Numerical simulations of a filament in a flowing soap film

Experiments concerning the properties of soap films have recently been carried out and these systems have been proposed as experimental versions of theoretical two‐dimensional liquids. A silk filament introduced into a flowing soap film, was seen to demonstrate various stable modes, and these were, namely, a mode in which the filament oscillates and one in which the filament is stationary and aligns with the flow of the liquid. The system could be forced from the oscillatory mode into the non‐ oscillatory mode by varying the length of the filament. In this article we use numerical and computational techniques in order to simulate the strongly coupled behaviour of the filament and the fluid. Preliminary results are presented for the specific case in which the filament is seen to oscillate continuously for the duration of our simulation. We also find that the filament oscillations are strongly suppressed when we reduce the effective length of the filament. We believe that these results are reminiscent of the different oscillatory and non‐oscillatory modes observed in experiment. The numerical solutions show that, in contrast to experiment, vortices are created at the leading edge of the filament and are preferentially grown in the curvature of the filament and are eventually released from the trailing edge of the filament. In a similar manner to oscillating hydrofoils, it seems that the oscillating filaments are in a minimal energy state, extracting sufficient energy from the fluid to oscillate. In comparing numerical and experimental results it is possible that the soap film does have an effect on the fluid flow especially in the boundary layer where surface tension forces are large. Copyright © 2004 John Wiley & Sons, Ltd.     

Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.     

Experimental flow study over a blunt-nosed axisymmetric body at incidence

The flowfield over a blunt-nosed cylinder was examined experimentally at a low subsonic speed for Re=1.88×10⁵ and angles of attack up to 40°. Velocity measurements were carried out (employing a seven-hole Pitot tube) as well as wall static pressure and wall shear-stress measurements. Surface flow visualization was applied using liquid crystals and a mixture of oil–TiO₂. For all the examined cases no flow asymmetries were found. For high angles of attack (20° and above) a separation “bubble” appears at the leeside of the nose area (streamwise flow separation). The basic feature of the circumferential pressure distribution at the after body area for these angles of attack is a plateau close to the suction peak and a fast recovery next to it. One streamwise vortex on each side of the symmetry plane is formed as well as a separation bubble about 90° far from this plane, where the cross-flow primary separation line is located. Each cross-flow primary separation line starts at the leeside nose area and moves towards the windward side along the cylindrical after body. The space between the two primary separation lines close to the wall is characterized by high flow fluctuations on the leeside, compared to the low fluctuations of the windward side.     

Forces along Equidistant Particle Paths

Two particles on the sphere leave the equator moving due south and travel at a constant and equal speed along a geodesic colliding at the south pole. An observer who is unaware of the curvature of the space will conclude that there is an attractive force acting between the particles. On the other hand, if particles travel at the same speed (initially parallel) along geodesics in the hyperbolic plane, then the particle paths diverge. Imagine two particles in the hyperbolic plane that are bound together at a constant distance with their center of mass traveling along a geodesic path at a constant velocity, then the force due to the curvature of the space acts to break the bond and increases as a quadratic function of the velocity. We consider this problem for the sphere and the hyperbolic plane and we give the exact formula for the apparent force between the particles. This revised version was published online in July 2006 with corrections to the Cover Date.     

Electron spin lifetimes in Hg0.78Cd0.22 Te and InSb

We have made direct pump–probe measurements of spin lifetimes in long wavelength narrow-gap semiconductors at wavelengths between 4 and 10 μm and from 4 to 300 K. In particular, we measure remarkably long spin lifetimes, τ_s300 ps, even at 300 K for epilayers of degenerate n-type InSb. In this material the mobility is approximately constant between 77 and 300 K, and we find that τ_s is approximately constant in this temperature range. In order to determine the dominant spin relaxation mechanism we have investigated the temperature dependence of τ_s in non-degenerate lightly n-type Hg_0.78Cd_0.22Te of approximately the same band gap as InSb, and find that τ_s varies from 356 ps at 150 K to 24 ps at 300 K. Our results, both in magnitude and temperature dependence of τ_s, imply that the Elliott–Yafet model dominates in these materials.     

Strangeness saturation: Dependence on system-size, centrality and energy

The dependence of the strangeness saturation factor on the system size, centrality and energy is studied in relativistic heavy-ion collisions.