Exact mass measurement of product ions for the structural confirmation and identification of unknown compounds using a quadrupole time-of-flight spectrometer: a simplified approach using combined tandem mass spectrometric functions

This article describes a simple method to perform lock mass corrected accurate mass measurements in tandem mass spectrometry (MS/MS) with a quadrupole time-of-flight (Q-TOF) mass spectrometer. The experimental approach consists of using the protonated molecule of a known compound, which is measured in a MS/MS function using low collision energy (no fragmentation), as mass calibrator. The unknown compound is acquired in MS/MS mode albeit using high collision energy. After the acquisition, the two MS/MS spectra of unknown and mass calibrator are combined, and the fragments of the unknown are lock mass corrected by using the protonated molecule of the mass calibrator. To prove this concept, 10 compounds were analyzed using this approach, the fragments interpreted and, where possible, related to structural data available in the literature. All the unequivocally assigned fragments were accurately mass measured with mass errors within appropriate limits, i.e. for m/z values <200 with a mass tolerance of 3 mDa while for m/z > 200 the mass tolerance is expressed as 10 ppm.     

First organophosphorus radical-mediated cyclisations to afford medium-sized rings: eight-membered lactones and seven- and eight-membered lactams

The phosphorus based radical precursors N-ethylpiperidine hypophosphite (EPHP) and diethylphosphine oxide (DEPO) are efficient reagents for carrying out the formation of seven- and eight-membered rings. Esters and amides were successfully converted into the corresponding eight-membered lactones and seven- and eight-membered lactams in good to excellent yields.     

Synthesis and biological evaluation of new inhibitors of UDP-Galf transferase--a key enzyme in M. tuberculosis cell wall biosynthesis

Two iminosugars have been designed and synthesized as potential inhibitors of UDP-Galf transferase, an enzyme involved in Mycobacterium tuberculosis cell wall biosynthesis. The design is based on a proposed model of the transition state for the transferase reaction. One of the two racemic compounds is the first reported inhibitor of the target enzyme from M. smegmatis.     

Determination of lactate or oxalate using injected lactate oxidase and peroxidase by capillary electrophoresis with UV detection

Two reactions, catalyzed by lactate oxidase (LO) and peroxidase, are initiated by a single injection of the enzymes and the substrate 2,2'-azino-bis(3-ethylene-thiazoline-6-sulfonic acid) (ABTS) into the capillary previously filled with the sample (lactate or lactate-oxalate mixture) and the run buffer containing NADH. The oxidized ABTS product upon reaction with NADH is converted to NAD(+) which is separated and detected in less than 2 min at 266 nm with a sample throughput of 7 min (including wash steps between samples). Simplex trade mark software is used to optimize the enzyme concentrations and reaction temperature. Consumption of the more expensive LO enzyme is only 1.4 x 10(-3) U per assay assuming 27 nL per injection. Linearity is established within the range from 0.0025 to 1 mM with R(2) of 0.9982. Recoveries of lactate from five spiked serum samples averaged 101%. Application of this method for the determination of oxalate as an inhibitor of LO is demonstrated.     

A practical synthesis of (+/-)-alpha-isosparteine from a tetraoxobispidine core

[reaction: see text] The title alkaloid was synthesized in racemic form from 3,7-diallyl-2,4,6,8-tetraoxo-3,7-diazabicyclo[3.3.1]nonane (7) by a regioselective diallylation reaction followed by double ring-closing olefin metathesis and exhaustive reduction. Tetraoxobispidine 7 was itself prepared in three simple operations from dimethyl malonate. The entire sequence to alpha-isosparteine was conducted on a multigram scale and proceeded without recourse to chromatography.     

Measurements in the separation region of a gas-particle cross flow

This paper reports the results from a study of the effects of particles on the boundary layer characteristics for cross flow over a single circular cylinder in the near separation region and on a cylinder located in the second row of a small mock-up heat exchanger array. Two size ranges of particles (45–85 m and 100–200 m) with two concentrations were used for the single cylinder tests. For the array, the larger particles were used at a single concentration. For the single cylinder, the results with the larger particles at mass loading ratio of 1.0 show an obvious effect on the velocity profile shape and on the rms levels. For reduced concentrations, and for the smaller particles, the effects are less noticeable. For the array, similar trends are observed and a delay in the separation point is reported.     

Recovery of intact proteins from silver stained gels

Silver stained proteins of a wide molecular weight (MW) range (20-116 kDa) were successfully recovered by both electroblot and electroelution. The recovery was demonstrated for nanogram loads of proteins separated by SDS-PAGE and visualized by silver staining methods compatible and incompatible with mass spectrometry (MS). It was shown that the alcohol/acid and glutaraldehyde fixation steps present in a number of staining procedures did not prevent recovery of intact proteins from gels. It was found that the recovery of intact proteins from silver stained gels was substantially increased upon pre-equilibration in a buffer containing the reducing agent, dithiothreitol (DTT). The effect of destaining on the recovery of silver stained proteins was also investigated. Comparable recovery of intact proteins within a wide MW range from silver stained gels with and without destaining step was demonstrated. Recovery of model proteins from gels visualized using silver staining method compatible with MS showed 52 to 76% yield of that from the unstained gel, depending upon method of the transfer. Comparison of the recovery of intact proteins from gels visualized using other staining procedures was also made. The above findings have implications as to the supposed irreversible nature of protein "fixation" inside polyacrylamide matrix, and confirm lack of binding of proteins in the gel to metal silver deposited on its surface. This method has the potential to be suitable for direct characterization of proteins by matrix-assisted laser desorption ionization-mass spectrometry (MALDI-MS) without additional purification steps.     

Sonic spray ionization applied to liquid chromatography/mass spectrometry analysis of endocrine-disrupting chemicals in environmental water samples

A sonic spray ionization liquid chromatography/mass spectrometry (LC/SSI-MS) procedure combined with off-line solid-phase extraction was optimized for the analysis of 20 endocrine-disrupting chemicals (EDCs) in water samples. Method development included a comparison of the novel sonic spray ionization (SSI) with more traditional ion sources, i.e. pneumatically assisted electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI). It was demonstrated that SSI and ESI spectra were very similar, but were more prone to the formation of solvent cluster ions as compared with APCI spectra. This phenomenon was most prominent for SSI and resulted in an increased chemical background in full-scan mass spectra. However, this chemical noise did not affect the overall sensitivity of SSI and ESI. After optimization of LC and MS parameters, the LC/SSI-MS method was validated. Recoveries ranged from 76.3 up to 113.4% for all compounds. Limits of detection (LOD) and quantitation (LOQ) were established between 3.0 and 11.5 ng/L and 9.9 and 38.0 ng/L, respectively. Within-day (n = 5) and between-day (n = 5) reproducibility were investigated at three levels and ranged from 3.3-16.5% and 7.6-19.2%, respectively. Eight-point calibration curves were established and showed linearity for all compounds (r(2) > 0.987) over a linear dynamic range of 10-10 000 ng/L.     

The solution photochemistry of αβ-unsaturated sulphones

1-Phenyl-2-(benzenesulphonyl)-ethylene and 1-phenyl-2-(benzenesulphonyl)-prop-1-ene have been shown to undergo $\text{Z}$,$\text{E}$-photoisomerisation, whereas 2-benzenesulphonylindene readily forms [_π2 + _π2] photoadducts with 2,3-dimethylbut-2-ene, cyclopentene, and cyclohexene.     

Aspects of the inorganic chemistry of rubber vulcanization. Part 61 Compounds of benzothiazole-2-selenone; a selenium-containing analogue of 2-mercaptobenzothiazole

Summary Benzothiazole-2-selenone, BTSeH, was prepared by treating 2-chlorobenzothiazole with Na₂Se, and the 6-ethoxy analogue (EtOBTSeH) was obtained similarly. From BTSeH, the species [R₄N][BTSe] (R=Me, Et Bu-n), Zn-(BTSe)₂(pyr)₂, (BTSe^–)₂, Zn(BTSe-)₂I₂ and Me₂C=CH-CH(SSeTB)Me were obtained. Addition of [n-Bu₄N] [BTSe] to [Zn(BTSe)₂] _n afforded [n-Bu₄N] [Zn(BTSe)₃(H₂O)]. The Se n.m.r. spectra of these species are briefly reported.