Extremal Convex Planar Sets

Each convex planar set K has a perimeter C, a minimum width E, an area A, and a diameter D. The set of points (E,C, A^1/2, D) corresponding to all such sets is shown to occupy a cone in the non-negative orthant of R⁴with its vertex at the origin. Its three-dimensional cross section S in the plane D = 1 is investigated. S lies in a rectangular parallelepiped in R³. Results of Lebesgue, Kubota, Fukasawa, Sholander, and Hemmi are used to determine some of the boundary surfaces of S, and new results are given for the other boundary surfaces. From knowledge of S, all inequalities among E, C ,A, and D can be found.     

Formation of p-type ZnO film on InP substrate by phosphor doping

ZnO thin film was initially deposited on InP substrate by radio frequency (rf) magnetron sputtering and the diffusion process was performed using the closed ampoule technique where Zn₃P₂ was used as the dopant source. To verify the junction formation of ZnO thin films, the electrical properties were measured, and the effects of Zn₃P₂ diffusion on ZnO thin films were investigated. It is observed that the electrical property of the film is changed from n-type to p-type by dopant diffusion effect. Based on the results, it is confirmed that ZnO thin films can be a potential candidate for ultraviolet (UV) optical devices.     

Electrochemical behavior of Li intercalation processes into a Li[NixLi(1/3−2x/3)Mn(2/3−x/3)]O2 cathode

Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂ (X=0.17, 0.25, 0.33, 0.5) compounds are prepared by a simple combustion method. The Rietvelt analysis shows that these compounds could be classified as having the α-NaFeO₂ structure. The initial charge-discharge and irreversible capacity increases with the decrease of x in Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂. Indeed, Li[Ni_0.50Mn_0.50]O₂ compound shows relatively low initial discharge capacity of 200 mAh/g and large capacity loss during cycling, with Li[Ni_0.17Li_0.22Mn_0.61]O₂ and Li[Ni_0.25Li_0.17Mn₀.₅₈]O₂ compounds exhibit high initial discharge capacity over 245 mAh/g and stable cycle performance in the voltage range of 4.8 -2.0 V. On the other hand, XANES analysis shows that the oxidation state of Ni ion reversibly changes between Ni²⁺ and about Ni³⁺, while the oxidation state of Mn ion sustains Mn⁴⁺ during charge-discharge process. This result does not agree with the previously reported ‘electrochemistry model’ of Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂, in which Ni ion changes between Ni²⁺ and NI⁴⁺. Based on these results, we modified oxidation-state change of Mn and Ni ion during charge-discharge process.     

Hyers-Ulam-Rassias stability of homomorphisms in quasi-Banach algebras associated to the Pexiderized Cauchy functional equation

In this paper, we prove the Hyers-Ulam-Rassias stability of homomorphisms in quasi-Banach algebras associated to the Pexiderized Cauchy functional equation. This is applied to investigate homomorphisms between quasi-Banach algebras. The concept of Hyers-Ulam-Rassias stability originated from Th.M. Rassias' stability theorem that appeared in his paper [Th.M. Rassias, On the stability of the linear mapping in Banach spaces, Proc. Amer. Math. Soc. 72 (1978) 297-300].     

On the bidirectional vortex and other similarity solutions in spherical coordinates

The bidirectional vortex refers to the bipolar, coaxial swirling motion that can be triggered, for example, in cyclone separators and some liquid rocket engines with tangential aft-end injectors. In this study, we present an exact solution to describe the corresponding bulk motion in spherical coordinates. To do so, we examine both linear and nonlinear solutions of the momentum and vorticity transport equations in spherical coordinates. The assumption will be that of steady, incompressible, inviscid, rotational, and axisymmetric flow. We further relate the vorticity to some power of the stream function. At the outset, three possible types of similarity solutions are shown to fulfill the momentum equation. While the first type is incapable of satisfying the conditions for the bidirectional vortex, it can be used to accommodate other physical settings such as Hill’s vortex. This case is illustrated in the context of inviscid flow over a sphere. The second leads to a closed-form analytical expression that satisfies the boundary conditions for the bidirectional vortex in a straight cylinder. The third type is more general and provides multiple solutions. The spherical bidirectional vortex is derived using separation of variables and the method of variation of parameters. The three-pronged analysis presented here increases our repertoire of general mean flow solutions that rarely appear in spherical geometry. It is hoped that these special forms will permit extending the current approach to other complex fluid motions that are easier to capture using spherical coordinates.     

On Regressive Isols and Comparability of Summands and a Theorem of R. Downey

In this paper we present a collection of results related to the comparability of summands property of regressive isols. We show that if an infinite regressive isol has comparability of summands, then every predecessor of the isol has a weak comparability of summands property. Recently R. Downey proved that there exist regressive isols that are both hyper-torre and cosimple. There is a surprisingly close connection between non-recursive recursively enumerable sets and particular retraceable sets and regressive isols. We apply the theorem of Downey to show that among the regressive isols that are related to recursively enumerable sets there are some with a new property.     

Emission and sputtering characteristics of Ne-Ar mixed gas glow discharge plasmas.

The emission characteristics of several Cu lines emitted from a Ne-Ar mixed gas glow discharge plasma were investigated. The addition of small amounts of Ar to a Ne plasma increases the sputtering rate of a Cu sample because Ar ions, which work as the impinging ions for cathode sputtering, are predominantly produced through Penning ionization collisions between Ne metastables and Ar atoms. Ar addition also elevates the number density of electrons in the plasma. These changes occurring in the Ne-Ar mixed gas plasma result in enhanced emission intensities of the Cu lines. The Cu II 270.10-nm and the Cu II 224.70-nm lines yield different intensity dependence on the Ar partial pressure added. This phenomenon is because these Cu II lines are excited principally through different charge transfer processes: collisions with Ne ions for the Cu II 270.10-nm line and collisions with Ar ions for the Cu II 224.70-nm line. The shape of sputtered craters in the Ne-Ar glow discharge plasma was measured. The depth resolution was improved when Ar was added to a Ne plasma because the crater bottoms were flatter with larger Ar partial pressures.     

Microstructure array on Si and SiOx generated by micro-contact printing, wet chemical etching and reactive ion etching

A method, combining micro-contact printing (μCP), wet chemical etching and reactive ion etching (RIE), is reported to fabricate microstructures on Si and SiOx. Positive and negative structures were generated based on different stamps used for μCP. The reproducibility of the obtained microstructures shows the methodology reported herein could be useful in Micro-Electro-Mechanical Systems (MEMS), optical and biological sensing applications.     

Preparation of antimicrobial poly(vinyl alcohol) nanofibers containing silver nanoparticles

Polyvinyl alcohol (PVA) nanofibers containing Ag nanoparticles were prepared by electrospinning PVA/silver nitrate (AgNO₃) aqueous solutions, followed by short heat treatment, and their antimicrobial activity was investigated for wound dressing applications. Since PVA is a water soluble and biocompatible polymer, it is one of the best materials for the preparation of wound dressing nanofibers. After heat treatment at 155 °C for 3 min, the PVA/AgNO₃ nanofibers became insoluble, while the Ag⁺ ions therein were reduced so as to produce a large number of Ag nanoparticles situated preferentially on their surface. The residual Ag⁺ ions were reduced by subsequent UV irradiation for 3 h. The average diameter of the Ag nanoparticles after the heat treatment was 5.9 nm and this value increased slightly to 6.3 nm after UV irradiation. It was found that most of the Ag⁺ ions were reduced by the simple heat treatment. The PVA nanofibers containing Ag nanoparticles showed very strong antimicrobial activity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2468–2474, 2006