Effective thermal conductivity of water-saturated sintered powder-metal plates

An experimental apparatus and related procedures for the determination of the effective thermal conductivity of sintered powder-metal plates saturated with distilled water at temperatures in the range 20–150°C are discussed. The apparatus and procedures are applied to two samples of sintered powder-metal plates, one made of nickel 200 and the other of stainless steel 316, with porosities of 28.10 and 46.45%, respectively, and each of nominal dimensions 127 mm × 127 mm × 6.35 mm. The experimental results are compared with corresponding predictions yielded by several correlations available in the literature. The correlations based on experimental data for packed beds of spherical particles and also porous plates made of cold-pressed (but not sintered) particles of angular shapes do not apply well to sintered powder-metal plates. A new correlation, which is based on extensions of ideas contained in earlier works and provides improved predictions, is proposed.     

Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

Growth and study of single crystals of (Na,K)NbO<Subscript>3</Subscript> solid solutions

(Na, K)NbO₃ crystals with a perovskite structure and a KNbO₃ content up to 40 mol % were grown from flux with the use of the solvent NaBO₂. The dielectric measurements of the crystals grown revealed phase transitions that had never been observed before in ceramic samples.     

On the dispersion of a solute in oscillating flow of a non-Newtonian fluid in a channel

The paper presents an exact analysis of the dispersion of an immiscible solute in a non-Newtonian fluid (known as an incompressible second-order fluid which shows viscoelastic behaviour) flowing slowly in a parallel plate channel in the presence of a periodic pressure gradient. Using a generalized dispersion model which is valid for all times after the solute injection, the diffusion coefficients K _i (τ)(i=1,2,3,…) are obtained as functions of time τ in the case when the initial solute distribution is in the form of a slug of finite extent. The analysis leads to the novel result that K ₂(τ) (which is a measure of the longitudinal dispersion coefficient of the solute) has a steady part S in addition to a fluctuating part D ₂(τ) due to the pulsatility of the flow. It is found that S decreases with increase in the viscoelastic parameter M for given values of the amplitude λ and frequency ω of the pressure pulsation. On the other hand, it is found that at a fixed instant τ, the amplitude of D ₂(τ) increases with increase in M for given values of λ and ω. Further it is shown that at a given instant τ, the amplitude of D ₂(τ) decreases with increase in ω for given λ and M and the profile for D ₂(τ) becomes progressively flatter with increase in ω. Finally the axial distribution of the average concentration θ _m of the solute over the channel cross-section is determined at different instants after the solute injection for several values of M, λ and ω. The present study is likely to have important bearing on the problem of dispersion of tracers in blood flow through arteries.     

Carleman problem for two pairs of functions in a ring

We consider a particular case of the matrix Carleman problem for two pairs of functions in a ring and find a constructive solution of this problem. In addition, we propose an algorithm for the construction of solutions for two infinite systems of smooth transition and for a system of two singular equations of special type. Translated from Ukrainskii Matematicheskii Zhurnal, Vol. 49, No. 5, pp. 662–671, May, 1997     

Thermoplastic polymers quality control

A technique is proposed for improving the accuracy of the heat of fusion of semicrystalline polymers by DSC. The results of three commercially available instruments are compared.     

NATA: 50 years experience with accreditation

 Laboratory accreditation is becoming increasingly accepted around the world as a means of identifying technically competent laboratories. It is also being used as a mechanism for the acceptance of test data both nationally and internationally. The concept and mechanisms of accreditation have been developed over the past 50 years. The first national laboratory accreditation system appeared in Australia in 1947. This organisation, known as the National Association of Testing Authorities (NATA), has since taken a leading role in developing accreditation practices that are now used world-wide in evaluating testing, measurement and calibration laboratories. This paper examines the development of the world's first and largest laboratory accreditation system, and looks at the difficulties and triumphs in gaining acceptance and recognition by government and industry of the benefits of laboratory accreditation. Received: 24 June 1996 Accepted: 25 June 1996