Time-resolved chemiluminescence technique for the microdetermination of proteins based on their complexation with copper(II).

Based on the complexation between proteins and Cu(II) coupled with the time-resolved chemiluminescence (CL) technique, a highly sensitive and quantitative assay for measuring proteins in solution is described. The complexes of proteins with Cu(II) have a strongly catalytic effect on the luminol-H2O2 CL reaction. Because the CL emission produced by the complexes is much more long-lived than that by Cu(II), the CL signals originating from proteins can be easily identified and measured with a time-resolved technique. On this basis, bovine albumin fraction V (BAF V) can be quantitatively determined in the range of 0.01 - 5.0 microg/ml with a detection limit of 5.8 ng/ml. The results show that the proposed assay exhibits a small variation in the response values for the same amount of different proteins, as compared to the Lowry as well as Bradford assays. The CL assay has also been studied for the detection of immobilized proteins.     

Sol–Gel-Derived Corrosion-Protection Coatings

There is a current need for alternative coatings that can provide corrosion resistance to metals or alloy surfaces due to the environmental hazards posed by conventional coatings. Herein, we report on novel organically-modified sol–gel coatings for the protection of metal and alloy surfaces. The basic concept of chemical conversion of metal surfaces is based on deposition of a hydrophobic, nonporous sol–gel barrier layer for surface protection and corrosion prevention. The properties of these organosilica coatings can be tuned by varying the composition of precursors. The evaluation of hydrophobicity, adhesive strength, and anticorrosion properties of organically-modified sol–gel derived coatings suggests their potential utility as technologically-compatible alternatives to conventional coatings.     

密封容器中后处理制备Tl2Ba2CaCu2Oy高温超导薄膜及其性能研究

以铝酸镧（001）单晶为基片，采用两步法制备Tl2Ba2CaCu2Oy（Tl 2212）高 温超导薄膜.首先，利用脉冲激光沉积（PLD）工艺沉积Ba2CaCu2Ox非晶前驱体薄膜；然后，前驱体薄膜在高温（720—850℃）下密封钢容器里铊化结晶形成Tl 2212薄膜.XRD结果表明Tl2212 薄膜是沿c轴方向生长的，其相组成为Tl 2212，摇摆曲线（0012）的半高宽为0.72° ，SEM图像显示其表面光滑平整，其零电阻温度为106.2K. 关键词： Tl 2212超导薄膜 脉冲激光沉积     

修饰态布居的选择性激发对无反转激光的作用

以三能级V型系统为例研究修饰态布居的选择性激发对无反转激光增益的作用. 当非 相干驱动场的频谱宽度远小于驱动场产生的修饰态能级的间距时，非相干驱动场只将一个修 饰态的布居抽运至激发态. 借助原子的衰减通道，系统中形成单向布居转移通道，从而建立 修饰态布居的选择性激发. 利用修饰态布居的选择性激发，可以摆脱裸态共振无反转激光的 三个限制: (1) 不再要求辅助的低频驱动跃迁比高频激光跃迁具有更高的衰减速率；(2) 显 著降低非相干激发速率的阈值；(3) 无反转激光的线性增益不再反比于相干驱动场的强 关键词： 修饰态布居的选择性激发 无反转激光增益 原子衰减速率 非相干激发阈值速率     

一种新颖的用于光腔模式及光束传输模拟的特征向量法

根据有限元法单元划分的思想，提出了一种新颖的模拟光腔模式及光束传输的特征向量法. 该方法的关键之处在于基于衍射积分理论构造了一种新的光束传输矩阵，通过求解特征矩阵方程可一次性得到谐振腔的一系列特征向量，每一列特征向量即代表了腔镜上光场的一个确定模式的振幅及相位分布. 并可采用该方法模拟光场传输到腔内或腔外任意地方的场分布. 该方法将传统方法中大量的迭代过程转化成为本征积分方程特征向量的求解过程，并与初值取值无关，且可一次性求得多个模式分布，从而可方便地分析谐振腔的模式鉴别能力. 特征向量法对圆形镜共焦 关键词： 谐振腔 特征向量法 模式分布     

多壁碳纳米管膜湿敏特性的研究

研究了多壁碳纳米管(MWNTs)薄膜的湿敏特性，实验所用的多壁碳纳米管是用热灯丝化学气相沉积法(CVD)合成的.分别对未修饰和修饰的多壁碳纳米管膜温度和湿度特性进行研究后发现，修饰的多壁碳纳米管对温度和湿度非常敏感，且对湿度的响应时间和恢复时间短，重复性好.而未修饰的多壁碳纳米管对温度和湿度不太敏感.对修饰多壁碳纳米管的湿敏特性进行了理论分析，给出了其理论表示式. 关键词： 多壁碳纳米管 化学修饰 湿敏特性 物理吸附     

Yb3+掺杂铝氟磷酸盐玻璃的光谱和激光性能

研究了Yb3 掺杂铝氟磷酸盐 (AFP)玻璃的吸收光谱、荧光光谱 ,测量了Yb3 离子的荧光有效线宽 (Δλeff>5 5nm)以及2 F5 2 能级的荧光寿命 (τmax=2ms)及随掺杂浓度的变化 .应用倒易法计算了Yb3 的发射截面 ,其发射截面可达 0 6 6 82 3pm2 ,且激光增益系数τfσemi达 1 2 89ms.pm2 .评估了Yb3 在AFP玻璃中的激光性能 ,发现其具有较理想的激发态最小粒子数 (0 15 )、饱和抽运强度 (8 3kW cm2 )和最小抽运强度 (1 2 4 5kW cm2 )值及良好的热稳定性 .研究结果表明掺Yb3 氟磷酸盐玻璃是实现高功率超短可调谐激光器的理想增益介质 .     

X波段六腔渡越管振荡器的高频特性研究

 从麦克斯韦方程出发，采用时域有限差分法（FDTD）和离散傅里叶变换（DFFT）相结合的方法，通过数值计算得出了六腔开放式谐振腔中前四个谐振频率和场分布，计算出的谐振频率与实验测量结果基本相同。比较了开放腔和封闭腔谐振频率，验证了TEM波吸收边界条件，并在实际编程计算中得以应用。计算结果为六腔渡越管振荡器的机理研究提供了依据。     

A mild and simple synthesis of N-aryl substituted toluenesulfamides under solvent-free conditions

N- aryl substituted benzenesulfamides are often used as heating-sensitive recording material1, thermal printing material2, sensitizer3 and developer4. Moreover, some of the benzenesulfamides have antifungal activities5. Many methods have been described for preparation of sulfamides. They are used to carry out in solvent8 or in solid phase condition9. These methods required solvent or solid support and even required heating or cooling. At the same time, the process of these methods is complex. Now we have developed a new method to prepare N-aryl substituted toluenesulfamides under solvent-free conditions.In recent years, solvent-free technology has gained popularity in organic synthesis. For instance,solidstate reaction and microwave reaction have received considerable attention. Solvent-free synthesis of amides has been reported10-11. This technology has many advantages such as high efficiency and selectivity, easy separation and environmental acceptability. All these merits are in accord with green chemistry's requirements of energy-saving, high efficiency and environmental benefits.In our paper, we used a simple and efficient method for preparing N-aryl substituted toluenesulfamides under solvent-free conditions, as a replacement for classic solvent, which gives many environmental benefits.All reactions were completed at room temperature by co-grinding in an agate mortar for 3-20min and the results are shown in Table 1.In conclusion, we have developed an efficient and convenient method of preparation N-aryl substituted toluenesulfamides in high yields. It symbols an improvement for synthesis of benzenesulfamides.     

Monoesterification of styrene–maleic anhydride copolymers with alcohols in ethyl benzene: Catalysis and kinetics

A kinetic investigation on the monoesterification reaction of the maleic anhydride residue (MA) in styrene-maleic anhydride copolymers with aliphatic alcohols was carried out in ethyl benzene solution. By comparison to classic catalysts such as tributylamine (TBA) and pyridine, 4-dimethylaminopyridine (4DMAP) is by far the most effective catalyst for this reaction. While both general base and nucleophilic mechanisms contribute to the reaction catalyzed by TBA or pyridine, a nucleophilic mechanism prevails with 4DMAP. This reaction is reversible, and its chemical equilibrium constant decreases significantly with increasing temperature. Both kinetic and thermodynamic results showed that in the presence of 4DMAP, the forward and reverse reactions are second and first order, respectively. The existence of side reactions, reactivity of two styrene-maleic anhydride copolymers of different MA contents as well as two aliphatic alcohols of different lengths are also addressed. © 1993 John Wiley & Sons, Inc.