Analysis of phosphate and phosphate containing headgroups enzymatically cleaved from phospholipids of <Emphasis Type="Italic">Bacillus subtilis</Emphasis> by capillary electrophoresis

A new, fast, selective, and reliable capillary electrophoresis method has been developed for analysis of selected phosphoesters (phosphoserine, phosphoethanolamine, phosphoglycerol) and phosphate. The method is based on separation of specific phosphate containing headgroups (phosphoesters) which are cleaved from the glycerol skeleton of a phospholipid by a regioselective enzyme (phospholipase C). Analysis of intact phospholipids with the same polar headgroup but different fatty acids shows that fatty acid composition has a high impact on separation of phospholipids, so analysis of separated polar headgroups, which avoids this influence, represents a much more suitable approach for phospholipid class research. Optimization of method parameters results in running buffers of relatively narrow pH interval (pH about 10) where all phosphoesters are separated. Further method validation has shown that direct UV detection has a sufficient detection limit for all analytes to perform suitable analyses of cell membrane lipids. The optimized method was tested on the lysate of cell membrane of Bacillus subtilis, where all analytes were determined.     

A reversed phase high performance liquid chromatography method for the determination of fumonisins B1 and B2 in food and feed using monolithic column and positive confirmation by liquid chromatography/tandem mass spectrometry

The development of a reversed phase high performance liquid chromatography fluorescence method for the determination of the mycotoxins fumonisin B(1) and fumonisin B(2) by using silica-based monolithic column is described. The samples were first extracted using acetonitrile:water (50:50, v/v) and purified by using a C(18) solid phase extraction-based clean-up column. Then, pre-column derivatization for the analyte using ortho-phthaldialdehyde in the presence of 2-mercaptoethanol was carried out. The developed method involved optimization of mobile phase composition using methanol and phosphate buffer, injection volume, temperature and flow rate. The liquid chromatographic separation was performed using a reversed phase Chromolith(?) RP-18e column (100 mm × 4.6 mm) at 30 °C and eluted with a mobile phase of a mixture of methanol and phosphate buffer pH 3.35 (78:22, v/v) at a flow rate of 1.0 mL min(-1). The fumonisins separation was achieved in about 4 min, compared to approximately 20 min by using a C(18) particle-packed column. The fluorescence excitation and emission were at 335 nm and 440 nm, respectively. The limits of detections were 0.01-0.04 μg g(-1) fumonisin B(1) and fumonisin B(2), respectively. Good recoveries were found for spiked samples (0.1, 0.5, 1.5 μg g(-1) fumonisins B(1) and B(2)), ranging from 84.0 to 106.0% for fumonisin B(1) and from 81.0 to 103.0% for fumonisin B(2). Fifty-three samples were analyzed including 39 food and feeds and 14 inoculated corn and rice. Results show that 12.8% of the food and feed samples were contaminated with fumonisin B(1) (range, 0.01-0.51 μg g(-1)) and fumonisin B(2) (0.05 μg g(-1)). The total fumonisins in these samples however, do not exceed the legal limits established by the European Union of 0.8 μg g(-1). Of the 14 inoculated samples, 57.1% contained fumonisin B(1) (0.16-41.0 μg g(-1)) and fumonisin B(2) (range, 0.22-50.0 μg g(-1)). Positive confirmation of selected samples was carried out using liquid chromatography-tandem mass spectrometry, using triple quadrupole analyzer and operated in the multiple reaction monitoring mode.     

Evaluation of the bioactivity of novel spiroisoxazoline typecompounds against normal and cancer cell lines

The aim of this study was to investigate the in vitro cellular activity of novel spiroisoxazoline type compounds against normal and cancer cell lines from lung tissue (Hs888Lu), neuron-phenotypic cells (SH-SY5Y), neuroblastoma (SH-SY5Y), human histiocytic lymphoma (U937), lung cancer (A549), and leukaemia (HL-60). Our bioassay program revealed that the spiroisoxazoline type compounds show cytotoxicity only in lymphoma cell lines, which is in contrast with the pyrrolidine precursor of these spiroisoxazoline compounds, where significant cytotoxicity is seen in all normal and cancer cell lines. These data suggest a tumour-specific mechanism of action. In addition these data also show that spiroisoxazoline compounds are non-toxic in the human neuronphenotypic neuroblastoma SH-SY5Y cell line, and furthermore that they might protect cells from neurodegenerative disease.     

Effect of ionic conductivity of a PAN–PC–LiClO<Subscript>4</Subscript> solid polymeric electrolyte on the performance of a TiO<Subscript>2</Subscript> photoelectrochemical cell

A nanoparticle TiO₂ solid-state photoelectrochemical cell has been fabricated. The effect of ionic conductivity of a solid electrolyte of polyacrylonitrile (PAN)–propylene carbonate (PC)–lithium perchlorate (LiClO₄) on the performance of a photoelectrochemical cell of indium tin oxide (ITO)/TiO₂/PAN–PC–LiClO₄/graphite has been investigated. A nanoparticle TiO₂ film was deposited onto ITO-covered glass substrate by controlled hydrolysis technique. A solid electrolyte of PAN–LiClO₄ with PC plasticizer prepared by solution casting technique was used as a redox couple medium. The room temperature conductivity of the electrolyte was determined by AC impedance spectroscopy technique. A graphite electrode was prepared onto a glass slide by electron beam evaporation technique. The device shows a photovoltaic effect under illumination. The short-circuit current density, J _sc, and open-circuit voltage, V _oc, vary with the conductivity of the electrolyte. The highest J _sc of 2.82 μA cm⁻² and V _oc of 0.56 V were obtained at the conductivity of 4.2 × 10⁻⁴ Scm⁻¹ and at the intensity of 100 mW cm⁻².     

Electrochemical and spectroscopic properties of poly-4,4′-dialkoxy-2,2′-bipyrroles

The structure and the electrochemical and spectral properties of two conductive electrochemically polymerized substituted bipyrroles 4,4′-methoxy-2,2′-bipyrrole and 4,4′-buthoxy-2,2′-bipyrrole were studied and compared. The polymers were characterized by cyclic voltammetry, FT-Raman spectroscopy, scanning electron microscopy, and in situ conductivity measurements at different pH and redox state.     

Fabrication of a nanoparticle TiO<Subscript>2</Subscript> photoelectrochemical cell utilizing a solid polymeric electrolyte of PAN–PC–LiClO<Subscript>4</Subscript>

A nanoparticle TiO₂ solid-state photoelectrochemical cell utilizing as a solid electrolyte of poly(acrylonitrile)–propylene–carbonate–lithium perchlorate (PAN–PC–LiClO₄) has been fabricated. The performance of the device has been tested in the dark and under illumination of 100-mW cm⁻² light. A nanoparticle TiO₂ film was deposited onto indium tin oxide-covered glass substrate by controlled hydrolysis technique assisted with spin-coating technique. The average grain size for the TiO₂ film is 76 nm. LiClO₄ salt was used as a redox couple. The room temperature conductivity of the electrolyte is 4.2 × 10⁻⁴ S cm⁻¹. A graphite electrode was prepared onto a glass slide by electron beam evaporation technique. The device shows the rectification property in the dark and shows the photovoltaic effect under illumination. The best J _sc and V _oc of the device were 2.82 μA cm⁻² and V _oc of 0.58 V, respectively, obtained at the conductivity of 4.2 × 10⁻⁴ S cm⁻¹ and intensity of 100 mW cm⁻². The J _sc was improved by about three times by introducing nanoparticle TiO₂ and by using a solid electrolyte of PAN–PC–LiClO₄ replacing PVC–PC–LiClO₄ in the device. The current transport mechanism of the cell is also presented in this paper.     

Structural and conductivity changes during the pyrolysis of polyaniline base

Polyaniline base has been exposed to various temperatures between 100 °C and 1000 °C for 2 h in air. The mass loss has increased with increasing temperature. FTIR and Raman spectroscopies show the gradual destruction of the PANI structure, the possible formation of intermediate oxime and nitrile groups, and the final conversion to graphitic material. The elemental analysis confirmed the dehydrogenation while the content of nitrogen was nearly constant even after treatment at 800 °C. The conductivity of PANI base, 10⁻⁸ S cm⁻¹, increased to ∼10⁻⁴ S cm⁻¹ after treatment at 1000 °C; most of the products, however, were non-conducting. Another series of experiments involved the polyaniline base heated at 500 °C for 1-8 h. The studies were performed in connection with the potential flame-retardant application of polyaniline.     

Iron(III)-promoted aza-Prins-cyclization: direct synthesis of six-membered azacycles

[reaction: see text] A new iron(III) halide-promoted aza-Prins cyclization between gamma,delta-unsaturated tosylamines and aldehydes provides six-membered azacycles in good to excellent yields. The process is based on the consecutive generation of gamma-unsaturated-iminium ion and further nucleophilic attack by the unsaturated carbon-carbon bond. Homoallyl tosylamine leads to trans-2-alkyl-4-halo-1-tosylpiperidine as the major isomer. In addition, the alkyne aza-Prins cyclization between homopropargyl tosylamine and aldehydes gives 2-alkyl-4-halo-1-tosyl-1,2,5,6-tetrahydropyridines as the only cyclic products.     

Minimal Connected τ-Critical Hypergraphs

A hypergraph is τ-critical if τ(−{E})<τ() for every edge E ∈ , where τ() denotes the transversal number of . We show that if is a connected τ-critical hypergraph, then −{E} can be partitioned into τ()−1 stars of size at least two, for every edge E ∈ . An immediate corollary is that a connected τ-critical hypergraph has at least 2τ()−1 edges. This extends, in a very natural way, a classical theorem of Gallai on colour-critical graphs, and is equivalent to a theorem of Füredi on t-stable hypergraphs. We deduce a lower bound on the size of τ-critical hypergraphs of minimum degree at least two.     

Uniform asymptotics for S- and MM-regression estimators

In this paper we find verifiable regularity conditions to ensure that S-estimators of scale and regression and MM-estimators of regression are uniformly consistent and uniformly asymptotically normally distributed over contamination neighbourhoods. Moreover, we show how to calculate the size of these neighbourhoods. In particular, we find that, for MM-estimators computed with Tukey’s family of bisquare score functions, there is a trade-off between the size of these neighbourhoods and both the breakdown point of the S-estimators and the leverage of the contamination that is allowed in the neighbourhood. These results extend previous work of Salibian-Barrera and Zamar for location-scale to the linear regression model.