Direct determination of impurities in high purity silicon carbide by inductively coupled plasma optical emission spectrometry using slurry nebulization technique

A novel method for the determination of Al, Ca, Cr, Cu, Fe, Mg, Mn, Ni and Ti in high purity silicon carbide (SiC) using slurry introduction axial viewed inductively coupled plasma optical emission spectrometry (ICP-OES) was described. The various sizes of SiC slurry were dispersed by adding dispersant polyethylene imine (PEI). The stability of slurry was characterized by zeta potential measurement, SEM observation and signal stability testing. The optimal concentration of PEI was found to be 0.5 wt% for the SiC slurry. Analytical results of sub-μm size SiC by the slurry introduction were in good accordance with those by the alkaline fusion method which verified that determination could be calibrated by aqueous standards. For μm size SiC, results of most elements have a negative deviation and should be calibrated by the Certified Reference Material slurry. Owing to a rather low contamination in the sample preparation and stability of the slurry, the limits of detection (LODs), which are in the range of 40-2000 ng g⁻¹, superior to those of the conventional nebulization technique by ICP-OES or ICP-MS.     

Energy transfer of highly vibrationally excited azulene. II. Photodissociation of azulene-Kr van der Waals clusters at 248 and 266 nm

Photodissociation of azulene-Kr van der Waals clusters at 266 and 248 nm was studied using velocity map ion imaging techniques with the time-sliced modification. Scattered azulene molecules produced from the dissociation of clusters were detected by one-photon vacuum ultraviolet ionization. Energy transfer distribution functions were obtained from the measurement of recoil energy distributions. The distribution functions can be described approximately by multiexponential functions. Fragment angular distributions were found to be isotropic. The energy transfer properties show significantly different behavior from those of bimolecular collisions. No supercollisions were observed under the signal-to-noise ratios S/N=400 and 100 at 266 and 248 nm, respectively. Comparisons with the energy transfer of bimolecular collisions in thermal systems and the crossed-beam experiment within detection limit are made.     

Temperature- and pH-dependent morphology and FT-IR analysis of magnesium carbonate hydrates

Various morphologies of magnesium carbonate hydrates have been synthesized by carefully adjusting the reaction temperature and pH value of the initial reaction solution in the precipitation process. At lower temperatures (from room temperature to 328 K) and lower pH values (variation with the reaction temperature), magnesium carbonate hydrates are prone to display needlelike morphology, and the axis diameter of the particles decreases with the increase of reaction temperature and pH value. With the further increase of the reaction temperature (333-368 K) and pH value, the sheetlike crystallites become the preferred morphology, and at higher temperatures and pH values, these crystallites tend to assemble into layerlike structures with diverse morphologies, such as spherical-like particles with rosette-like structure and cakelike particles built from sheetlike structure. Fourier transform infrared (FT-IR) spectra show that these various morphologies are closely related to their compositions. The needlelike magnesium carbonate hydrate has a formula of MgCO3.xH2O, in which the value x is greatly affected by the experimental conditions, whereas with the morphological transformation from needlelike to sheetlike structure, their corresponding compositions also change from MgCO3.xH2O to Mg5(CO3)4(OH)2.4H2O in the interval of 328-333 K.     

New one-carbon degradative transformation of beta-alkyl-beta-azido alcohols

[STRUCTURE: SEE TEXT] A new transformation of 2-azido-1-hydroxy-containing compounds to nitriles with one carbon less than the starting materials by oxidation was reported. The reaction can be performed under mild conditions.     

Constrained tone transformation technique for separation and combination of Mandarin tone and intonation

This paper addresses a classical but important problem: The coupling of lexical tones and sentence intonation in tonal languages, such as Chinese, focusing particularly on voice fundamental frequency (F1) contours of speech. It is important because it forms the basis of speech synthesis technology and prosody analysis. We provide a solution to the problem with a constrained tone transformation technique based on structural modeling of the F1 contours. This consists of transforming target values in pairs from norms to variants. These targets are intended to sparsely specify the prosodic contributions to the F1 contours, while the alignment of target pairs between norms and variants is based on underlying lexical tone structures. When the norms take the citation forms of lexical tones, the technique makes it possible to separate sentence intonation from observed F0 contours. When the norms take normative F0 contours, it is possible to measure intonation variations from the norms to the variants, both having identical lexical tone structures. This paper explains the underlying scientific and linguistic principles and presents an algorithm that was implemented on computers. The method's capability of separating and combining tone and intonation is evaluated through analysis and re-synthesis of several hundred observed F0 contours.     

Electrochemistry of marmatite-carbon paste electrode in the presence of bacterial strains

The electrochemical behaviors of a marmatite-carbon paste electrode with the chemical leaching of Fe3+ ions, or the microbial leaching using Acidithiobacillus ferrooxidans, were compared. The cyclic voltammograms of the electrode in the presence and absence of bacterial strains showed that the leaching process of marmatite was carried out by the different reactions occurring in the interface of the marmatite electrode-leach liquid. The polarization currents of the electrode under the differently applied potentials suggested that the microbial leaching of marmatite could be accelerated by the applied potential. The SEM observations indicated that the corrosion pits formed in the electrode surface were similar to the attached bacterial cells in shape and size, other than that by the chemical leaching of Fe3+ ions. The contact leaching of the attached cells on the mineral substrate played an important role on the dissolution of marmatite in addition to the chemical leaching of Fe3+ ions.     

Excimer laser pumped by an intense, high-energy heavy-ion beam

High-energy heavy ions are an ideal tool to generate homogeneously excited, extended volumes of nonthermal plasmas. Here, the high-energy loss (dE/dx) and absolute power deposition of heavy ions interacting with matter has been used to pump an ultraviolet laser. A pulsed 70 MeV/u 238U beam with up to 2.5 x 10(9) particles in approximately 100 ns beam bunches was stopped in a 1.2 m long laser cell filled with a 1.6 bar Ar-Kr-F2 mixture (typically 50%:49.9%:0.1%). Laser effect on the 248 nm KrF* excimer transition is clearly demonstrated.     

Unifying two results of Orlov on singularity categories

Let \mathbbX\mathbb{X} be a separated Noetherian scheme of finite Krull dimension which has enough locally free sheaves of finite rank and let U í \mathbbXU\subseteq \mathbb{X} be an open subscheme. We prove that the singularity category of U is triangle equivalent to the Verdier quotient triangulated category of the singularity category of \mathbbX\mathbb{X} with respect to the thick triangulated subcategory generated by sheaves supported in the complement of U. The result unifies two results of Orlov. We also prove a noncommutative version of this result.     

Apply a novel evolutionary algorithm to the solution of parameter selection problems

In this study, a modified line-up competition algorithm (LCA) is used to solve parameter selection problems. The so-called parameter selection problems contain parameter identification problems and optimal control problems. Once the later problems are transformed by control parametrization, the parameters embedded in both problems are selected by the proposed method under the framework of integration approach. Two parameter identification problems and one optimal control problem are given to demonstrate the use of LCA. The results show that in addition to being insensitive to the initial conditions, LCA is very efficient in solving highly nonlinear parameter selection problems.     

Internal layers for a quasi--linear singularly perturbed delay differential equation

The current paper is mainly concerned with the internal layers for a quasi--linear singularly perturbed differential equation with time delays. By using the method of boundary layer functions and the theory of contrast structures, the existence of a uniformly valid smooth solution is proved, and the asymptotic expansion is constructed. As an application, a concrete example is presented to demonstrate the effectiveness of our result.