Effect of 60Co γ-irradiation on structural and optical properties of thin films of Ga10Se80Hg10

Thin films of Ga₁₀Se₈₀Hg₁₀ have been deposited onto a chemically cleaned Al₂O₃ substrates by thermal evaporation technique under vacuum. The investigated thin films are irradiated by ⁶⁰Co γ-rays in the dose range of 50–150 kGy. X-ray diffraction patterns of the investigated thin films confirm the preferred crystallite growth occurs in the tetragonal phase structure. It also shows, the average crystallite size increases after γ-exposure, which indicates the crystallinity of the material increases after γ-irradiation. These results were further supported by surface morphological analysis carried out by scanning electron microscope and atomic force microscope which also shows the crystallinity of the material increases with increasing the γ-irradiation dose. The optical transmission spectra of the thin films at normal incidence were investigated in the spectral range from 190 to 1100 nm. Using the transmission spectra, the optical constants like refractive index (n) and extinction coefficient (k) were calculated based on Swanepoel’s method. The optical band gap (E_g) was also estimated using Tauc’s extrapolation procedure. The optical analysis shows: the value of optical band gap of investigated thin films decreases and the corresponding absorption coefficient increases continuously with increasing dose of γ-irradiation.     

Performance improvement of spectral amplitude coding-optical code division multiple access systems using NAND detection with enhanced double weight code

The bit-error rate (BER) performance of the spectral amplitude coding-optical code division multiple access (SACOCDMA) system has been investigated by using NAND subtraction detection technique with enhanced double weight (EDW) code. The EDW code is the enhanced version of double weight (DW) code family where the code weight is any odd number and greater than one with ideal cross-correlation. In order to evaluate the performance of the system, we used mathematical analysis extensively along with the simulation experiment. The evaluation results obtained using the NAND subtraction detection technique was compared with those obtained using the complementary detection technique for the same number of active users. The comparison results revealed that the BER performance of the system using NAND subtraction detection technique has greatly been improved as compared to the complementary technique.     

Characterization of small-signal intensity modulation of single-mode fiber grating Fabry-Perot laser source

A comprehensive study on the small-signal intensity modulation (IM) characteristics of a fiber grating Fabry-Perot (FGFP) laser is numerically investigated. The effect of external optical feedback (OFB), temperature, injection current, cavity volume, nonlinear gain compression factor, and fiber grating (FG) parameters on IM characteristics are presented. The temperature dependence (TD) of IM is calculated according to the TD of laser cavity parameters instead of using the well-known Parkove relationship. It has been shown that the optimum external fiber length (L _ext) is 3.1 cm. The optimum range of working temperature for FGFP laser is between 23 to 27 °C. We also show that by increasing the laser injection current from 10 to 60 mA, the IM peak amplitude decreased from 6.3 to 0.2 dB and the relaxation-oscillation frequency (ROF) is shifted from 1.2 GHz towards higher frequency of 5.48 GHz. In addition, the AR coating reflectivity and gain compression factor have no significant effect on the IM. The study indicates that a stable operation and excellent modulation characteristic can be obtained after optimization process.     

Practical spatial resolution of electron energy loss spectroscopy in aberration corrected scanning transmission electron microscopy

The resolution of electron energy loss spectroscopy (EELS) is limited by delocalization of inelastic electron scattering rather than probe size in an aberration corrected scanning transmission electron microscope (STEM). In this study, we present an experimental quantification of EELS spatial resolution using chemically modulated 2×(LaMnO(3))/2×(SrTiO(3)) and 2×(SrVO(3))/2×(SrTiO(3)) superlattices by measuring the full width at half maxima (FWHM) of integrated Ti M(2,3), Ti L(2,3), V L(2,3), Mn L(2,3), La N(4,5), La N(2,3) La M(4,5) and Sr L(3) edges over the superlattices. The EELS signals recorded using large collection angles are peaked at atomic columns. The FWHM of the EELS profile, obtained by curve-fitting, reveals a systematic trend with the energy loss for the Ti, V, and Mn edges. However, the experimental FWHM of the Sr and La edges deviates significantly from the observed experimental tendency.     

Gas by-products of CF3I under AC partial discharge

This paper presents the decomposition by-products of trifluro-iodo-methane and their relative proportions in the gas phase under the occurrence of partial discharge. The experiment was performed in the presence of water vapor from 250 to 400 ppm under a non-uniform electric field configuration. The experimental results reveal that the by-products of C₂F₆, C₂F₄, C₂F₅I with the amount of 1300, 200, and 55 (CH₃I) ppm, respectively, were produced for a cumulative charge of 161 mC. Other by-products, such as C₃F₈, CHF₃, C₃F₆ CH₃I were obtained at less than 30 ppm C₂F₆ was the dominant gas by-product of trifluro-iodo-methane suffering partial discharge.     

Instability,intermixing and electronic structure at the epitaxial LaAlO3/SrTiO3(001) heterojunction

The question of stability against diffusional mixing at the prototypical LaAlO₃/SrTiO₃(001) interface is explored using a multi-faceted experimental and theoretical approach. We combine analytical methods with a range of sensitivities to elemental concentrations and spatial separations to investigate interfaces grown using on-axis pulsed laser deposition. We also employ computational modeling based on the density function theory as well as classical force fields to explore the energetic stability of a wide variety of intermixed atomic configurations relative to the idealized, atomically abrupt model. Statistical analysis of the calculated energies for the various configurations is used to elucidate the relative thermodynamic stability of intermixed and abrupt configurations. We find that on both experimental and theoretical fronts, the tendency toward intermixing is very strong. We have also measured and calculated key electronic properties such as potential energy gradients and valence band discontinuity at the interface. We find no measurable electric field in either the LaAlO₃ or SrTiO₃, and that the valence band offset is near zero, partitioning the band discontinuity almost entirely to the conduction band edge. Significantly, we find it is not possible to account for these electronic properties theoretically without including extensive intermixing in our physical model of the interface. The atomic configurations which give the greatest electrostatic stability are those that eliminate the interface dipole by intermixing, calling into question the conventional explanation for conductivity at this interface—electronic reconstruction. Rather, evidence is presented for La indiffusion and doping of the SrTiO₃ below the interface as being the cause of the observed conductivity.     

Management of branch-duct intraductal papillary mucinous neoplasms of the pancreas: observation with MR imaging

Purpose

To evaluate the clinical outcomes of conservative management by observation with MRI of patients with branch-duct intraductal papillary mucinous neoplasms (BD-IPMNs).

Materials and Methods

Twenty-three consecutive patients, who were followed up by MRI with magnetic resonance cholangiopancreatography (MRCP) over a period of more than 9 months after initial MRI examinations, were enrolled in this study. On MRI, number of lesions, the maximum diameter of BD-IPMNs, lesion location, the presence of associated dilatation of main pancreatic duct (MPD), the presence of enhancing mural nodules within the lesion and the presence of interval change were retrospectively reviewed on initial and follow-up MR images in consensus by two radiologists. All patients were evaluated to search for evidence of malignant progression of disease.

Results

The follow-up period ranged from 10 to 96 months (mean, 37 months). On initial MRI with MRCP, a total of 39 lesions were found in 23 patients. The maximum diameter of BD-IPMNs ranged between 6 and 32 mm, with a mean of 12 mm. Thirty-four lesions (87%) of 19 patients remained unchanged in the maximum diameter. Five lesions (13%) of four patients showed an increase in the maximum diameter. Enhancing mural nodules were not found in any individual, neither on the initial MRI study nor on the follow-up studies. There was no patient who had evidence of local aggressive growth of tumor or evidence of metastases to distant sites.

Conclusion

Our study suggests that branch-duct IPMNs without enhancing mural nodules are essentially benign and should be managed nonoperatively through observation by MRI.     

Anisotropic Bianchi type V perfect fluid cosmological models in Lyra’s geometry

The law of variation for mean Hubble’s parameter with average scale factor, in an anisotropic Bianchi type V cosmological space–time, is discussed within the frame work of Lyra’s manifold. The variation of Hubble’s parameter, which gives a constant value of deceleration parameter, generates two types of solutions for the average scale factor; one is the power-law and the other one is of exponential form. Using these two forms, new classes of exact solutions of the field equations have been found for a Bianchi type V space–time filled with perfect fluid in Lyra’s geometry by considering a time-dependent displacement field. The physical and kinematical behaviors of the singular and non-singular models of the universe are examined. Exact expressions for look-back time, luminosity distance and event horizon versus redshift are also derived and their significance are discussed in detail. It has been observed that the solutions are compatible with the results of recent observations.     

Analysis of coir fiber acoustical characteristics

Coir fiber from coconut husk is an important agricultural waste in Malaysia. Acoustic absorption coefficient of the fiber as a porous material is studied in this paper. Two types of fiber are investigated, fresh from wet market and industrial prepared mixed with binder. Moreover two analytical models, namely; Delany–Bazley and Biot–Allard are used for analysis. Experimental measurements in impedance tube are conducted to validate the analytical outcomes. Results show that fresh coir fiber has an average absorption coefficient of 0.8 at f > 1360 Hz and 20 mm thickness. Increasing the thickness is improved the sound absorption in lower frequencies, having the same average at f > 578 Hz and 45 mm thickness. Delany–Bazley technique can be used for both types of fiber while Biot–Allard method is compensated for the industrial prepared fiber considering the binder additive. This form generally shows poor acoustical absorption in low frequencies. Inevitably, fiber has to be mixed with additives in commercial use to enhance its characteristics such as stiffness, unti-fungus and flammability. Hence other approaches such as adding air gap or perforated plate should be used to improve the acoustical properties of industrial treated coir fiber.     

Spectroscopic study of sulforhodamine 640-doped sol-gel silica

The sol-gel process is a technique which provides a low-temperature route for the preparation of organic dye-doped porous silica glass. Extended UV transmission was observed for HCl-catalysed sol-gel silica. Properties of a solute may differ greatly between a free solution and that solution confined in pores of a sol-gel glass. Absorption and fluorescence properties of sulforhodamine 640-doped silica samples prepared by sol-gel process were investigated. In the TEOS-derived gel, the emission of the dye does not shift during aging but exhibits a large change during drying. The emission maximum of sulforhodamine 640 blue shifts was discussed as a function of increasing rigidity of the surrounding matrix.