Optimization of the design and operation of FAIMS analyzers

Field asymmetric waveform ion mobility spectrometry (FAIMS) holds significant promise for post-ionization separations in conjunction with mass-spectrometric analyses. However, a limited understanding of fundamentals of FAIMS analyzers has made their design and operation largely an empirical exercise. Recently, we developed an a priori simulation of FAIMS that accounts for both ion diffusion (including anisotropic components) and Coulomb repulsion, and validated it by extensive comparisons with FAIMS/MS data. Here it is corroborated further by FAIMS-only measurements, and applied to explore how key instrumental parameters (analytical gap width and length, waveform frequency and profile, the identity and flow speed of buffer gas) affect FAIMS response. We find that the trade-off between resolution and sensitivity can be managed by varying gap width, RF frequency, and (in certain cases) buffer gas, with equivalent outcome. In particular, the resolving power can be approximately doubled compared to "typical" conditions. Throughput may be increased by either accelerating the gas flow (preferable) or shortening the device, but below certain minimum residence times performance deteriorates. Bisinusoidal and clipped-sinusoidal waveforms have comparable merit, but switching to rectangular waveforms would improve resolution and/or sensitivity. For any waveform profile, the ratio of two between voltages in high and low portions of the cycle produces the best performance.     

Ti接枝MCM-41催化剂的结构设计及化学亲和选择性研究

 用二氯化钛茂作为活性物种的来源，利用Si－MCM－41催化剂表面羟基的反应性，得到了Ti接枝MCM－41催化剂的两种结构模型．结构表征结果表明，Ti接枝MCM－41催化剂不仅长程结构好，孔径分布均一，而且催化剂表面活性中心含量高．两种结构模型催化剂上芳烃羟化反应性能表明，Ti接枝MCM－41催化剂表面的亲水／憎水性可以在较宽的范围内调变，从而可实现控制芳烃羟化的化学亲和选择性．另外，研究结果还表明，Ti接枝MCM－41催化剂具有很好的活性稳定性．     

Characterization and electrochemical investigation of boron-doped mesocarbon microbead anode materials for lithium ion batteries

The structure and anodic performance of boron-doped and undoped mesocarbon microbeads (MCMBs) have been comparatively studied and the results obtained by XPS, XRD, SEM, Raman spectroscopy and electrochemical measurements are discussed. It is found that boron doping introduces a depressed d ₀₀₂ spacing and the larger amount of "unorganized carbon", which induces vacancy formation in the graphite planes and leads to a quite different morphology from that of the undoped material. Electrochemical charge/discharge cycle tests indicated that after boron doping the lithium intercalation was carried through at a somewhat higher potential, being attended by greater irreversible capacity loss. Electronic Publication     

Interfacial micellar structures from novel amphiphilic star polymers

An amphiphilic heteroarm star polymer containing 12 alternating hydrophobic/hydrophilic arms of polystyrene (PS) and poly(acrylic acid) (PAA) connected to a well-defined rigid aromatic core was studied at the air-water and the air-solid interfaces. At the air-water interface, the molecules spontaneously form pancakelike micellar aggregates which measure up to several microns in diameter and 5 nm in thickness. Upon reduction of the surface area per molecule to 7 nm2, the two-dimensional micelles merged into a dense monolayer. We suggest that confined phase separation of dissimilar polymer arms occurred upon their segregation on the opposite sides of the rigid disklike aromatic core, forcing the rigid cores to adopt a face-on orientation with respect to the interface. Upon transfer onto solid supports the PS chains face the air-film interface making it completely hydrophobic, and the PAA chains were found to collapse and form a thin flattened underlayer. This study points toward new strategies to create large 2D microstructures with facial amphiphilicity and suggests a profound influence of star molecular architecture on the self-assembly of amphiphiles at the air-water interface.     

Infrared-optical properties of vapour-deposited metal films

Spectroscopic infrared ellipsometry was applied to determine the optical constants of thin metal layers deposited on dielectric substrates such as glass or CaF(2). The layers were produced by evaporating gold or silver in a vacuum, and the coverage, that is the deposited mass per area, was chosen in the range 80-1200 mg m(-2) for gold, which refers to thicknesses in the lower nanometer range; in the case of the specifically lighter silver, about half the coverage was applied. At low coverage a metal island structure is obtained, which gives rise to surface-enhanced infrared absorption (SEIRA). Depending on the coverage, the deposited films exhibit either dielectric or metallic optical properties. Atomic force microscopy and conductivity measurements complement the spectroscopic observation.     

α-乙酰基二硫缩烯酮α碳原子的酰化反应

进行了α-乙酰基二硫缩烯酮与酰氯的酰化反应. 以干燥的二氯甲烷为溶剂, 在四氯化钛催化下, α-乙酰基环二硫缩烯酮(1)可与脂肪及芳酰氯(2)反应, 在化合物1的α-碳原子上发生酰化反应, 以较高的产率生成各种α-乙酰基-α-酰基二硫缩烯酮(3).     

反相高效液相色谱法测定3种中成药中的葛根素

 建立了测定小儿清感灵片、步长新脑心通胶囊和感冒清热颗粒 3种中成药中葛根素含量的反相高效液相色谱方法。采用APEXODS色谱柱 ,以醋酸铵缓冲液 (10 0mmol/L ,pH 5 0 ) 甲醇 (体积比为 75∶2 5 )的混合溶液为流动相 ,检测波长为 2 5 0nm ,流速为 0 8mL/min。葛根素在 2mg/L～ 2 0mg/L时其色谱峰面积与质量浓度的线性关系良好 (r =0 9999) ;上述 3种中成药中的葛根素含量分别为 3 48mg/g ,1 0 8mg/ g及 1 5 2mg/ g(蔗糖型 ) ;其加样回收率分别为 99 0 % ,93 4%和 97 5 %。该法简便、快速、专属性强 ,可以作为多种中药制剂中葛根素含量的测定方法。     

新显色剂二溴对甲基偶氮甲磺光度测定稀土的研究和应用

研究了新显色剂二溴对甲基偶氮甲磺光度测定铈组稀土总量的方法，在酸性介质中，试剂与以铈组稀土为代表稀土形成蓝色配合物，在６４４ｎｍ有最大吸收，铈含量在０～１５μｇ／２５ｍｌ范围内符合比耳定律，方法应用于钢铁中铈组稀土总量的直接测定，发现其准确性和重视性良好。     

Elucidating dominant factors of PO43-, Cd2+ and nitrobenzene removal by biochar: A comparative investigation based on distinguishable biochars

Four distinct biochars were employed to remove three typical pollutants, meanwhile, path analysis, a multi-statistical regression method, was performed to elucidate the dominant factors of biochar adsorption. This work can provide a new insight to prepare a targeted biochar as adsorbents.