Three-Stage Extraction of Gelatines from Tendons of Abattoir Cattle: 2—Properties of Gelatines

The subject of our previous paper (part 1) was three-stage extraction of gelatines from short cattle tendons. In this paper, we studied influence of extraction conditions on quality of produced gelatines??protein content, ash content, rigidity of gelatine gels, viscosity, and distribution of molecular weights. Ash content of gelatines ranged in limits 3.5?C10.5?%. Rigidity of the gels was influenced by extraction conditions and by elastin content in gelatines; highest-quality gels display rigidity of 213 Bloom. Viscosity of gelatines ranged from 2.47 to 12.11?mPa?s. Molecular weights of gelatines display a proportion of fractions from 20 to 36?kDa, a quite high proportion of fractions from approximately 50 to 100?kDa, in some cases even fractions above 200?kDa appear. It was found that transition temperature and melting temperature of gelatines extracted from tendons are in accord with data on gelatines obtained by traditional extraction techniques from skins and bones. With respect to efficiency of the whole extraction process and to quality of extracted gelatine, we may recommend extraction conditions as follows: in the 1st processing stage, shaking degreased starting material with water in ratio 1:10 at 25?°C for 5?h; in the 2nd stage, treating the swelled material with 5?% (w/w) added proteolytic enzyme at 40?°C for 25?h; in 3rd stage, extracting gelatine while boiling for 16?min.     

Sorption of methanol,dimethyl carbonate,methyl acetate,and acetone vapors in CTA and PTMSP: General findings from the GAB Analysis

Sorption of vapors of four organic compounds in two glassy polymers, cellulose triacetate (CTA) and poly[(trimethylsilyl)propyne] (PTMSP), has been reported and analyzed in terms of Guggenheim‐Anderson‐De Boer (GAB) model. These two structurally and physicochemically different glassy polymers both independently showed that one sorption site was formed by about three monomeric units. This finding held true for vapors of all characterized compounds; that is, for methanol, for its derivatives dimethyl carbonate and methyl acetate, and for acetone. The “rule of three” might thus also be applicable to other sorbates and glassy polymers. Further, an original modification of the GAB model for the sorption of alcohols in PTMSP was derived and successfully tested. Overall, the analyses of the sorption isotherms, heats of sorption and diffusion coefficients supported the view that the sorption of vapors in glassy polymers has adsorptive nature. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2016 , 54, 561–569     

Immunosensor for the Measurement of Human Serum Albumin in Urine Based on the Spreeta Surface Plasmon Resonance Sensor

The application of SPR for measurement of the concentration of human serum albumin (HSA) in urine was studied using the compact integrated SPR sensing system Spreeta. HSA was immobilized via cystamine and glutaraldehyde onto the gold sensing area and a competitive assay for HSA was developed using a limited amount of the monoclonal antibody AL-01 in solution. Measurements were carried out in the flow-through mode and the interaction between immobilized HSA and antibody was observed in real time. To obtain reproducible results, different conditions of the measurement (method of immobilization of HSA, data evaluation, concentration of antibody, regeneration procedure) were tested. The calibration curve for clinically relevant concentrations of HSA in urine samples was constructed using 300-times diluted antibody in the form of ascites fluid. The measuring range was between 0.1 and 5 mg/l of HSA, the sensing surface was successfully regenerated and suitable for more than 20 assays. The developed method was tested on real samples of urine; to overcome the non-specific adsorption of urine components, the differential approach was adopted and the measured signal was corrected by subtraction of the response observed in the absence of the antibody.     

In-syringe magnetic-stirring-assisted liquid–liquid microextraction for the spectrophotometric determination of Cr(VI) in waters

A fully automated method for the determination of chromate is described. It is based on the selective reaction of Cr(VI) with diphenylcarbazide in acidic media to form a colored complex of Cr(III) with the oxidation product diphenylcarbazone. The reaction was performed within the syringe of an automatic burette containing a magnetic stirrer for homogenization of the sample and the required reagents. In-syringe stirring was made possible using a specially designed driving device placed around the syringe barrel to achieve a rotating magnetic field in the syringe, forcing the stirrer to spin. In a second step, the reaction mixture in the syringe was neutralized to allow in-syringe magnetic-stirring-assisted dispersive liquid–liquid microextraction of the complex into 125 μL of n-hexanol. After phase separation by droplet flotation over 30 s, the organic phase was propelled into a coupled spectrophotometric detection cell. The entire multistep procedure including in-system standard preparation was done within 270 s. The method was used for the analysis of natural waters, achieving average analyte recovery of 103 %, a limit of detection of 0.26 μg L^-1, and a repeatability of less than 4 % relative standard deviation.     

Green chromatography separation of analytes of greatly differing properties using a polyethylene glycol stationary phase and a low-toxic water-based mobile phase

A simple, rapid, and environmentally friendly HPLC method was developed and validated for the separation of four compounds (4-aminophenol, caffeine, paracetamol, and propyphenazone) with different chemical properties. A “green” mobile phase, employing water as the major eluent, was proposed and applied to the separation of analytes with different polarity on polyethylene glycol (PEG) stationary phase. The chromatography separation of all compounds and internal standard benzoic acid was performed using isocratic elution with a low-toxicity mobile phase consisting of 0.04 % (v/v) triethylamine and water. HPLC separation was carried out using a PEG reversed-phase stationary phase Supelco Discovery HS PEG column (15?×?4 mm; particle size 3 μm) at a temperature of 30 °C and flow rate at 1.0 mL min^?1. The UV detector was set at 210 nm. In this study, a PEG stationary phase was shown to be suitable for the efficient isocratic separation of compounds that differ widely in hydrophobicity and acid–base properties, particularly 4-aminophenol (log P, 0.30), caffeine (log P, ?0.25), and propyphenazone (log P, 2.27). A polar PEG stationary phase provided specific selectivity which allowed traditional chromatographic problems related to the separation of analytes with different polarities to be solved. The retention properties of the group of structurally similar substances (aromatic amines, phenolic compounds, and xanthine derivatives) were tested with different mobile phases. The proposed green chromatography method was successfully applied to the analysis of active substances and one degradation impurity (4-aminophenol) in commercial preparation. Under the optimum chromatographic conditions, standard calibration was carried out with good linearity correlation coefficients for all compounds in the range (0.99914–0.99997, n?=?6) between the peak areas and concentration of compounds. Recovery of the sample preparation was in the range 100?±?5 % for all compounds. The intraday method precision was determined as RSD, and the values were lower than 1.00 %.

Properties of two amide‐based hydrophilic interaction liquid chromatography columns

Hydrophilic interaction liquid chromatography is a separation technique suitable for the separation of moderately and highly polar compounds. Various stationary phases (SPs) for hydrophilic interaction liquid chromatography are commercially available. While the SPs based on the same type of ligand are available from different providers, they can display a distinct retention characteristics and separation selectivity. The current work is focused on characterization and comparison of the separation systems of two amide‐based HPLC columns from two producers, i.e. XBridge Amide column and TSK gel Amide‐80 column. Several characterization procedures (tests) were used to investigate the differences between these columns. The chromatographic behavior of selected analytes indicates that multimodal interactions are responsible for retention and separation on these columns. Multiple testing approaches were used in order to reveal subtle differences between the SPs. Both amide‐based columns showed certain differences in retention, selectivity, and plate counts. Based on the tests used in this study, we conclude that the investigated columns provide a different degree of H‐bonding interactions.     

HPLC column-switching technique for sample preparation and fluorescence determination of propranolol in urine using fused-core columns in both dimensions

A new and fast high-performance liquid chromatography (HPLC) column-switching method using fused-core columns in both dimensions for sample preconcentration and determination of propranolol in human urine has been developed. On-line sample pretreatment and propranolol preconcentration were performed on an Ascentis Express RP-C-18 guard column (5?×?4.6 mm), particle size, 2.7 μm, with mobile phase acetonitrile/water (5:95, v/v) at a flow rate of 2.0 mL min^?1 and at a temperature of 50 °C. Valve switch from pretreatment column to analytical column was set at 4.0 min in a back-flush mode. Separation of propranolol from other endogenous urine compounds was achieved on the fused-core column Ascentis Express RP-Amide (100?×?4.6 mm), particle size, 2.7 μm, with mobile phase acetonitrile/water solution of 0.5 % triethylamine, pH adjusted to 4.5 by means of glacial acetic acid (25:75, v/v), at a flow rate of 1.0 mL min^?1 and at a temperature of 50 °C. Fluorescence excitation/emission detection wavelengths were set at 229/338 nm. A volume of 1,500 μL of filtered urine sample solution was injected directly into the column-switching HPLC system. The total analysis time including on-line sample pretreatment was less than 8 min. The experimentally determined limit of detection of the method was found to be 0.015 ng mL^?1.