Identification of Different Cobalt Nucleation on Glassy Carbon

The nucleation mechanisms of cobalt from sulfate solutions were studied by utilizing the electrochemical technique, chronoamperometry. It was found that the recorded current-time transients introduced from 1.0mol/L CoSO4 solution were complexes with unusual shapes. All characteristic features were identified as separate process. The instantaneous or progressive nucleation with 2D or 3D growth exists during the cobalt deposition, depending on the applied potentials.     

固相微萃取GC-MS法测定苹果不同品种中主要芳香成分的研究

利用固相微萃取(solid phase nmicroelraction,SPME)和气质联用技术对目前果汁生产企业主要用于制汁的金帅、澳洲青苹、国光、新红星、富士及秦冠等品种的主要芳香成分进行定性和定量分析,比较不同品种之间芳香成分在种类和含量上的差异。在香气成分的定量分析中,以脱香果汁为基体加入混合标样,采用内标标准曲线法制作标准曲线,消除由SPME带来的系统误差,提高了实验结果的准确性和精确性。     

固相萃取高效液相色谱-质谱法测定动物组织中硝基呋喃代谢产物

研究了对动物组织中4种硝基呋喃类代谢产物AOZ、AMOZ、SEM和AHD的自动固相萃取HPLC-MS分析方法，分别以2-氯苯甲醛和2-硝基苯甲醛作为衍生化试剂，分别用AMOZ-d5、AOZ-d4作内标，用ENSPE柱进行提取，以乙腈-0．1％甲酸为流动相，采用梯度洗脱，可在15min内将4种代谢产物完全分离并进行测定。回收率为85％-90％；检出限可达0．5μg／kg。采用两种衍生化方法可获得较多的定性确证信息。采用本方法研究了硝基呋喃在鸡饲养过程中的残留规律。     

高效液相色谱-电感耦合等离子体质谱联用测定生物样品中无机汞和甲基汞

建立了高效液相色谱(HPLC)和电感耦合等离子体质谱(ICP-MS)联用测定多种生物样品中的无机汞和甲基汞的方法,并对比了提取生物样品中无机汞和甲基汞的不同前处理方法。实验使用5 mol/L的盐酸超声波提取样品中的无机汞和甲基汞。高效液相色谱流动相为含有0.06 mol/L醋酸氨,20μg/L B i,0.1%(V/V)2-巯基乙醇的5%(V/V)甲醇-水溶液,色谱柱为C18反相柱(5μm,3.9 mm×150 mm)。提取液在液相色谱中分离后,进入电感耦合等离子体质谱检测其中无机汞和甲基汞的浓度。测定了人发(GBW 07601),对虾(GBW 08572),鱼肉组织(IAEA MA-B-3/TM)和牛肝(GBW 080193)4种生物标准参考物,结果与标准参考物的标准值相符。无机汞和甲基汞检出限分别为0.3和0.2μg/L。     

高效液相色谱法检测鳗鱼中氟苯尼考残留量

建立了鳗鱼肌肉中氟苯尼考残留的分析方法。采用乙酸乙酯作为提取剂,提取液挥干后溶于缓冲液中,经正已烷脱脂、C18SPE小柱净化后,采用高效液相色谱进行分析,方法在1～200ng之间呈线性相关;相关系数r=0．9999。对于0．05、0．10、0．50mg／kg 3个添加水平,平均回收率均在90％以上,相对标准偏差为4．24％～7．36％,方法检出限和定量限分别为9．1μg/kg和22．3μg／kg。     

臭氧发生器所产生气体中氮氧化物的HPLC法测定

基于氮氧化物溶于水生成HNO2和HNO3的反应,采用NaOH溶液收集氮氧化物,用高效液相色谱法测定氮氧化物,并用分光光度法作对比。结果表明,分光光度法所测结果偏低,高效液相色谱法更准确而且简便、快速,选择性好。     

微波萃取高效液相色谱法测定口红中芳香胺类化合物

利用微波萃取高效液相色谱法测定了口红中芳香胺类化合物.先将口红涂于玻璃片上,然后用微波萃取和高效液相色谱法测定萃取液中的芳香胺类化合物.研究了3种市售口红并得到了芳香胺类化合物的定量测定结果.考察了微波萃取的条件,并将薄层色谱等萃取分离方法和微波萃取法进行了比较,证明微波萃取法在萃取膏状物和蜡状物中的组分时,具有比其它方法更加方便、快速等优点.     

个旧超大型锡多金属矿稀土元素地球化学特征

对比研究了个旧不同类型岩(矿)石(蚀变花岗岩、钙质泥岩、大理岩、矽卡岩矿石、层状矿石和脉状矿石)的稀土元素、微量元素地球化学特征,借以示踪不同类型矿床的成矿物质来源。研究表明不同类型矿石中的稀土元素配分曲线较为相似,成矿物质具有同源性,并与本区的花岗岩具有一定的成因联系。由于其成矿方式的不同,不同类型矿石中的稀土元素特征和矿物组合特征略有差异,脉状矿石和层状矿石中稀土含量相对较少且富集轻稀土,而矽卡岩矿石中稀土含量相对较多且轻、重稀土的含量变化较大。     

4-(取代嘧啶-2-基)-1-芳磺酰基氨基脲化合物的合成与表征

以取代的苯磺酰肼与(取代嘧啶-2-基)-氨基甲酸苯酯在非亲核性碱存在下合成了12个4-(取代嘧啶-2-基)-1-芳磺酰基氨基脲化合物5和3个5与碱形成的有机盐5as, 5bs和5cs. 所有合成化合物均经过元素分析和¹H NMR的结构确证. ¹H NMR数据证明, 在5as～5cs中, 磺酰氨基脲起到提供质子的作用.     

Preparation and application of the sol-gel-derived acrylate/silicone co-polymer coatings for headspace solid-phase microextraction of 2-chloroethyl ethyl sulfide in soil

Three types of novel acrylate/silicone co-polymer coatings, including co-poly(methyl acrylate/hydroxy-terminated silicone oil) (MA/OH-TSO), co-poly(methyl methacrylate/OH-TSO) (MMA/OH-TSO) and co-poly(butyl methacrylate/OH-TSO) (BMA/OH-TSO), were prepared for the first time by sol-gel method and cross-linking technology and subsequently applied to headspace solid-phase microextraction (HS-SPME) of 2-chloroethyl ethyl sulfide (CEES), a surrogate of mustard, in soil. The underlying mechanisms of the coating process were discussed and confirmed by IR spectra. The selectivity of the three types of sol-gel-derived acrylate/silicone coated fibers was studied, and the BMA/OH-TSO coated fibers exhibited the highest extraction ability to CEES. The concentration of BMA and OH-TSO in sol solution was optimized, and the BMA/OH-TSO (3:1)-coated fibers possessed the highest extraction efficiency. Compared with commercially available polyacrylate (PA) fiber, the sol-gel-derived BMA/OH-TSO (3:1) fibers showed much higher extraction efficiency to CEES. Therefore, the BMA/OH-TSO (3:1)-coated fibers were chosen for the analysis of CEES in soil matrix. The reproducibility of coating preparation was satisfactory, with the RSD 2.39% within batch and 3.52% between batches, respectively. The coatings proved to be quite stable at high temperature (to 350 degrees C) and in different solvents (organic or inorganic), thus their lifetimes (to 150 times) are longer than conventional fibers. Extraction parameters, such as the volume of water added to the soil, extraction temperature and time, and the ionic strength were optimized. The linearity was from 0.1 to 10 microg/g, the limit of detection (LOD) was 2.7 ng/g, and the RSD was 2.19%. The recovery of CEES was 88.06% in agriculture soil, 92.61% in red clay, and 101.95% in sandy soil, respectively.