifier is generated by running a stochastic parallel gradient descent algorithm on a digital signal processor （DSP）. The experimental result shows that the whole system in close-loop performs well for long-time observation. Energy encircled in the target pinhole is 6.68 times more than that in open-loop. The combination efficiency is as high as 84.5%.     

Compact and portable terahertz source by mixing two frequencies generated simultaneously by a single solid-state laser

We have demonstrated a compact and portable terahertz (THz) source, based on difference-frequency generation in a GaSe crystal. The two input frequencies, required for achieving frequency mixing, are generated by a single Q-switched Nd:YLF laser incorporating two laser resonators. The average power of the THz output reaches 1 μW at 1.64 THz (182 μm) within a linewidth of 65 GHz. Such a THz source can be packaged into a compact and portable system.     

Charge/discharge characteristics of sulfur composite electrode at different temperature and current density in rechargeable lithium batteries

The charge/discharge characteristics of the sulfur composite cathodes were investigated at different temperatures and different current densities. The composite presented the discharge capacities of 854 and 632 mAh g⁻¹ at 60 and −20 °C, respectively, while it had the discharge capacities of 792 mAh g⁻¹ at 25 °C. The composite presented the discharge capacities of 792 and 604 mAh g⁻¹ at 55.6 and 667 mA g⁻¹, respectively, at room temperature. The results showed that the sulfur composite cathodes presented good charge/discharge characteristics between 60 and −20 °C and at a high c-rate up to 667 mA g⁻¹.     

The thermal activation of cummulative fatigue damage at ultrasonic frequencies

Internal friction, modulus defects and the initial occurrence of slip lines on the surface of armco iron specimens were studied during and after loading at 22.5 kHz, at temperatures of 296, 333, 373 and 423 K and with strain amplitudes ranging from 1.5 × 10^-7 to 4 × 10^-4. At a particular strain, amplitude dependent internal friction begins, the modulus starts to change and the slip lines may be observed. These strain amplitudes are thermally affected by activation energies of 25.1, 16.7 or 13.6 J kmol^-1 as defined by the Arrhenius equation.     

顺丁烯二酸酐均相加氢制琥珀酸酐和γ-丁内酯

研究了不同过渡金属催化体系对顺丁烯二酸酐均相催化加氢的催化作用,结果表明,对于顺丁烯二酸酐均相催化加氢生成琥珀酸酐和γ－丁内酯,三氯化钌／三苯基膦是较佳催化剂体系,在此催化剂体系作用下,顺丁烯二酸酐催化加氢仅生成琥珀酸酐和γ－丁内酯,无其它副产物生成,还考察了溶剂,三苯基膦／钌摩尔比,反应温度、氢气压力对顺酐催化加氢生成琥珀酸酐和γ－丁内酯选择性的影响,在适当的反应条件下,顺丁烯二酸酐均相加氢可高     

两个光纤激光器的互相注入锁定

光纤激光器的相干合成技术是实现高功率、高亮度光纤激光系统的重要技术途径.利用分束器分光使两个光纤激光器的能量互相注入，从而使两个光纤激光器达到锁相锁模实现相干输出. 实验研究表明：在独立运行的情况下，两个光纤激光器的远场光斑只是两个激光器光强的简单叠加；在互相注入锁定的情况下，两个光纤激光器的远场光斑是具有高对比度的干涉条纹，并得到两个激光器的输出模式总为异相模.这与理论分析的结果相一致. 关键词： 光纤激光器 相干合成 锁相     

Adaptive generalized functional synchronization of chaotic systems with unknown parameters

A universal adaptive generalized functional synchronization approach to any two different or identical chaotic systems with unknown parameters is proposed, based on a unified mathematical expression of a large class of chaotic system. Self-adaptive parameter law and control law are given in the form of a theorem. The synchronization between the three-dimensional R6ssler chaotic system and the four-dimensional Chen＇s hyper-chaotic system is studied as an example for illustration. The computer simulation results demonstrate the feasibility of the method proposed.